Jumbo commit for 4.7 installation instructions:

- do not mention tape as an installation media on systems where it is very
  unlikely that a tape drive can be connected to (i.e. anything with only
  USB as expansion capabilities)
- do not mention that fetching the installation sets from a partition is
  ``for upgrades only''. You may do this for installation, but of course
  you can not use a partition which will be newfs'ed for that purpose.
- mention ext2fs partitions as possible installation sets source only on
  platforms where the installation media actually can mount an ext2fs
  filesystem.
- stress the fact that the sparc miniroot image is a GENERIC kernel with
  a little on-disk filesystem, and not a RAMDISK kernel with a little
  in-memory filesystem, and thus must not be overwritten during installation
  (i.e. be careful if you repartition the disk the miniroot has been put on).
- more conv=sync -> conv=osync for tape setup instructions.
- model-specific layout changes on armish, loongson and socppc instructions.
- fix various typos and grammar mistaeks.

"sure" deraadt@ (without eyeballing)

1 files changed, 2 insertions, 2 deletions

diff --git a/distrib/notes/amd64/install b/distrib/notes/amd64/install
index 5ef3922e2b5..f797f560c58 100644
--- a/distrib/notes/amd64/install
+++ b/distrib/notes/amd64/install
@@ -1,4 +1,4 @@
-dnl	$OpenBSD: install,v 1.13 2009/05/13 18:38:29 miod Exp $
+dnl	$OpenBSD: install,v 1.14 2010/03/16 17:23:09 miod Exp $
 OpenBSDInstallPrelude
 
 If OpenBSD will be sharing the disk with another operating system,
@@ -54,7 +54,7 @@ OpenBSDInstallPart5({:-
 	If you have DOS or Linux partitions defined on the disk, these
 	will usually show up as partition 'i', 'j' and so on.-:})
 
-OpenBSDInstallPart6({:-CD-ROM, -:})
+OpenBSDInstallPart6({:-CD-ROM, tape, -:})
 
 OpenBSDURLInstall