| Age | Commit message (Collapse) | Author |
|---|
|
|
|
This changes numbers of the SIOCSIFMEDIA and SIOCGIFMEDIA ioctls and
grows struct ifmediareq.
Old ifconfig and dhclient binaries can still assign addresses, however
the 'media' subcommand stops working. Recompiling ifconfig and dhclient
with new headers before a reboot should not be necessary unless in very
special circumstances where non-default media settings must be used to
get link and console access is not available.
There may be some MD fallout but that will be cleared up later.
ok deraadt miod
with help and suggestions from several sharks attending l2k15
|
|
initializing variables before they get used.
|
|
ok bluhm@, claudio@, dlg@
|
|
Note that pseudo-drivers not using if_input() are not affected by this
conversion.
ok mikeb@, kettenis@, claudio@, dlg@
|
|
|
|
ok krw@ miod@
|
|
not available to programs anyway.
|
|
the kernel_lock), as we already do better conversions in
user-mode. Yet, no need for every single driver to fiddle with the
conversion code as they are done transparently by common MI code. With
help from armani and miod, support from mpi
ok armani@
|
|
|
|
- rename uiomove() to uiomovei() and update all its users.
- introduce uiomove(), which is similar to uiomovei() but with a size_t.
- rewrite uiomovei() as an uiomove() wrapper.
ok kettenis@
|
|
|
|
|
|
after discussions with beck deraadt kettenis.
|
|
|
|
|
|
one copy when both isp(4) and qla(4) are enabled. This is a temporary
measure until qla(4) takes over completely.
looked at by miod@ and kettenis@
|
|
|
|
|
|
scsi_adapter struct, just do it once in the chip code.
ok krw@
|
|
resurrection of the bad idiom in the tree.
sufficient review by miod, kettenis, tedu
|
|
entries to decide if the IFF_ALLMULTI flag should be set, check if there
is at least one real range between them.
This should not change the behavior of any driver but if you encounter
any problem, feel free to revert the offending chunk and ping me about
it.
ok naddy@, dlg@
|
|
|
|
ok matthew guenther mikeb
|
|
No functional change.
|
|
ok miod@
|
|
- the am7990_get() - now lance_get() - is unchanged.
- the interrupt acknowledge logic is unchanged, and will disable interrupts,
then acknowledge all interrupt conditions.
Add ILACC (79900) support (from NetBSD).
Both LANCE (am7990.c) and ILACC (am79900.c) code share as much common code
(lance.c) as possible. This affects all le(4) attachments, but the changes
are mostly mechanical, to split am7990-specific parts from lance-agnostic
parts.
Compile tested on all affected platforms. Tested on alpha, hp300, luna88k,
mvme88k, sparc, sparc64 and vax.
|
|
don't have to. Just remove these include lines.
Compiled on amd64 i386 sparc64; OK henning@ mikeb@
|
|
operations only if device is console
ok kettenis
|
|
autonegotiation timer when PHY gets the link so that if we
restart the timer the mii_ticks value would be sane.
Lifted originally from FreeBSD, tested by a few on re(4) and
bge(4), ok kettenis
|
|
structures (including sound-card registers) from concurent
access by syscall and interrupt code-paths. Since critical
sections remain the same, calls to splraise/spllower can be
safely replaced by calls to mtx_enter/mtx_leave with two
exceptions: (1) mutexes are not reentrant (the inner splraise
is thus removed), and (2) we're not allowed to sleep with a
mutex (either msleep is used or the mutex is released before
sleeping).
ok and help from kettenis, a lot of work from armani
|
|
ok guenther millert kettenis
|
|
to appease dhcpd, as dhcpd has now been fixed to not require this.
repeated prodding and special ok deraadt@
|
|
ifm_status, for dhclient's sake. Current dhclient interface_status()
considers interfaces able to report media information but not returning
IFM_AVALID as down. Note that these interfaces usually have mii(4) or
have specific code reporting correct values; sparc le(4) is an exception.
Found the hard way by sebastia@; joint work with krw@, ok deraadt@
|
|
|
|
not make these drivers spew millions of lines of output.
ok krw
|
|
"reads OK" claudio@
|
|
for both structs, the new members are 'bps' and 'msb', which
describe the number of bytes per sample and data alignment in the
sample, respectively. drivers must properly set these fields in
the 'query_encoding', 'set_parameters' and 'get_default_params'
hardware interface methods.
discussed with ratchov, deraadt
|
|
ok deraadt matthew millert
|
|
step in elminating 'struct scsi_device' entirely.
Spotted and initial diff from matthew@.
ok matthew@ dlg@ deraadt@ marco@ miod@
|
|
max-baud-rate hint. Adjust TTYHOG (the nearly full logic) to this new
situation. The larger buffers are required by the very high speed
KDDI devices in Japan (CF com, or USB ucom) so those are the only two
drivers which currently ask for a larger buffer size.
ok yasuoka miod
|
|
a process instead of using curproc. ok deraadt
|
|
supported it doesn't do any harm), so put the KNOTE() in selwakeup() itself and
remove it from any occurences where both are used, except one for kqueue itself
and one in sys_pipe.c (where the selwakeup is under a PIPE_SEL flag).
Based on a diff from tedu.
ok deraadt
|
|
miod@ deraadt@ ok.
|
|
calls can go directly into selwakeup() safely
long discussion with nicm, murmers of consent from tedu and miod, noone
else seems to care of kqueue is busted as long as it makes their sockets
move data fast... pretty sad.
|
|
return zero on success and nonzero on failure.
This commit only performs mechanical changes for the existing emulops to
always return zero.
|
|
tree, and s/NetBSD/OpenBSD/ in a debug printf.
|
|
work. Tested by deraadt@.
|
|
but it is an important first step.
|
|
Not tested on sparc64 yet.
|
