index
:
src
cvs/HEAD
kms/intel
kms/radeon
master
OpenBSD base system
summary
refs
log
tree
commit
diff
log msg
author
committer
range
path:
root
/
sys
/
dev
/
fdt
Age
Commit message (
Expand
)
Author
2020-11-19
Use bus_space_mmap(9) instead of pmap_extract(9) to find out the physical
Mark Kettenis
2020-11-17
Split imxiic(4) into the FDT-attachment code and the i.MX I2C code
Patrick Wildt
2020-11-14
Add support for the VF610 I2C controller to imxiic(4). It uses its
Patrick Wildt
2020-11-14
Move enabling/disabling the I2C controller and clearing the Interrupt
Patrick Wildt
2020-11-14
Add 10G media support. This makes the 10G ports on the "single shot" model
Mark Kettenis
2020-11-13
Assert reset before configuring the MACs. Otherwise we leave the 10G MAC
Mark Kettenis
2020-11-13
To prepare for upcoming VF610 support, access the clk div table using
Patrick Wildt
2020-11-13
Convert array of two-element arrays into a much more readable array of
Patrick Wildt
2020-11-13
Add define for the status register's Arbitration Lost bit.
Patrick Wildt
2020-11-13
On VF610 the registers are a single byte apart, so introduce a regshift
Patrick Wildt
2020-11-13
Even though the registers are 16-bit wide, the upper 8 bits are always
Patrick Wildt
2020-11-12
Reconfigure the COMPHY mode when we find an SFP and configure inband media
Mark Kettenis
2020-11-12
FDT-based I2C drivers should not use OF_* API in the match code, since
Patrick Wildt
2020-11-10
Enable optical output when bringing an interface up and disable it again
Mark Kettenis
2020-11-10
Add interfaces to control optical output of an SFP.
Mark Kettenis
2020-11-10
Fix previous commit; using > 0 to check a pointer isn't quite right.
Mark Kettenis
2020-11-10
If possible, check the MOD-DEF0 signal to detect the presence of an SFP.
Mark Kettenis
2020-11-09
Rework MAC initialization code. Properly turn comphy off and on again
Patrick Wildt
2020-11-09
Clear TX sent counter on up/down.
Patrick Wildt
2020-11-09
On interface down, drop received packets by adding them back into the
Patrick Wildt
2020-11-09
Small whitespace cleanup.
Patrick Wildt
2020-11-08
Add supported media types for SFPs.
Mark Kettenis
2020-11-08
U-Boot might not have cleaned its pools. The pool needs to be empty
Patrick Wildt
2020-11-08
Hand the pool a physical address, not a virtual one.
Patrick Wildt
2020-11-08
Check that DMA memory has been allocated for the rings and the BM. While
Patrick Wildt
2020-11-07
Add clock support for i.MX8MP. This variant uses essentially the
Patrick Wildt
2020-11-06
The ClearFog GT 8K device tree references the PP22's gate clock
Patrick Wildt
2020-11-03
Have mvpp(4) pass MII flags depending on the phy mode specified in
Patrick Wildt
2020-11-03
Disable HW PHY polling. It's enabled by default.
Patrick Wildt
2020-10-12
Add support for the i.MX8M AHB clocks. These behave just like all the
Patrick Wildt
2020-10-12
OCOTP's parent clock is the IPG clock on i.MX8M.
Patrick Wildt
2020-10-08
Register sxitwi(4) in the I2C framework.
Patrick Wildt
2020-09-29
Add support for A64 UART resets.
Mark Kettenis
2020-09-13
Add support for the RK3308 MAC.
Jonathan Matthew
2020-09-13
Correct the property name used to look up the delays for the phy reset
Jonathan Matthew
2020-09-08
Add RK3308 temperature sensors.
Jonathan Matthew
2020-09-08
Add RK3328 PWM, also found in the RK3308.
Jonathan Matthew
2020-09-06
Add RK3308 clocks
Jonathan Matthew
2020-09-04
Add RK3308 pinctrl support
Jonathan Matthew
2020-09-04
Add RK3308 GRF
Jonathan Matthew
2020-08-30
PLL1(CPU_PLL) stability improvement for Allwinner H3/H2+
SASANO Takayoshi
2020-08-24
Enable UHS-I support. No SDR104 support though since it doesn't seem to work
Mark Kettenis
2020-08-22
Rework unicast/multicast configuration. Keep note that this only changes
Patrick Wildt
2020-08-22
Correct oversize rxq initialization in the classifier.
Patrick Wildt
2020-08-22
IPv4 protocol parser init fixup and a few whitespace fixes.
Patrick Wildt
2020-08-22
Consistently use sizeof(pe) or sizeof(*pe) for the parser entry struct.
Patrick Wildt
2020-08-22
Use sizeof(variable) instead of using a macro for the length parameter.
Patrick Wildt
2020-08-22
Simplify some code by getting rid of an extra variable.
Patrick Wildt
2020-08-22
More consistent use of the BIT() macro.
Patrick Wildt
2020-08-22
Simplify check for return code.
Patrick Wildt
[next]