| Age | Commit message (Collapse) | Author | |
|---|---|---|---|
| 2005-04-25 | csum -> csum_flags | Brad Smith | |
| ok krw@ canacar@ | |||
| 2005-04-23 | style | Brad Smith | |
| 2005-01-15 | make sure interface is in RUNNING state before touching the multicast filters | Brad Smith | |
| From NetBSD NetBSD PR 27678 for details ok mcbride@ | |||
| 2004-11-01 | back out previous commit. | Brad Smith | |
| 2004-10-31 | don't swap zeros | Brad Smith | |
| 2004-10-23 | add missing braces, noticed by mcbride@ | Brad Smith | |
| 2004-10-23 | re-add old xl_encap_90xB() for 905B/C cards. removed in rev 1.52. | Brad Smith | |
| fixes reported mbuf leaks as well as transmit side breakage on macppc, PR 3892. ok mcbride@ | |||
| 2004-10-02 | remove if NVLAN here too | Brad Smith | |
| 2004-09-28 | remove if NVLAN around IFCAP_VLAN_MTU | Brad Smith | |
| 2004-09-23 | don't need to set ifp->if_mtu or ifp->if_output in each driver, | Brad Smith | |
| {ether,atm,fddi}_ifattach already does this. ok mcbride@ markus@ henning@ | |||
| 2004-06-04 | fix conversion to ether_crc32_be(). problem noticed by naddy@ | Brad Smith | |
| ok mcbride@ | |||
| 2004-06-01 | dv_xname is not the same as dv_unit (for hell knows what reason) | Michael Shalayeff | |
| 2004-05-30 | a bit of syncing with the FreeBSD driver, namely... | Brad Smith | |
| - disable TX hardware checksumming since its buggy and slow - re-enable the hardware multicast filter setup on 3c905B/C's - enable reception of VLAN sized frames on 3c90x's (pre B/C) - remove all DELAY(1) calls around MII operations in the xl driver. according to the MII specification, the delay produced by our reads alone are sufficient for correct operation. this reduces the time mii_tick takes from 10ms to ~1ms here. that's still a lot, but much better than before - report media status for bitrate PHYs - change the method used to detect older boomerang chips - fix an issue with reading PHY regs over the i2c bus - fix mbuf leaks in an error (rare) code path - reuse the TX descriptor if xl_encap() failed instead of just picking the next one - fix bug with 3c90xB cards and newer. We weren't trying to copy the mbuf chain into an mbuf cluster when there is more than 63 mbufs in the chain. we were trying with older cards though - add some magic bits necessary to turn the transmitter on for some (newer) 556B chips local change... - use ether_crc32_be() instead of hand-rolled xl_calchash() tested on i386/3c900 by beck@, sparc64/3c905C by me, i386/3c905C by sturm@, naddy@ and a few others ok deraadt@ | |||
| 2003-10-21 | typos from Tom Cosgrove; | Jason McIntyre | |
| Tom: I did not commit a couple of your changes. i did not include some punctuation fixes (full stops, etc.) mnemorable -> mnemonic: i decided memorable was probably better instrunctions -> instruction: i kept the plural | |||
| 2003-06-29 | remove usage of xl_unit | Jason Wright | |
| 2003-03-24 | splimp() around xl_reset() during autoconf. something in xl_reset() wants | Jason Wright | |
| to generate an interrupt before the rings are setup correctly on some variants; ok deraadt. | |||
| 2003-01-05 | spelling | Theo de Raadt | |
| 2002-12-02 | - Remove a few magic constants | Jason Wright | |
| - set baudrate for the non-mii modes | |||
| 2002-11-25 | remove printf's in xl_setmode(). | Brad Smith | |
| -- deraadt@ ok | |||
| 2002-11-17 | Make sure never to put a loaded dmamap in the spare. 3c90x should work | Jason Wright | |
| on big endian now... | |||
| 2002-11-17 | this driver has never been in sys/pci (in OpenBSD at least) and supports | Jason Wright | |
| cardbus and pci interfaces; pointed out by brad. | |||
| 2002-11-17 | Fix another case (tx this time) where buffers were not unloaded (nor ↵ | Jason Wright | |
| sync'd). (bad bad aaron): 90xB works on sparc64, 90x is probably still broken. | |||
| 2002-11-17 | - lightly season with htole32 and friends... enough to get rx working | Jason Wright | |
| on sparc64 - also fix a bug when dmamap's were never freed on the rx side (bad aaron), and avoid a sync if we run out of buffers. | |||
| 2002-08-22 | simplify multicast setup on the 3c905 (pre-B/C, etc) | Jason Wright | |
| 2002-07-09 | Don't write 32 bits to a 16-bit register. | Aaron Campbell | |
| 2002-06-15 | Check the correct variable when freeing the RX/TX lists. | Aaron Campbell | |
| 2002-06-15 | bus_dma'ify. Tested on 3c900(pci), 3c905b(pci), and 3c575c(cardbus). Thanks | Aaron Campbell | |
| to todd@ and camiel@ for trying it, too. | |||
| 2002-06-09 | a step towards consistancy; in general: | Todd T. Fries | |
| 'struct arpcom foo' -> 'struct arpcom sc_arpcom' ok itojun@ | |||
| 2002-06-08 | Add hardware TCP/IP checksum offloading support for receive and transmit for | Aaron Campbell | |
| the 3c905b; deraadt@ ok. | |||
| 2002-03-14 | First round of __P removal in sys | Todd C. Miller | |
| 2002-02-15 | Don't cast nonexistent return value from splx to (void). ok art@ | Thomas Nordin | |
| 2002-01-25 | Disestablish *powerhook* on detach. jason@ ok | Thomas Nordin | |
| 2001-12-15 | Disestablish the powerhook on detach. ok jason@ | Thomas Nordin | |
| 2001-11-06 | Replace inclusion of <vm/foo.h> with the correct <uvm/bar.h> when necessary. | Miod Vallat | |
| (Look ma, I might have broken the tree) | |||
| 2001-08-19 | Don't reset rx/tx without turning them back on after suspend (Beck is now | Jason Wright | |
| able to do "Real Work" after a suspend) | |||
| 2001-08-19 | Add a powerhook for bringing the 556 out of sleepy mode after suspend. | Jason Wright | |
| (This isn't perfect... it still requires an down up transition, but Bob is kicking me off his laptop so he can do "Real Work"). | |||
| 2001-08-12 | remove some of the redundant vm includes | Michael Shalayeff | |
| 2001-08-03 | This driver allows vlan sized frames on 905B, set IFCAP_VLAN_MTU on that chip | Chris Cappuccio | |
| 2001-07-02 | these don't depend on pci register defs | Jason Wright | |
| 2001-06-27 | ALTQ'ify network drivers. | Kenjiro Cho | |
| - use the new queue macros. - use IFQ_POLL() to peek at the next packet. - use IFQ_IS_EMPTY() for empty check. - drivers should always check if (m == NULL) after IFQ_DEQUEUE(), since it could return NULL even when IFQ_IS_EMPTY() is FALSE under rate-limiting. - drivers are supposed to call if_start from tx complete interrupts (in order to trigger the next dequeue under rate-limiting). | |||
| 2001-06-23 | ether_input_mbuf(). | Federico G. Schwindt | |
| 2001-04-08 | Don't print anything for transmission error 90, since the driver always | Aaron Campbell | |
| recovers from the situation, and there's not much point in knowing about it. | |||
| 2001-03-25 | Missing splx(). Thanks to Dawson and team for finding this | Constantine Sapuntzakis | |
| 2001-02-20 | for ethernet ifaces attach bpf from ether_ifattach; jason@, aaron@, itojun@ ok | Michael Shalayeff | |
| 2001-02-02 | No need for xl(4) to report tx underruns, they are much too common, and the | Aaron Campbell | |
| driver adjusts itself to compensate anyway; jason@ ok. | |||
| 2001-01-12 | add SIOCSIFMTU; angelos@ coached | Todd T. Fries | |
| 2000-11-09 | new timeouts | Michael Shalayeff | |
| 2000-10-19 | if vlans are in use, then set the 3c905b to accept frames of size 1518. | Jason Wright | |
| 2000-10-16 | Use mii_attach() directly instead of mii_phy_probe(). | Aaron Campbell | |
| 2000-10-15 | Do not pass uninitialized ifmedia structures to ifmedia_add(). Fixes PR1426. | Aaron Campbell | |
| Thanks to reinhard@ for testing. | |||
 |
index : src | |
| OpenBSD base system |
| summaryrefslogtreecommitdiff |