Age | Commit message (Expand) | Author |
2005-10-31 | show the speed status in hw.cpuspeed; ok drahn | Theo de Raadt |
2005-10-31 | On suspend/resume save the current time to the RTC earlier and restore it later | Dale Rahn |
2005-09-22 | NEWINTR is not an option on OpenBSD. | Dale Rahn |
2005-09-15 | Stop compiling the texte console rotation code #ifdef __zaurus__, but use | Miod Vallat |
2005-08-12 | Do not notify apmd of APM_CRIT_SUSPEND_REQ events; apmd makes us fall | Uwe Stuehler |
2005-08-09 | - Don't depend on the APM_CRIT_RESUME event to run PWR_RESUME power hooks | Uwe Stuehler |
2005-08-08 | Avoid overlap in USB hard and the soft interrupt bits, update comments | Uwe Stuehler |
2005-07-18 | remove trailing newline in panic(9); ok millert@ and deraadt@ | Federico G. Schwindt |
2005-07-18 | Initialize UART registers after resume, and make functions non-static. | Uwe Stuehler |
2005-07-01 | Move all zaurus specific code from pxa2x0_pcic.c into scoop_pcic.c | Uwe Stuehler |
2005-06-16 | GPIO generates many shared interrupts, eg disk (cf) and network (other cf) | Dale Rahn |
2005-06-16 | i2c and i2s are separete devices, and zaudio depends on them. | Uwe Stuehler |
2005-06-16 | unbust "com at pxaip" attachment so that there is no need to enable | Uwe Stuehler |
2005-05-27 | add missing prototypes | Uwe Stuehler |
2005-05-27 | Dale's lost diff for IRQ sharing, turned on by default. | Uwe Stuehler |
2005-05-27 | The forgotten part of the merge of pxacom back into com. | Uwe Stuehler |
2005-05-27 | - Merge changes from pxacom back into the common com driver. | Uwe Stuehler |
2005-05-27 | Replace unused pxa2x0_watchdog_boot() with RTC control functions. | Uwe Stuehler |
2005-05-26 | Reset the zaurus audio components after resume, so that subsequent opens | Christopher Pascoe |
2005-05-23 | fix rasops initialization when not acting as console; ok miod@ | Uwe Stuehler |
2005-05-23 | Round the DMA block size, not the maximum buffer size. Addresses "request | Christopher Pascoe |
2005-05-23 | Avoid potential null pointer dereference. | Christopher Pascoe |
2005-05-09 | Permit one of the PXA2X0's UARTs to operate in Slow Infrared (SIR) mode | Uwe Stuehler |
2005-04-30 | Temporary hack to (un)rotate the Zaurus console until a proper rasops | Christopher Pascoe |
2005-04-21 | clean dmesg output | Theo de Raadt |
2005-04-17 | make sure round_blocksize does not produce 0 after alignment | Christopher Pascoe |
2005-04-15 | Remove i2c entry, it is included from zaudio config. | Christopher Pascoe |
2005-04-15 | Functions for accessing the pxa2x0 I2S controller. | Christopher Pascoe |
2005-04-15 | Routines providing access to the pxa2x0 I2C controller. | Christopher Pascoe |
2005-04-14 | Add basic support for the pxa2x0 DMA controller. | Christopher Pascoe |
2005-04-13 | Call special suspend and resume hooks. The latter can cancel a resume. | Uwe Stuehler |
2005-04-12 | register descriptions for the inter-ic sound controller | David Gwynne |
2005-04-12 | size for the i2s controller registers, and add some comments for clarity | David Gwynne |
2005-04-12 | better reg descriptions of the ac97 controller. | David Gwynne |
2005-04-11 | no need to include sys/timeout.h | Uwe Stuehler |
2005-04-11 | - eliminate extra powerhook in pxalcd, inspired by ohci changes | Uwe Stuehler |
2005-04-11 | - ask upper layer for events and call apm_record_event() as appropriate | Uwe Stuehler |
2005-04-08 | - manipulate the proper event counter in pxagpio_intr1 | Uwe Stuehler |
2005-04-08 | clean up properly in the event of a failure during attach. | David Gwynne |
2005-04-06 | spelling/grammar cleanups | Christopher Pascoe |
2005-04-05 | Argument to DELAY should be usecs, not hz. | Christopher Pascoe |
2005-04-03 | check powerhook_establish() result, and pass the correct softc to it. | Uwe Stuehler |
2005-03-30 | use the local powerhook, not the generic ohci one. suspend/resume now works | David Gwynne |
2005-03-30 | extra gunk to make ohci suspend and resume work on the zaurus | David Gwynne |
2005-03-30 | make the powerhooks the responsibility of the bus ohci is attached to | David Gwynne |
2005-03-30 | complete the definition of the power manager sleep status register | David Gwynne |
2005-03-29 | Handle apm_battlow flag by suspending, and clear all flags after resume. | Uwe Stuehler |
2005-03-22 | Use a sane interrupt priority for serial. Has a better chance of working. | Dale Rahn |
2005-03-09 | With some correct interrupt acknowledgement and register initialization, | Dale Rahn |
2005-03-09 | Wait for card to become ready after reset; ok drahn@ | Uwe Stuehler |