Your spring jumbo m4-fu. This time:

- mention comp contains an objective-C compiler too.
- rewrite InstallPrelude so that it will only output the ``know your drive
  geometry'' blurb if asked to, and for a specified disk type. Use it for
  non-IDE and non-SCSI disks only, otherwise the kernel is good enough to
  do the job without the users' help.
- similarily, adapt BootMsgs to make the second part of the geometry blurb
  optional, and to accept up to three disk types. Use this to report better
  disk names (i.e. no point saying an scsi disk would show up as sd0 on
  platforms which can't have scsi disks, or won't be able to boot from them).
- in InstallPart4, drop the part about block and fragment sizes in
  disklabel. The defaults are good, and you won't get to change them unless
  you switched to expert mode.
- the default answer to ``wanna get the ftp mirror list, unzel?'' is ``no'',
  so pressing enter to get it is not enough anymore (-:

1 files changed, 5 insertions, 10 deletions

diff --git a/distrib/notes/sparc/install b/distrib/notes/sparc/install
index 915a9acfb95..7687598522a 100644
--- a/distrib/notes/sparc/install
+++ b/distrib/notes/sparc/install
@@ -1,5 +1,5 @@
-dnl	$OpenBSD: install,v 1.64 2005/04/27 03:07:16 jsg Exp $
-OpenBSDInstallPrelude
+dnl	$OpenBSD: install,v 1.65 2007/03/01 19:24:45 miod Exp $
+OpenBSDInstallPrelude({:-SMD disks-:})
 
 There are several ways to install OpenBSD onto a disk. The easiest way
 in terms of preliminary setup is to use the OpenBSD miniroot that can
@@ -172,14 +172,9 @@ OpenBSDInstallPart2
 	is bad, your diskless setup isn't correct, or you may have
 	a hardware or configuration problem.
 
-OpenBSDBootMsgs
-
-	While booting, you will probably see several warnings.  You
-	may be warned that the kernel can't figure out what device
-	it booted from.  Do not be alarmed, this is completely normal.
-	This warning occurs because while OpenBSD/MACHINE can boot from
-	the floppy drive, the kernel itself lacks a floppy driver for some
-	MACHINE models.
+OpenBSDBootMsgs(SMD drives are noisy and weight a ton per kilobyte and scare
+		cats,"sd0" for SCSI drives,{:-and "xd0" or "xy0"
+	for SMD drives-:})
 
 	You will next be asked for your terminal type.  If you are
 	installing from a keyboard/monitor console, the default of