| Age | Commit message (Collapse) | Author | |
|---|---|---|---|
| 2006-10-22 | Check that ni->ni_rates.rs_nrates is not greater than sizeof rs.rates in | Damien Bergamini | |
| iwi_auth_and_assoc() before copying the rate set. The firmware command allows a maximum of 12 rates to be defined while the ieee80211_rateset structure can contain up to 15 rates. Notice that this should not happen since the rate set is supposed to be negotiated at that time but Jeremie Le Hen sees some evidence of this happening in FreeBSD. In case it happens, print a diagnostic message and truncate the rate set. Pointed out by Jeremie Le Hen. | |||
| 2006-10-22 | sync the zyd entry; | Jason McIntyre | |
| 2006-10-22 | oops, the eventnotify stuff was accidentally enabled with the scsiconf | David Gwynne | |
| changes. its not ready yet, so disable it again. | |||
| 2006-10-22 | cancel progress meter when upload write fails; ok deraadt@ | Damien Miller | |
| 2006-10-22 | Activate RX radiotap. We have RSSI for now. | Marcus Glocker | |
| 2006-10-21 | does not compile | Theo de Raadt | |
| 2006-10-21 | Fix RX handling; the chip injects control data in front and between | Marcus Glocker | |
| a 802.11 frame which needs to be cut off. Looks like we receive the first correct looking management frames now. Add first radio bpf mtap bits but don't activate them in the RX handler yet. Need first to find out which radio data the card delivers. | |||
| 2006-10-21 | - Ensure that at least 16 TX descriptors are kept unused in the ring. | Brad Smith | |
| - Use more complete error handling for TX load problems. From scottl@FreeBSD | |||
| 2006-10-21 | sync w/ current mirrors.dat | Alexander von Gernler | |
| while there, create an extra section for 2nd lvl mirrors, easier to maintain ok deraadt@ | |||
| 2006-10-21 | Don't try to spoof 0 length DOS MBR/EBR partitions. By skipping | Kenneth R Westerback | |
| partitions with 0 in the length field we don't need to test for and skip partitions that are all zeros. Eliminating that code allows elimination of a local pointer. "0 length partitions are definately dead" deraadt@ | |||
| 2006-10-21 | remove IBSS and add monitor mode to the list of supported | Damien Bergamini | |
| operating modes. | |||
| 2006-10-21 | enable zyd | Theo de Raadt | |
| 2006-10-21 | some extra const disease damien was testing slipped in; ok damien | Theo de Raadt | |
| 2006-10-21 | huge diff to bring zyd(4) into a working state. | Damien Bergamini | |
| should work with ZD1211 (not ZD1211B!) adapters with either a RFMD or AL2230 radio chip. does not support IBSS or HostAP modes yet. committed over a Billion 3011G (ZD1211/AL2230). "commit it!" deraadt@ | |||
| 2006-10-21 | Retire B_LOCKED and BQ_LOCKED. The last real usage of the | Thordur I. Bjornsson | |
| flag and the buffer queue went away when LFS was removed. ok, pedro@ "looks sane", deraadt@ testing: tybollt@solace.miun.se | |||
| 2006-10-21 | Some KNF cleanup. | Kenneth R Westerback | |
| De-register. Move declaration to top of function for DOS MBR processing. Indent nit in macppc. No functional change. | |||
| 2006-10-21 | sync | Damien Bergamini | |
| 2006-10-21 | Intel PRO/Wireless 3965ABG | Damien Bergamini | |
| 2006-10-21 | acx(4) and pgt(4) don't use rssadapt(9) for automatic rate control. | Damien Bergamini | |
| acx(4) uses AMRR and automatic rate control is handled by the firmware for pgt(4). | |||
| 2006-10-21 | Do not pass down IOBASEUNK/MADDRUNK/IRQUNK. | Mark Kettenis | |
| ok miod@, drahn@ | |||
| 2006-10-21 | We have a pointer (pp), so use it in the DOSPTYP_UNUSED case rather | Kenneth R Westerback | |
| than lp->d_partitions[8+n++]. All other cases already use the pointer. No functional change. | |||
| 2006-10-21 | the create and destroy functions for clonable interfaces return 0 on | Henning Brauer | |
| success, not -1 on error. fix check in 2 cases. ok mpf mcbride | |||
| 2006-10-21 | note that -hP and -iP are illegal; ok otto | Jason McIntyre | |
| 2006-10-21 | bufferevent_write() return code misdocumented; ok jmc | Theo de Raadt | |
| 2006-10-21 | remove calls to abort(3) that can't happen anyway; from | Otto Moerbeek | |
| <bret dot lambert at gmail.com>; ok millert@ deraadt@ | |||
| 2006-10-21 | rework the bus scanning code by splitting it out into separate functions | David Gwynne | |
| for walking the bus and targets, and probing the luns. this removes the need to use magic numbers to wildcard each of these, which in turn makes the code a lot easier to read. as a bonus we get some more space to work in (80 chars isnt that much somtimes). note that this code wont probe high luns if lun 0 doesnt exist. ok krw@ | |||
| 2006-10-21 | in client_nextaddr, check fd != -1 before close, just nicer this way | Henning Brauer | |
| From: amandal@entrisphere.com | |||
| 2006-10-21 | Found that even if client fd (i.e to NTP source) is set to | Henning Brauer | |
| -1 because of error, it may still participate in poll() causing poll() to repeatedly wake up on error fd. so make sure w edon't add -1 fds to pollevents to avoid unnecessary wakeups From: amandal@entrisphere.com | |||
| 2006-10-21 | when ntp_sendmsg fails, reset trustlevel to TRUSTLEVEL_PATHETIC | Henning Brauer | |
| From: amandal@entrisphere.com | |||
| 2006-10-21 | EADDRNOTAVAIL after connect is one of the soft errors where we don't abort | Henning Brauer | |
| too. from amandal@entrisphere.com | |||
| 2006-10-21 | tbert sent me a diff to change some 0 to NULL | Ted Unangst | |
| i got carried away and deleted a whole bunch of useless casts this is C, not C++. ok md5 | |||
| 2006-10-20 | Try again with local variable to avoid alignment issues. | Kenneth R Westerback | |
| "The dosparts member of cpu_disklabel was not used for any persistant data. Eliminate it, and just use the data being read in while processing MBR and EBR records. Should be no functional change. ok weingart@ deraadt@" | |||
| 2006-10-20 | indent | Theo de Raadt | |
| 2006-10-20 | use the ASIX AX88190 defines from ax88190reg.h and remove some | Brad Smith | |
| AX88190 specific defines from ne2000reg.h From NetBSD | |||
| 2006-10-20 | some defines for the ASIX AX88790 chipset. | Brad Smith | |
| From NetBSD | |||
| 2006-10-20 | some new flags. | Brad Smith | |
| From NetBSD | |||
| 2006-10-20 | sync some comments with the NetBSD driver. | Brad Smith | |
| 2006-10-20 | remove another chunk of unused NetBSD code. | Brad Smith | |
| 2006-10-20 | remove some NetBSD code. | Brad Smith | |
| 2006-10-20 | ansi | Brad Smith | |
| 2006-10-20 | fix $OpenBSD$ tag. | Xavier Santolaria | |
| 2006-10-20 | from freebsd rev1.128: | Michael Shalayeff | |
| If an error occurs while writing a buffer, then the data will not have hit the disk and the dependencies cannot be unrolled. In this case, the system will mark the buffer as dirty again so that the write can be retried in the future. When the write succeeds or the system gives up on the buffer and marks it as invalid (B_INVAL), the dependencies will be cleared. pedro@ ok | |||
| 2006-10-20 | brelse() after failed bread(), from Christoph Egger, okay mickey@ | Pedro Martelletto | |
| 2006-10-20 | OpenBSD no longer supports using an older FreeBSD MBR partition. | David Hill | |
| ok krw@ | |||
| 2006-10-20 | remove the IFM_100_T4 switch case for the manual media code, brgphy(4) | Brad Smith | |
| does not actually support 100baseT4. | |||
| 2006-10-20 | attach for the Broadcom BCM5755 ASIC based chipsets as well. | Brad Smith | |
| 2006-10-20 | regen | Brad Smith | |
| 2006-10-20 | add PHY id for the Broadcom BCM5755 ASIC based chipsets. | Brad Smith | |
| 2006-10-20 | move the Jumbo frame settings and Ethernet@Wirespeed code into separate | Brad Smith | |
| functions. no-op change. | |||
| 2006-10-20 | Declare loop variable so this compiles. | Jonathan Gray | |
| ok krw@ | |||
 |
index : src | |
| OpenBSD base system |
| summaryrefslogtreecommitdiff |