| Age | Commit message (Expand) | Author |
|---|
| 2007-04-26 | Improve debug statements. No binary change without AMI_DEBUG. | Alexander Bluhm |
| 2007-04-23 | Kill inlines to shave some bytes. | Artur Grabowski |
| 2007-04-22 | disable debug output here too. it's working fine (even on strange archs) | David Gwynne |
| 2007-04-20 | Increase the delay while uploading a firmware buffer in malo_load_firmware(). | Claudio Jeker |
| 2007-04-19 | Cleanup phy selection code, simplifying the code considerably. Attach only | Mark Kettenis |
| 2007-04-19 | make it compile again if LMDEBUG is defined; | Robert Nagy |
| 2007-04-17 | The debug printf in malo_newstate() is too verbose so require debug level 2 | Claudio Jeker |
| 2007-04-16 | During the drives detection only check the status register to be not | Alexander Yurchenko |
| 2007-04-13 | scsi_generic is now 16 bytes. Adjust padding so struct is still | Kenneth R Westerback |
| 2007-04-13 | scsi_generic is now 16 bytes. Adjust offsets into structure being | Kenneth R Westerback |
| 2007-04-13 | The integrated Atheros NICs found in IBM/Lenovo ThinkPads use the same | Reyk Floeter |
| 2007-04-12 | Oops, a code rearrangement meant that I didn't initialise the failed ccb | Christopher Pascoe |
| 2007-04-11 | Remove debug leftovers to make console output quite again in hostap mode. | Marcus Glocker |
| 2007-04-11 | Cleanup makros even more. Remove unused ones and reduce the amount of | Claudio Jeker |
| 2007-04-11 | As probe response mgmt frames are already handled by the firmware, ignore | Marcus Glocker |
| 2007-04-10 | ``it's'' -> ``its'' when the grammar gods require this change. | Miod Vallat |
| 2007-04-10 | wrap reading of the error fis up into a func of its own, and use | David Gwynne |
| 2007-04-08 | Change the API to sili_port_intr so it can timeout a command and reuse the | Christopher Pascoe |
| 2007-04-08 | Add support for NCQ error recovery and enable NCQ command submission. | Christopher Pascoe |
| 2007-04-08 | Track the order that CCBs are submitted in, so that after an error we are | Christopher Pascoe |
| 2007-04-08 | sili uses one queue for NCQ and legacy commands. No need for the AHCI-style | Christopher Pascoe |
| 2007-04-07 | Always assume write commands had zero residual; the chip only counts | Christopher Pascoe |
| 2007-04-07 | Whitespace cleanup. No code change. | Christopher Pascoe |
| 2007-04-07 | Add transfer failure detection and recovery from non-fatal errors. | Christopher Pascoe |
| 2007-04-07 | Rework command issue/completion flow to be more like AHCI's and switch to | Christopher Pascoe |
| 2007-04-07 | Split command completion out into a separate function, working towards | Christopher Pascoe |
| 2007-04-07 | Permit PACKET command issue. | Christopher Pascoe |
| 2007-04-07 | Fill out control information for ATAPI commands. | Christopher Pascoe |
| 2007-04-07 | Helper macros to provide the port name in debug messages. | Christopher Pascoe |
| 2007-04-07 | Use the rx_count saved in the LRAM command slot entry to determine the | Christopher Pascoe |
| 2007-04-07 | Add some more device status related register definitions. | Christopher Pascoe |
| 2007-04-07 | Sync the command corresponding to our ccb, not slot 0. | Christopher Pascoe |
| 2007-04-07 | Add infrastructure to handle more than one ccb. | Christopher Pascoe |
| 2007-04-07 | Correct offset for global interrupt status register. | Christopher Pascoe |
| 2007-04-07 | this diff covers two changes, but theyre very tightly tied together. | David Gwynne |
| 2007-04-07 | sizeofa will give us the number of elements in an array. use it when | David Gwynne |
| 2007-04-06 | Correct order of bus_space_barrier() parameters. | Jonathan Gray |
| 2007-04-06 | white space fix | David Gwynne |
| 2007-04-06 | copy the dmamem wrapper into sili for use for allocating hba memory. this | David Gwynne |
| 2007-04-05 | After been attacked by Michael Buesch <mb@bu3sch.de> because we initially | Marcus Glocker |
| 2007-04-05 | this is a relatively big commit that implements a basic io path. | David Gwynne |
| 2007-04-05 | finish resetting the device by sending a soft reset via the post_direct | David Gwynne |
| 2007-04-05 | sili_post_direct lets you submit a prb without all the goop of a ccb and | David Gwynne |
| 2007-04-05 | rearrange the busywait funcs slightly | David Gwynne |
| 2007-04-05 | DPRINTF will be useful soon, so stick it in | David Gwynne |
| 2007-04-05 | control bits in the prb. shuffle things around a bit... | David Gwynne |
| 2007-04-05 | start defining the scatter/gather bits and the port request blocks (PRBs). | David Gwynne |
| 2007-04-04 | Activate interference mitigation. | Marcus Glocker |
| 2007-04-04 | Debugging. Fix a lot wrong registers. Fix a couple of /* XXX */ and | Marcus Glocker |
| 2007-04-04 | implement sili_pwait_{ne,eq} for busy waiting on register values. | David Gwynne |
