diff options
Diffstat (limited to 'usr.sbin')
| -rw-r--r-- | usr.sbin/ldpd/ldpd.conf.5 | 12 |
1 files changed, 4 insertions, 8 deletions
diff --git a/usr.sbin/ldpd/ldpd.conf.5 b/usr.sbin/ldpd/ldpd.conf.5 index e96bc83cb33..c9dbb9de895 100644 --- a/usr.sbin/ldpd/ldpd.conf.5 +++ b/usr.sbin/ldpd/ldpd.conf.5 @@ -1,4 +1,4 @@ -.\" $OpenBSD: ldpd.conf.5,v 1.28 2016/05/23 19:14:03 renato Exp $ +.\" $OpenBSD: ldpd.conf.5,v 1.29 2016/05/23 21:05:07 jmc Exp $ .\" .\" Copyright (c) 2013, 2016 Renato Westphal <renato@openbsd.org> .\" Copyright (c) 2009 Michele Marchetto <michele@openbsd.org> @@ -116,7 +116,7 @@ If not specified, the numerically lowest IP address of the router will be used. .Ic transport-preference .Pq Ic ipv4 Ns | Ns Ic ipv6 .Xc -Specify the prefered address-family for TCP transport connections. +Specify the preferred address-family for TCP transport connections. If two dual-stack LSRs preferences does not match, no LDP session will be established. The default is @@ -265,19 +265,16 @@ l2vpn name type vpls { .Pp Layer 2 VPN specific parameters are listed below. .Bl -tag -width Ds -.Pp .It Ic bridge Ar interface Set the bridge interface the VPLS is associated with. This parameter is optional and is only used to remove MAC addresses received from MAC address withdrawal messages. Only one bridge interface can be set. -.Pp .It Ic interface Ar interface Configure a non pseudowire interface pertaining to the VPLS. This parameter is optional and is only used to send MAC address withdrawal messages when the specified interface is shutdown. Multiple interfaces can be configured. -.Pp .It Ic mtu Ar number Set the MTU advertised in the pseudowires. Local and remote MTUs must match for a pseudowire to be set up. @@ -290,6 +287,7 @@ Specify the type of the configured pseudowires. The type must be the same at both endpoints. The default is .Ic ethernet . +.El .Sh PSEUDOWIRES Each .Xr mpw 4 @@ -313,15 +311,12 @@ Specify whether the use of the control word is preferred or not preferred. The default is .Ic yes . -.Pp .It Ic neighbor-addr Ar address Specify the IPv4 or IPv6 address of the remote endpoint of the pseudowire. A targeted neighbor will automatically be created for this address. By default, the LSR-ID of the remote endpoint of the pseudowire will be used. -.Pp .It Ic neighbor-id Ar address Specify the LSR-ID of the remote endpoint of the pseudowire. -.Pp .It Ic pw-id Ar number Set the PW ID used to identify the pseudowire. The PW ID must be the same at both endpoints. @@ -334,6 +329,7 @@ Specify whether the use of the Status TLV is preferred or not preferred. The default is .Ic yes . +.El .Sh FILES .Bl -tag -width "/etc/ldpd.conf" -compact .It Pa /etc/ldpd.conf |