| Age | Commit message (Expand) | Author |
|---|
| 2006-06-26 | ServerWorks HT-1000 | Brad Smith |
| 2006-06-26 | add the PCI id for the ServerWorks HT-1000 SMbus controller. | Brad Smith |
| 2006-06-26 | mention optional bind_address in runtime port forwarding setup | Damien Miller |
| 2006-06-26 | darwin's turtle is nomore | Michael Shalayeff |
| 2006-06-26 | increase polling intervbal, but only after we are synced and have done | Otto Moerbeek |
| 2006-06-26 | Reset adjtime() on startup; having an adjtime() active while starting | Otto Moerbeek |
| 2006-06-26 | sync the bge and bnx entries; | Jason McIntyre |
| 2006-06-26 | tweaks; | Jason McIntyre |
| 2006-06-26 | remove wicontrol stuff; | Jason McIntyre |
| 2006-06-26 | remove wicontrol stuff; | Jason McIntyre |
| 2006-06-26 | I'm not sure where the NC370i came from, but HP definitely makes a NC370F, | Brad Smith |
| 2006-06-26 | add commented out entries for bnx. | Brad Smith |
| 2006-06-26 | Code cleanup/shortening. No binary changes. | Marc Balmer |
| 2006-06-26 | do not allow a Jumbo size MTU yet. | Brad Smith |
| 2006-06-26 | mention bnx(4). | Brad Smith |
| 2006-06-26 | add a man page. | Brad Smith |
| 2006-06-26 | relocate the firmware per Theo's request. | Brad Smith |
| 2006-06-26 | sync | Theo de Raadt |
| 2006-06-26 | Add support for bnx(4). | Brad Smith |
| 2006-06-26 | Add a rough initial port of the bce driver from FreeBSD, which provides | Brad Smith |
| 2006-06-26 | Kludge around the fact that redboot uses ELF's vaddr, however maps | Dale Rahn |
| 2006-06-26 | wicontrol went away | Theo de Raadt |
| 2006-06-26 | sync | Theo de Raadt |
| 2006-06-26 | wicontrol went away | Theo de Raadt |
| 2006-06-26 | wicontrol goes away, use ifconfig. yes, a few things cannot be done | Theo de Raadt |
| 2006-06-26 | enable ne*; ok mpf who tested it, we all feel bad for you | Theo de Raadt |
| 2006-06-26 | remove extraneous brackets and list the architecures in alphabetic order. | Brad Smith |
| 2006-06-26 | Add IDE_PCI_CLASS_OVERRIDE for ServerWorks HT-1000 SATA. | Brad Smith |
| 2006-06-25 | fix a typo in a comment and add the comment to the sparc hme driver. | Brad Smith |
| 2006-06-25 | put the 1.32 change back; tested by many | Michael Shalayeff |
| 2006-06-25 | rename vfs_busy() flags VB_UMIGNORE/VB_UMWAIT to VB_NOWAIT/VB_WAIT | Nikolay Sturm |
| 2006-06-25 | regen | Martin Reindl |
| 2006-06-25 | fix Surecom NE-34 dmesg, found on misc@ | Martin Reindl |
| 2006-06-25 | add a note for MTU adjustment. | Brad Smith |
| 2006-06-25 | reorganize the code to be more sane. | Brad Smith |
| 2006-06-25 | regen | Brad Smith |
| 2006-06-25 | add Parallels PCI ids. | Brad Smith |
| 2006-06-25 | DAC&ADC group and custom mixer table for the CMedia CMI9880. | Brad Smith |
| 2006-06-25 | If the encoding of an audio converter is 0, refer to | Brad Smith |
| 2006-06-24 | Shave 8 bytes off struct udf_mnt | Pedro Martelletto |
| 2006-06-24 | replace unneeded bzero() | Pedro Martelletto |
| 2006-06-24 | rearrange some comments | Pedro Martelletto |
| 2006-06-24 | ieee80211_cfgget() and ieee80211_cfgset() are dead; ok jsg | Theo de Raadt |
| 2006-06-24 | Configure network devices at ipl 3, not ipl 1. | Miod Vallat |
| 2006-06-24 | Replace physaccess() usage with pmap_kenter_cache(). | Miod Vallat |
| 2006-06-24 | regen | Jonathan Gray |
| 2006-06-24 | Correct a typo in one of the CN700 host bridge product ids. | Jonathan Gray |
| 2006-06-24 | Add abstraction for resistor factors and avoid using the rfact member of | Mark Kettenis |
| 2006-06-24 | Use pmap_enter_cache() instead of physacc() in bus_mem_add_mapping(), and let | Miod Vallat |
| 2006-06-24 | Allocate ethernet buffers as uvm pages, and map them with pmap_enter_cache(), | Miod Vallat |
