diff options
Diffstat (limited to 'share/man/man4')
| -rw-r--r-- | share/man/man4/tun.4 | 47 |
1 files changed, 27 insertions, 20 deletions
diff --git a/share/man/man4/tun.4 b/share/man/man4/tun.4 index e8452e3270d..6ed4d8da9a0 100644 --- a/share/man/man4/tun.4 +++ b/share/man/man4/tun.4 @@ -1,4 +1,4 @@ -.\" $OpenBSD: tun.4,v 1.32 2004/08/17 23:58:36 jaredy Exp $ +.\" $OpenBSD: tun.4,v 1.33 2004/09/02 12:55:22 jaredy Exp $ .\" .\" Copyright (c) 2003 Marcus D. Watts All rights reserved. .\" @@ -81,7 +81,9 @@ are removed. .Pp Writes never block. If the protocol queue is full, the packet is dropped, -a ``collision'' is counted, and +a +.Dq collision +is counted, and .Er ENOBUFS is returned. .Pp @@ -93,9 +95,9 @@ the following special commands defined in are supported: .Pp .Bl -tag -width indent -compact -.It Dv TUNGIFINFO (struct tuninfo) -.It Dv TUNSIFINFO (struct tuninfo) -Can be used to get or set the interface characteristics. +.It Dv TUNGIFINFO Fa "struct tuninfo *" +.It Dv TUNSIFINFO Fa "struct tuninfo *" +Get or set the interface characteristics. .Bd -literal /* iface info */ struct tuninfo { @@ -128,20 +130,25 @@ but can be set to This sets the interface media address header type. .Pp .It Dv TUNSIFMODE Fa int *flags -Can be used to just set the interface flags. +Set just the interface flags. +.Pp .It Dv FIONBIO Fa int *flag -Can be used to set non-blocking I/O. +Set non-blocking I/O. +.Pp .It Dv FIOASYNC Fa int *flag -Can be used to cause signal +Cause signal .Dv SIGIO to be sent when a packet can be read. +.Pp .It Dv TIOCSPGRP Fa int *pgrp .It Dv TIOCGPGRP Fa int *pgrp Get or set the process group to which signals might be sent via .Dv FIOASYNC . +.Pp .It Dv FIONREAD Fa int *count -Gets the byte count of the next packet available to be read. +Get the byte count of the next packet available to be read. +.Pp .It Dv SIOCGIFADDR Fa struct ether_addr *addr .It Dv SIOCSIFADDR Fa struct ether_addr *addr Get or set the Ethernet address of the device in layer 2 mode. @@ -155,11 +162,11 @@ If open fails, .Xr errno 2 may be set to one of: .Bl -tag -width Er -.It Bq Eq EPERM +.It Bq Er EPERM Only the superuser may open the device. -.It Bq Eq ENXIO +.It Bq Er ENXIO Not that many devices configured. -.It Bq Eq EBUSY +.It Bq Er EBUSY Device was already open. .El .Pp @@ -169,20 +176,20 @@ call fails, .Xr errno 2 is set to one of: .Bl -tag -width Er -.It Bq Eq EMSGSIZE +.It Bq Er EMSGSIZE The packet supplied was too small or too large. The maximum sized packet allowed is currently 16384 bytes. -.It Bq Eq ENOBUFS +.It Bq Er ENOBUFS There were no mbufs, or the queue for the outgoing protocol is full. -.It Bq Eq EAFNOSUPPORT +.It Bq Er EAFNOSUPPORT The address family specified in the tunnel header was not recognized. .El .Pp Ioctl commands may fail with: .Bl -tag -width Er -.It Bq EINVAL +.It Bq Er EINVAL Attempt to set both .Dv IFF_POINTOPOINT and @@ -194,7 +201,7 @@ or using or .Dv SIOCSIFADDR in layer 3 mode. -.It Bq ENOTTY +.It Bq Er ENOTTY Unrecognized ioctl command. .El .Pp @@ -202,19 +209,19 @@ A .Xr read 2 call may fail because of: .Bl -tag -width Er -.It Bq Eq EHOSTDOWN +.It Bq Er EHOSTDOWN The device is not ready. The device must have an .Xr inet 4 interface address assigned to it, such as via .Dv SIOCSIFADDR . -.It Bq Eq EWOULDBLOCK +.It Bq Er EWOULDBLOCK Non-blocking I/O was selected and no packets were available. .El .Pp An attempt to send a packet out via the interface may fail with: .Bl -tag -width Er -.It Bq Eq EHOSTDOWN +.It Bq Er EHOSTDOWN The device is not ready. The device must have an .Xr inet 4 |