Your spring jumbo m4-fu. This time:

- mention comp contains an objective-C compiler too.
- rewrite InstallPrelude so that it will only output the ``know your drive
  geometry'' blurb if asked to, and for a specified disk type. Use it for
  non-IDE and non-SCSI disks only, otherwise the kernel is good enough to
  do the job without the users' help.
- similarily, adapt BootMsgs to make the second part of the geometry blurb
  optional, and to accept up to three disk types. Use this to report better
  disk names (i.e. no point saying an scsi disk would show up as sd0 on
  platforms which can't have scsi disks, or won't be able to boot from them).
- in InstallPart4, drop the part about block and fragment sizes in
  disklabel. The defaults are good, and you won't get to change them unless
  you switched to expert mode.
- the default answer to ``wanna get the ftp mirror list, unzel?'' is ``no'',
  so pressing enter to get it is not enough anymore (-:

1 files changed, 2 insertions, 2 deletions

diff --git a/distrib/notes/sgi/install b/distrib/notes/sgi/install
index cee0906d64f..c855d946582 100644
--- a/distrib/notes/sgi/install
+++ b/distrib/notes/sgi/install
@@ -1,4 +1,4 @@
-dnl	$OpenBSD: install,v 1.8 2005/08/30 17:05:32 miod Exp $
+dnl	$OpenBSD: install,v 1.9 2007/03/01 19:24:45 miod Exp $
 OpenBSDInstallPrelude
 
 There are several ways to install OpenBSD onto a disk. The easiest way
@@ -53,7 +53,7 @@ OpenBSDInstallPart2
 	diskless setup isn't correct, or you may have a hardware or
 	configuration problem.
 
-OpenBSDBootMsgs
+OpenBSDBootMsgs(,"sd0")
 
 	You will next be asked for your terminal type.
 dnl XXX needs extra text here once graphics console is available