diff options
Diffstat (limited to 'regress/sys')
| -rw-r--r-- | regress/sys/net/pf_fragment/Makefile | 16 |
1 files changed, 8 insertions, 8 deletions
diff --git a/regress/sys/net/pf_fragment/Makefile b/regress/sys/net/pf_fragment/Makefile index 532736c0530..3a10596cf02 100644 --- a/regress/sys/net/pf_fragment/Makefile +++ b/regress/sys/net/pf_fragment/Makefile @@ -1,4 +1,4 @@ -# $OpenBSD: Makefile,v 1.18 2015/11/01 21:30:00 bluhm Exp $ +# $OpenBSD: Makefile,v 1.19 2016/05/28 19:54:26 sthen Exp $ # The following ports must be installed: # @@ -6,7 +6,7 @@ # py-libdnet python interface to libdnet # scapy powerful interactive packet manipulation in python -# Check wether all required python packages are installed. If some +# Check whether all required python packages are installed. If some # are missing print a warning and skip the tests, but do not fail. PYTHON_IMPORT != python2.7 -c 'from scapy.all import *' 2>&1 || true .if ! empty(PYTHON_IMPORT) @@ -31,11 +31,11 @@ regress: # out in out in out in rtt in in # Configure Addresses on the machines, there must be routes for the -# networks. Adapt interface and addresse variables to your local +# networks. Adapt interface and address variables to your local # setup. To control the remote machine you need a hostname for # ssh to log in. # You must have an anchor "regress" for the divert rules in the pf.conf -# of the PF machine. The kernel of the PF machine gets testet. +# of the PF machine. The kernel of the PF machine gets tested. # # Run make check-setup to see if you got the setup correct. @@ -68,10 +68,10 @@ RTT_IN6 ?= fdd7:e83e:66bc:217:5054:ff:fe12:3452 .if empty (PF_SSH) || empty (RT_SSH) || empty (ECO_SSH) regress: - @echo this tests needs three remote machines to operate on + @echo this test needs three remote machines to operate on @echo PF_SSH RT_SSH ECO_SSH are empty @echo fill out these variables for additional tests, then - @echo check wether your test machines are set up properly + @echo check whether your test machines are set up properly .endif .MAIN: all @@ -186,7 +186,7 @@ run-regress-ping6-mtu: addr.py stamp-pfctl ${SUDO} ${PYTHON}ping6_mtu_1300.py ${${ip}6} .endfor -# Send packet to big to get to destination. +# Send packet too big to get to destination. # Check that checksum of the quoted original packet in ICMP is correct. # Currently these test fail as pf does not fix the checksum of @@ -317,7 +317,7 @@ CLEANFILES += addr.py *.pyc *.log stamp-* .PHONY: check-setup -# Check wether the address, route and remote setup is correct +# Check whether the address, route and remote setup are correct check-setup: @echo '\n======== $@ SRC ========' .for ip in SRC_OUT |