diff options
| -rw-r--r-- | sys/netinet6/nd6.c | 22 | ||||
| -rw-r--r-- | sys/netinet6/nd6_nbr.c | 4 | ||||
| -rw-r--r-- | sys/netinet6/nd6_rtr.c | 6 |
3 files changed, 16 insertions, 16 deletions
diff --git a/sys/netinet6/nd6.c b/sys/netinet6/nd6.c index 59e3af798b9..ddc5fc1ea7f 100644 --- a/sys/netinet6/nd6.c +++ b/sys/netinet6/nd6.c @@ -1,4 +1,4 @@ -/* $OpenBSD: nd6.c,v 1.70 2006/02/21 10:23:25 markus Exp $ */ +/* $OpenBSD: nd6.c,v 1.71 2006/06/16 15:41:19 pascoe Exp $ */ /* $KAME: nd6.c,v 1.280 2002/06/08 19:52:07 itojun Exp $ */ /* @@ -536,7 +536,7 @@ nd6_timer(ignored_arg) /* * expire interface addresses. * in the past the loop was inside prefix expiry processing. - * However, from a stricter speci-confrmance standpoint, we should + * However, from a stricter spec-conformance standpoint, we should * rather separate address lifetimes and prefix lifetimes. */ for (ia6 = in6_ifaddr; ia6; ia6 = nia6) { @@ -889,7 +889,7 @@ nd6_free(rt, gc) if (dr) { /* - * Unreachablity of a router might affect the default + * Unreachability of a router might affect the default * router selection and on-link detection of advertised * prefixes. */ @@ -941,7 +941,7 @@ nd6_free(rt, gc) /* * Upper-layer reachability hint for Neighbor Unreachability Detection. * - * XXX cost-effective metods? + * XXX cost-effective methods? */ void nd6_nud_hint(rt, dst6, force) @@ -1067,7 +1067,7 @@ nd6_rtrequest(req, rt, info) break; } /* - * In IPv4 code, we try to annonuce new RTF_ANNOUNCE entry here. + * In IPv4 code, we try to announce new RTF_ANNOUNCE entry here. * We don't do that here since llinfo is not ready yet. * * There are also couple of other things to be discussed: @@ -1295,8 +1295,8 @@ nd6_ioctl(cmd, data, ifp) * in6_prlist is used for nd6_sysctl() - fill_prlist(). */ /* - * XXX meaning of fields, especialy "raflags", is very - * differnet between RA prefix list and RR/static prefix list. + * XXX meaning of fields, especially "raflags", is very + * different between RA prefix list and RR/static prefix list. * how about separating ioctls into two? */ bzero(oprl, sizeof(*oprl)); @@ -1488,7 +1488,7 @@ nd6_cache_lladdr(ifp, from, lladdr, lladdrlen, type, code) * Validation about ifp->if_addrlen and lladdrlen must be done in * the caller. * - * XXX If the link does not have link-layer adderss, what should + * XXX If the link does not have link-layer address, what should * we do? (ifp->if_addrlen == 0) * Spec says nothing in sections for RA, RS and NA. There's small * description on it in NS section (RFC 2461 7.2.3). @@ -1580,7 +1580,7 @@ fail: if (ln->ln_state == ND6_LLINFO_STALE) { /* * XXX: since nd6_output() below will cause - * state tansition to DELAY and reset the timer, + * state transition to DELAY and reset the timer, * we must set the timer now, although it is actually * meaningless. */ @@ -1614,7 +1614,7 @@ fail: * - If lladdr exist, set IsRouter. This means (1-5). * - If it is old entry (!newentry), set IsRouter. This means (7). * So, based on the spec, in (1-5) and (7) cases we must set IsRouter. - * A quetion arises for (1) case. (1) case has no lladdr in the + * A question arises for (1) case. (1) case has no lladdr in the * neighbor cache, this is similar to (6). * This case is rare but we figured that we MUST NOT set IsRouter. * @@ -1740,7 +1740,7 @@ nd6_output(ifp, origifp, m0, dst, rt0) goto sendpkt; /* - * next hop determination. This routine is derived from ether_outpout. + * next hop determination. This routine is derived from ether_output. */ if (rt) { if ((rt->rt_flags & RTF_UP) == 0) { diff --git a/sys/netinet6/nd6_nbr.c b/sys/netinet6/nd6_nbr.c index 51d7d509907..9cfc5c9290d 100644 --- a/sys/netinet6/nd6_nbr.c +++ b/sys/netinet6/nd6_nbr.c @@ -1,4 +1,4 @@ -/* $OpenBSD: nd6_nbr.c,v 1.39 2006/03/05 21:48:57 miod Exp $ */ +/* $OpenBSD: nd6_nbr.c,v 1.40 2006/06/16 15:41:19 pascoe Exp $ */ /* $KAME: nd6_nbr.c,v 1.61 2001/02/10 16:06:14 jinmei Exp $ */ /* @@ -272,7 +272,7 @@ nd6_ns_input(m, off, icmp6len) * If source address is unspecified address, it is for * duplicated address detection. * - * If not, the packet is for addess resolution; + * If not, the packet is for address resolution; * silently ignore it. */ if (IN6_IS_ADDR_UNSPECIFIED(&saddr6)) diff --git a/sys/netinet6/nd6_rtr.c b/sys/netinet6/nd6_rtr.c index e0322c637c1..7c41977d47b 100644 --- a/sys/netinet6/nd6_rtr.c +++ b/sys/netinet6/nd6_rtr.c @@ -1,4 +1,4 @@ -/* $OpenBSD: nd6_rtr.c,v 1.38 2006/04/22 19:43:07 claudio Exp $ */ +/* $OpenBSD: nd6_rtr.c,v 1.39 2006/06/16 15:41:19 pascoe Exp $ */ /* $KAME: nd6_rtr.c,v 1.97 2001/02/07 11:09:13 itojun Exp $ */ /* @@ -797,7 +797,7 @@ insert: /* * Insert the new router in the Default Router List; * The Default Router List should be in the descending order - * of router-preferece. Routers with the same preference are + * of router-preference. Routers with the same preference are * sorted in the arriving time order. */ @@ -894,7 +894,7 @@ nd6_prelist_add(pr, dr, newp) if (newp != NULL) *newp = new; - /* initilization */ + /* initialization */ LIST_INIT(&new->ndpr_advrtrs); in6_prefixlen2mask(&new->ndpr_mask, new->ndpr_plen); /* make prefix in the canonical form */ |