summaryrefslogtreecommitdiff
path: root/sys/dev/pci
AgeCommit message (Expand)Author
2006-09-18g/c unused SK_{SET,CLR}BIT macrosBrad Smith
2006-09-18regenBrad Smith
2006-09-18add entries for unknown Marvell SATA and ServerWorks IDE PCI ids.Brad Smith
2006-09-18regenBrad Smith
2006-09-18- fix typo in Corollary vendor nameBrad Smith
2006-09-17add a flag to indicate which boards are only capable of 10/100 modes ofBrad Smith
2006-09-17Readd the Dell PHY LED setup workaround and the Jumbo capability flag.Brad Smith
2006-09-17Try to reclaim the TX descriptors in the watchdog handler before actuallyBrad Smith
2006-09-17Overhaul RX path to recover from mbuf cluster allocation failure.Brad Smith
2006-09-17revert revision 1.131, the code in question was later found to not ensureBrad Smith
2006-09-17- correct the firmware synchronization in bge_reset(), thisBrad Smith
2006-09-17defer establishing the interrupt until later during attach, to let theBrad Smith
2006-09-16Get subvendor from the PROM instead of the PCI configuration space, since theMark Kettenis
2006-09-16Bring pgt(4) in a working state. Much work also done by claudio@.Marcus Glocker
2006-09-16Asking for HWERR interrupts and not acknowledging them leadsJonathan Gray
2006-09-16Support for Intel 6321ESB SATA. Tested on one of cloder's newJonathan Gray
2006-09-16Match VIA VT8237A SATA which while untested should act likeJonathan Gray
2006-09-16regenJonathan Gray
2006-09-16VIA VT8237A SATAJonathan Gray
2006-08-31Do proper chipset identification.Marcus Glocker
2006-08-31Get firmware loaded.Marcus Glocker
2006-08-30Try to read station address from the chip first, then try the EEPROM (if weMark Kettenis
2006-08-29Add support for onboard bge(4)'s on Sun UltraSPARC hardware that apparentlyMark Kettenis
2006-08-28Completely rework the allocation/management of Rx buffers.Damien Bergamini
2006-08-28Move DMA mapping code from if_pgt_pci.c to pgt.c and port it as is for now.Marcus Glocker
2006-08-28Get MAC address from the OpenFirmware local-mac-address property on sparc64.Mark Kettenis
2006-08-28move the firmware messaging under NBIO since it's only used by bio.David Gwynne
2006-08-28revert flags usage commits. too close to release. will go in post release ins...Brad Smith
2006-08-28add a BGE_JUMBO flag.Brad Smith
2006-08-28turns out the volume info contains a bitmap of failed physdisks in it, soDavid Gwynne
2006-08-28Dell PCI vendor subid.Brad Smith
2006-08-28Set the BGE_NO3LED flag to properly adjust the PHY LED mode if attachingBrad Smith
2006-08-27it works a little better like this.Brad Smith
2006-08-27pack several boolean fields into the existing bge_flags field.Brad Smith
2006-08-27sigh, this is annoying. it appears that the arc firmware doesnt care if aDavid Gwynne
2006-08-27try to get the status of the volume out of the arc firmware and intoDavid Gwynne
2006-08-27if a disk dissapears out of a raidset, then the raid info will list its idDavid Gwynne
2006-08-27little nitDavid Gwynne
2006-08-25update for the Triware to 3ware renaming and use pci_matchbyid().Brad Smith
2006-08-25regenBrad Smith
2006-08-25- rename TRIWARE to 3WAREBrad Smith
2006-08-25Disable interrupts during the attach of UHCI and EHCI controllers. IfChristopher Pascoe
2006-08-25fill in the controllers name in the inq ioctl. spotted by deraadt@David Gwynne
2006-08-25don't need to clear if_timer during attach.Brad Smith
2006-08-25only write to the RMAC_CFG_KEY register for the Xframe chipset.Brad Smith
2006-08-25Allow the driver to compile with MSK_DEBUG.Brad Smith
2006-08-24Add some first PCI glue.Marcus Glocker
2006-08-24show the firmware revision of the disks.David Gwynne
2006-08-24report the size of the disks and volumes correctly.David Gwynne
2006-08-24too much copy and paste. report raid 1 correctly.David Gwynne