summaryrefslogtreecommitdiff
path: root/sys/dev/ic
AgeCommit message (Expand)Author
2007-05-02Eliminate unused inline functions and replace ahc_lock() whichKenneth R Westerback
2007-04-28missing splbio/splx pair (which splasserted me per-device probe) inTheo de Raadt
2007-04-28remove abstraction around splbio/splx; they just confuse things; ok dlg marco...Theo de Raadt
2007-04-26Improve debug statements. No binary change without AMI_DEBUG.Alexander Bluhm
2007-04-23Kill inlines to shave some bytes.Artur Grabowski
2007-04-22disable debug output here too. it's working fine (even on strange archs)David Gwynne
2007-04-20Increase the delay while uploading a firmware buffer in malo_load_firmware().Claudio Jeker
2007-04-19Cleanup phy selection code, simplifying the code considerably. Attach onlyMark Kettenis
2007-04-19make it compile again if LMDEBUG is defined;Robert Nagy
2007-04-17The debug printf in malo_newstate() is too verbose so require debug level 2Claudio Jeker
2007-04-16During the drives detection only check the status register to be notAlexander Yurchenko
2007-04-13scsi_generic is now 16 bytes. Adjust padding so struct is stillKenneth R Westerback
2007-04-13scsi_generic is now 16 bytes. Adjust offsets into structure beingKenneth R Westerback
2007-04-13The integrated Atheros NICs found in IBM/Lenovo ThinkPads use the sameReyk Floeter
2007-04-12Oops, a code rearrangement meant that I didn't initialise the failed ccbChristopher Pascoe
2007-04-11Remove debug leftovers to make console output quite again in hostap mode.Marcus Glocker
2007-04-11Cleanup makros even more. Remove unused ones and reduce the amount ofClaudio Jeker
2007-04-11As probe response mgmt frames are already handled by the firmware, ignoreMarcus Glocker
2007-04-10``it's'' -> ``its'' when the grammar gods require this change.Miod Vallat
2007-04-10wrap reading of the error fis up into a func of its own, and useDavid Gwynne
2007-04-08Change the API to sili_port_intr so it can timeout a command and reuse theChristopher Pascoe
2007-04-08Add support for NCQ error recovery and enable NCQ command submission.Christopher Pascoe
2007-04-08Track the order that CCBs are submitted in, so that after an error we areChristopher Pascoe
2007-04-08sili uses one queue for NCQ and legacy commands. No need for the AHCI-styleChristopher Pascoe
2007-04-07Always assume write commands had zero residual; the chip only countsChristopher Pascoe
2007-04-07Whitespace cleanup. No code change.Christopher Pascoe
2007-04-07Add transfer failure detection and recovery from non-fatal errors.Christopher Pascoe
2007-04-07Rework command issue/completion flow to be more like AHCI's and switch toChristopher Pascoe
2007-04-07Split command completion out into a separate function, working towardsChristopher Pascoe
2007-04-07Permit PACKET command issue.Christopher Pascoe
2007-04-07Fill out control information for ATAPI commands.Christopher Pascoe
2007-04-07Helper macros to provide the port name in debug messages.Christopher Pascoe
2007-04-07Use the rx_count saved in the LRAM command slot entry to determine theChristopher Pascoe
2007-04-07Add some more device status related register definitions.Christopher Pascoe
2007-04-07Sync the command corresponding to our ccb, not slot 0.Christopher Pascoe
2007-04-07Add infrastructure to handle more than one ccb.Christopher Pascoe
2007-04-07Correct offset for global interrupt status register.Christopher Pascoe
2007-04-07this diff covers two changes, but theyre very tightly tied together.David Gwynne
2007-04-07sizeofa will give us the number of elements in an array. use it whenDavid Gwynne
2007-04-06Correct order of bus_space_barrier() parameters.Jonathan Gray
2007-04-06white space fixDavid Gwynne
2007-04-06copy the dmamem wrapper into sili for use for allocating hba memory. thisDavid Gwynne
2007-04-05After been attacked by Michael Buesch <mb@bu3sch.de> because we initiallyMarcus Glocker
2007-04-05this is a relatively big commit that implements a basic io path.David Gwynne
2007-04-05finish resetting the device by sending a soft reset via the post_directDavid Gwynne
2007-04-05sili_post_direct lets you submit a prb without all the goop of a ccb andDavid Gwynne
2007-04-05rearrange the busywait funcs slightlyDavid Gwynne
2007-04-05DPRINTF will be useful soon, so stick it inDavid Gwynne
2007-04-05control bits in the prb. shuffle things around a bit...David Gwynne
2007-04-05start defining the scatter/gather bits and the port request blocks (PRBs).David Gwynne
generated by cgit v1.2.3 (git 2.25.1) at 2025-01-07 09:23:15 +0000