| Age | Commit message (Expand) | Author |
|---|
| 2021-08-26 | Request wMaxInputLength bytes of data on each interrupt which should | Joshua Stein |
| 2021-06-23 | Add titmp(4), a driver for the TI TMP451 temperature sensor. | Mark Kettenis |
| 2021-04-24 | Remove unused function pointers from `todr_handle'. | Martin Pieuchot |
| 2021-01-22 | ims: an actual i2c-connected mouse is unlikely | Joshua Stein |
| 2021-01-13 | Add support for the HYM8563 RTC, which is a PCF8563 clone. | Mark Kettenis |
| 2020-11-14 | Extend pcamux(4) with ACPI support. So far pcamux(4) has assumed it's | Patrick Wildt |
| 2020-11-13 | Add support for the PCA9547 I2C mux to pcamux(4). In comparison to | Patrick Wildt |
| 2020-10-23 | Add support for the Micro Crystal RV4162. This variant holds the | Patrick Wildt |
| 2020-09-30 | Move mfokclock(4) from loongson to sys/dev/i2c so that it be used by more | Patrick Wildt |
| 2020-09-29 | Add support for the PCA9546 I2C switch to pcamux(4). In comparison to | Patrick Wildt |
| 2020-09-29 | The pcamux(4) device tree node's children are the individual channels, | Patrick Wildt |
| 2020-08-26 | Declare hw_{prod,serial,uuid,vendor,ver} in <sys/systm.h>. | Visa Hankala |
| 2020-07-09 | On some laptops that have a Windows Precision Touchpad (imt) and | Joshua Stein |
| 2020-06-18 | Add pcamux(4), a driver for the PCA8548 I2C switch. | Mark Kettenis |
| 2020-04-29 | Enable the trickle charger after setting the control register. | Patrick Wildt |
| 2020-04-29 | Update the trickle charger diode defines based on the datasheet, and | Patrick Wildt |
| 2020-04-29 | Writing and reading time has been broken in abcrtc(4) as well. I was | Patrick Wildt |
| 2020-04-29 | Configure abcrtc(4)'s trickle charger. This uses information | Patrick Wildt |
| 2020-04-29 | The function to write to abcrtc(4)'s configuration registers | Patrick Wildt |
| 2020-04-27 | Attach when the name matches "dallas,ds1307" which is what the device tree | Mark Kettenis |
| 2020-04-27 | Don't clear OSF flag when we attach such that we can reject the RTC clock | Mark Kettenis |
| 2020-04-25 | Add dsxrtc(4), a driver for the Maxim DS3231/DS3232 I2C RTC. | Mark Kettenis |
| 2020-04-24 | Remove unused include. | Mark Kettenis |
| 2020-04-24 | Remove unused struct. | Mark Kettenis |
| 2020-01-24 | ihidev(4): tsleep(9) -> tsleep_nsec(9); ok mpi@ jcs@ | cheloha |
| 2020-01-11 | Use block mode for smbus access as required by the IPMI standard and | Mark Kettenis |
| 2020-01-11 | Add constants to support block mode. Needed to support SMBus block read | Mark Kettenis |
| 2020-01-09 | Convert sleeps of 1sec or more to tsleep_nsec(9). | Martin Pieuchot |
| 2019-12-16 | Extend the expected SPD types to include DDR4 and low-power DDR3 & 4. | Claudio Jeker |
| 2019-10-06 | Fix month mask. | Mark Kettenis |
| 2019-09-06 | mcprtc(4), a driver for the Microchip MCP79400 RTC and similar variants. | Patrick Wildt |
| 2019-09-03 | Avoid uninitialized variable; using a for loop like in siif_recvmsg() was | Mark Kettenis |
| 2019-08-19 | Add support for SMBus System Interface (SSIF). | Mark Kettenis |
| 2019-07-31 | ihidev: continue doing polling when interrupt setup fails | Joshua Stein |
| 2019-07-22 | Even when polling is requested, install ihidev's interrupt handler | Joshua Stein |
| 2019-04-08 | change psize to a signed int to cope with it going negative since | Joshua Stein |
| 2019-01-02 | abcrtc(4), a driver for the Abracon AB1805 RTC and similar variants. | Patrick Wildt |
| 2018-09-20 | fix a memory leak in ihidev_hid_command() | Jonathan Gray |
| 2018-09-01 | Match on interfaces with Digitizers/Touchscreen collections, as long | Joshua Stein |
| 2018-08-25 | Add umt(4) for USB Windows Precision Touchpad devices | Joshua Stein |
| 2018-08-25 | Move HID->bus constant conversion for HID report types out of ihidev | Joshua Stein |
| 2018-07-30 | define WSMOUSE_TYPE_TOUCHPAD so non-elantech drivers can stop | Joshua Stein |
| 2018-07-09 | Strip down the (not enabled) pcagpio(4) GPIO extender. This removes | Patrick Wildt |
| 2018-06-22 | set I2C_F_POLL when acquiring the iic bus in an interrupt handler | Joshua Stein |
| 2018-04-07 | Add islrtc(4), a driver for the Intersil ISL1208 Real Time Clock. | Mark Kettenis |
| 2018-01-12 | revert previous changes to enable dwiic on Dell precision as it seems | Mike Larkin |
| 2018-01-08 | Attach dwiic_pci on Dell Precision 7520. Also restrict ihidev reports | Mike Larkin |
| 2017-11-30 | Add bgw(4), a driver for a family of Bosch acceleration sensors. | Mark Kettenis |
| 2017-11-29 | add an adaptive polling mode when no interrupt handler is available, | Joshua Stein |
| 2017-10-28 | Add the compat-mode setup for wsmouse. | Ulf Brosziewski |
