Age | Commit message (Collapse) | Author |
|
ok krw@
|
|
tested and ok krw@, "get it in" deraadt@
|
|
e.g. 'Brazil/DeNoronha East'. Input with embedded spaces put the
install script into a state where a valid timezone could not be
entered.
Problem noted by and fix tested by Javier Bassi.
ok deraadt@
|
|
/etc has changed in substantial ways. Perhaps on the 5.0->5.1 transition
this will not be so scary. As it is now, it is way too tempting for
inexperienced users with incredibly complex configurations to go into
sysmerge and cause themselves major havoc.
|
|
when they are per-device packages which can containing more than one
firmware files..
from sthen
|
|
ok deraadt krw
|
|
pointed out by Moritz Grimm (mgrimm-at-mrsserver-dot-net)
|
|
user picks up rtsol.
reported in bugs@ by Rene Maroufi (info at maroufi dot net).
bluhm@ ok
|
|
run when upgrading using a CD.
The reason was that at the time sysmerge(8) would run (and gets its
sets), the CD would be unmounted. We are now taking a different approach
and get the (x)etc sets anyway according to whether base and/or xbase
was selected and put them under /tmp in the chroot.
This way whatever upgrade method is chosen, the sets will always be in
a consistent location.
ok krw@
|
|
startup-like output in fw_update
"looks good" deraadt@
|
|
future messes now that there are a few more dynamics programs running
in chroot.
|
|
reported by and ok krw@
|
|
"go ahead" deraadt@
|
|
"i like" henning@, "Fine with me" deraadt@
|
|
- Globals variable names should not start with an underscore
- Fetch {,x}etcNN.tgz from where we found the corresponding base
(meaning it must not be the same place)
"reads ok" todd@, ok krw@
|
|
the sysmerge(8) question now which makes it pretty obvious.
ok krw@
|
|
we could as well pull the 'mv bsd.mp bsd' and the associated checks
out of there.
ok deraadt@ "makes sense" todd@
|
|
to no.
The way it works is as follow:
- if baseXX was selected during the upgrade, etcXX will be added to the
args to pass to sysmerge(8)
- if xbaseXX was selected during the upgrade, xetcXX will be added to
the args to pass to sysmerge(8)
Note that etcXX and xetcXX will always be fetched from the first
installation source that was configured during the upgrade (it is most
likely that other sources contain site specific sets rather than the
base ones).
This option will not be available when using tape.
"read good" krw@
prodded by and ok (with love) pirofti@, ok deraadt@
|
|
net.inet6.ip6.accept_rtadv in sysctl.conf or not) on updates
as then we dont do any network config, so move it from
install.sub to install.sh
idea not rejected by IPv6-enabled bluhm@
ok krw@ deraadt@
|
|
In effect, this removes the "old" vndX nodes, and renames
the svndX nodes to vndX.
Old svndX nodes will still continue to work though, for now.
Cleanup accordingly.
ok deraadt@, todd@
comments and ok on the man page bits from jmc@
|
|
by deraadt@.
|
|
/etc/fstab, after asking user. Current default is existing behaviour.
Feedback & suggestions deraadt@, halex@, jsing@, todd@.
ok deraadt@
|
|
/root/.forward.
"makes sense" kettenis, ok pirofti@ deraadt@
|
|
when they won't be able to boot the installed root disk. Move
installboot invocation to just before congratulation on sucess is
emitted. Thus the installed partition will be 'complete' if it ever
is booted.
"go for it" deraadt@
|
|
Silence is golden. Problem seen and fix tested by guenther@.
ok guenther@ halex@
|
|
populated upon installation again.
|
|
- ask for permission to continue upgrade if one or more mounts failed
Fixes issue noted by Peter Miller, who also tested the diff. Thanks!
ok krw@
|
|
in particular a single write will result in a single re-key event,
rather than 64 writes causing 64 re-keys -- wasting the kernel's time.
|
|
|
|
to change the environment that functions assume they run in. use
sub-shells or absolute paths when possible.
ok krw
|
|
pointed out by Mikalaj Kucharski, mikolaj at kuharski dot name
ok deraadt@
|
|
please commit deraadt@
|
|
this code has been busted for quite a while.
pointed out by miod
|
|
ok kjell otto miod
|
|
ok krw@, jsing@
|
|
an ip address
- do the same on startup of the install/upgrade too
- do NOT do it unconditionally on all dhcp'd interfaces, since
we use the group to retain state.
ok krw@, deraadt@
|
|
|
|
- use the aformentioned function to properly quote the wireless config
into /etc/hostname.$if
Now, if only /etc/netstart didn't screw up whitespace...
"I don't speak Swahili, so I'm going to have to trust you" deraadt@
no objections from others, specifically so from krw@
|
|
ok krw@
|
|
|
|
|
|
ok halex guenther
|
|
(which has already been mounted).
discussed with halex
|
|
|
|
based on a diff from damien@
ok deraadt@
|
|
|
|
of the "additional" list files (for architectures which split the list)
Then... cleanup some TZ which it is clear should not have been placed onto
certain media which don't have the space for them.
|
|
|
|
telnet portion partially from the latest heimdal.
ok mikeb@
|
|
|