| Age | Commit message (Expand) | Author |
|---|
| 2006-03-05 | Sprinkle some tabs and a little cleaning. | Brad Smith |
| 2006-03-05 | tabs are holier than spaces. | Brad Smith |
| 2006-03-04 | don't set the interface pointer twice in tl_init(). | Brad Smith |
| 2006-03-04 | Typos grab bag of the month, eyeballed by jmc@ | Miod Vallat |
| 2006-03-04 | add PCI sub-ids for ACER, FSC, Intel and NEC products. | Brad Smith |
| 2006-03-04 | remove the colon between "address" and the MAC address. | Brad Smith |
| 2006-03-04 | - Use sc->sc_dev.dv_xname everywhere. | Brad Smith |
| 2006-03-02 | Put the PHY update/reset call in nfe_init back to the spot it was at | Jonathan Gray |
| 2006-02-27 | Increase delay value, fixes pr5018. | Alexander Yurchenko |
| 2006-02-27 | Workaround for bridge attachment where nothing lives behind these 'rare' | Dale Rahn |
| 2006-02-26 | Disable alipm(4) on sparc64 if not running at the recommended 74KHz clock, to | Mark Kettenis |
| 2006-02-26 | use sc->sc_dev.dv_xname consistently. | Damien Bergamini |
| 2006-02-26 | prettify + u_int{8,16,32}_t -> uint{8,16,32}_t | Damien Bergamini |
| 2006-02-26 | regen | Brad Smith |
| 2006-02-26 | fix some of the ATI names. | Brad Smith |
| 2006-02-26 | Let if_nfe.c compile again by putting declaration of ifp inside #ifdef | Kenneth R Westerback |
| 2006-02-26 | Don't define NFE_DEBUG by default. | Jonathan Gray |
| 2006-02-26 | clean up if there is a failure to attach. | Brad Smith |
| 2006-02-26 | store the shutdown hook pointer in the softc struct. | Brad Smith |
| 2006-02-26 | vic(4) is PCI only so make it look like a typical PCI only driver. | Brad Smith |
| 2006-02-26 | - set baud rate in ixgb_update_link_status(). | Brad Smith |
| 2006-02-25 | add vic(4) config glue. The driver is not yet enabled. | Reyk Floeter |
| 2006-02-25 | Add vic(4), a driver for the VMware vmxnet network interface. This is | Reyk Floeter |
| 2006-02-25 | sync | Damien Bergamini |
| 2006-02-25 | ids for intel pro/wireless 3945ABG | Damien Bergamini |
| 2006-02-24 | Make ServerWorks SATA less chatty. Sprinkle some KNF while I'm there. | Mark Kettenis |
| 2006-02-24 | update link status here. | Brad Smith |
| 2006-02-24 | check for M_PKTHDR. | Brad Smith |
| 2006-02-24 | regen | Brad Smith |
| 2006-02-24 | add the Envy24 I/O Ctrlr | Brad Smith |
| 2006-02-24 | regen | Brad Smith |
| 2006-02-24 | add IC Ensemble and the Envy24 Audio controller | Brad Smith |
| 2006-02-24 | regen | Brad Smith |
| 2006-02-24 | fix the order | Brad Smith |
| 2006-02-24 | regen | Brad Smith |
| 2006-02-24 | add a PCI id for Dell PERC 4e/Di and 4e/Si adapters. | Brad Smith |
| 2006-02-24 | clear the powerdown mode that Windows will put bce chips into | Brad Smith |
| 2006-02-24 | add TTTech MC322 | Brad Smith |
| 2006-02-24 | use some define's for the PCI ids and add another ICP Vortex PCI id. | Brad Smith |
| 2006-02-23 | regen | Brad Smith |
| 2006-02-23 | add another ICP Vortex PCI id. | Brad Smith |
| 2006-02-22 | fix nfe_txeof() to reset the wathdog timeout only when a full tx frame | Damien Bergamini |
| 2006-02-22 | re-enable interrupt mitigation and mask out NFE_IRQ_TIMER that was causing | Damien Bergamini |
| 2006-02-22 | IBM makes a pcn card that shows up as: | Brad Smith |
| 2006-02-22 | For 82544 and newer chips increase the number of TX descriptors to 512. | Brad Smith |
| 2006-02-22 | regen | Brad Smith |
| 2006-02-22 | update the media settings after MAC setup. | Brad Smith |
| 2006-02-21 | disable interrupt mitigation until i figure out why we're spending 10% of | Damien Bergamini |
| 2006-02-21 | - Overhaul link state detection code. | Brad Smith |
| 2006-02-20 | - remove mbuf linearization code. it is broken in this context and it is very | Damien Bergamini |
