| Age | Commit message (Expand) | Author |
|---|
| 2006-09-17 | revert revision 1.131, the code in question was later found to not ensure | Brad Smith |
| 2006-09-17 | - correct the firmware synchronization in bge_reset(), this | Brad Smith |
| 2006-09-17 | defer establishing the interrupt until later during attach, to let the | Brad Smith |
| 2006-09-16 | Get subvendor from the PROM instead of the PCI configuration space, since the | Mark Kettenis |
| 2006-09-16 | Bring pgt(4) in a working state. Much work also done by claudio@. | Marcus Glocker |
| 2006-09-16 | Asking for HWERR interrupts and not acknowledging them leads | Jonathan Gray |
| 2006-09-16 | Support for Intel 6321ESB SATA. Tested on one of cloder's new | Jonathan Gray |
| 2006-09-16 | Match VIA VT8237A SATA which while untested should act like | Jonathan Gray |
| 2006-09-16 | regen | Jonathan Gray |
| 2006-09-16 | VIA VT8237A SATA | Jonathan Gray |
| 2006-08-31 | Do proper chipset identification. | Marcus Glocker |
| 2006-08-31 | Get firmware loaded. | Marcus Glocker |
| 2006-08-30 | Try to read station address from the chip first, then try the EEPROM (if we | Mark Kettenis |
| 2006-08-29 | Add support for onboard bge(4)'s on Sun UltraSPARC hardware that apparently | Mark Kettenis |
| 2006-08-28 | Completely rework the allocation/management of Rx buffers. | Damien Bergamini |
| 2006-08-28 | Move DMA mapping code from if_pgt_pci.c to pgt.c and port it as is for now. | Marcus Glocker |
| 2006-08-28 | Get MAC address from the OpenFirmware local-mac-address property on sparc64. | Mark Kettenis |
| 2006-08-28 | move the firmware messaging under NBIO since it's only used by bio. | David Gwynne |
| 2006-08-28 | revert flags usage commits. too close to release. will go in post release ins... | Brad Smith |
| 2006-08-28 | add a BGE_JUMBO flag. | Brad Smith |
| 2006-08-28 | turns out the volume info contains a bitmap of failed physdisks in it, so | David Gwynne |
| 2006-08-28 | Dell PCI vendor subid. | Brad Smith |
| 2006-08-28 | Set the BGE_NO3LED flag to properly adjust the PHY LED mode if attaching | Brad Smith |
| 2006-08-27 | it works a little better like this. | Brad Smith |
| 2006-08-27 | pack several boolean fields into the existing bge_flags field. | Brad Smith |
| 2006-08-27 | sigh, this is annoying. it appears that the arc firmware doesnt care if a | David Gwynne |
| 2006-08-27 | try to get the status of the volume out of the arc firmware and into | David Gwynne |
| 2006-08-27 | if a disk dissapears out of a raidset, then the raid info will list its id | David Gwynne |
| 2006-08-27 | little nit | David Gwynne |
| 2006-08-25 | update for the Triware to 3ware renaming and use pci_matchbyid(). | Brad Smith |
| 2006-08-25 | regen | Brad Smith |
| 2006-08-25 | - rename TRIWARE to 3WARE | Brad Smith |
| 2006-08-25 | Disable interrupts during the attach of UHCI and EHCI controllers. If | Christopher Pascoe |
| 2006-08-25 | fill in the controllers name in the inq ioctl. spotted by deraadt@ | David Gwynne |
| 2006-08-25 | don't need to clear if_timer during attach. | Brad Smith |
| 2006-08-25 | only write to the RMAC_CFG_KEY register for the Xframe chipset. | Brad Smith |
| 2006-08-25 | Allow the driver to compile with MSK_DEBUG. | Brad Smith |
| 2006-08-24 | Add some first PCI glue. | Marcus Glocker |
| 2006-08-24 | show the firmware revision of the disks. | David Gwynne |
| 2006-08-24 | report the size of the disks and volumes correctly. | David Gwynne |
| 2006-08-24 | too much copy and paste. report raid 1 correctly. | David Gwynne |
| 2006-08-24 | ignore passthru volumes, struct bioc_vol isnt smart enough to know what | David Gwynne |
| 2006-08-24 | figure out the raid level of the volume. | David Gwynne |
| 2006-08-24 | oops, im unlocking too often | David Gwynne |
| 2006-08-24 | a start at the BIOC INQ, VOL, and DISK ioctls for fetching information | David Gwynne |
| 2006-08-24 | regen | Gordon Willem Klok |
| 2006-08-24 | Add vendor "miro computer products AG" and device MiroVIEDO DC20 plus | Gordon Willem Klok |
| 2006-08-23 | regen | Brad Smith |
| 2006-08-23 | add SiS 191 Gig Ethernet PCI id. | Brad Smith |
| 2006-08-22 | use LIST_FOREACH; from FreeBSD | Martin Reindl |
