Age | Commit message (Collapse) | Author | |
---|---|---|---|
2007-10-10 | Rework the debug dmesg to perform a more complete codec dump. | Deanna Phillips | |
Tested by jmc, ckuethe, kettenis and jakemsr. | |||
2007-10-10 | sync | Theo de Raadt | |
2007-10-10 | shortening | Theo de Raadt | |
2007-10-10 | sync | Theo de Raadt | |
2007-10-10 | oops | Theo de Raadt | |
2007-10-10 | sync | Theo de Raadt | |
2007-10-10 | apple products; from dunceor | Theo de Raadt | |
2007-10-10 | regen | David Gwynne | |
2007-10-10 | add the pci product id for the Mellanox ConnectX EN adapters. | David Gwynne | |
2007-10-10 | regen | David Gwynne | |
2007-10-10 | add the mellanox vendor id | David Gwynne | |
2007-10-09 | malloc+bzero -> malloc+M_ZERO. Use 'malloc(sizeof(*p) ...' idiom. | Kenneth R Westerback | |
2007-10-09 | malloc+memset(,0,) -> malloc+M_ZERO. 'Fixes' not zeroing of all | Kenneth R Westerback | |
allocated memory, as I can't see an obvious initialization of the memory elsewhere. NetBSD uses M_ZERO here. | |||
2007-10-09 | Ops, forgot debug printf. | Marcus Glocker | |
2007-10-09 | Setup channels with OFDM flags. Permit user to set fix rates. | Marcus Glocker | |
2007-10-09 | MALLOC -> malloc | Gilles Chehade | |
ok krw@ | |||
2007-10-09 | we have been knocking out i2c when ipmi exists on a machine (because | Theo de Raadt | |
there are ipmi bmc's that apparently violate i2c bus master locking). but those problems bite us only for sensors which we re-scan every few seconds, and then we hit the ipmi bmc's races. for non-sensor devices (like spdmem) it is probably ok to look once. let's try that method for a while and see if anyone sees breakage. | |||
2007-10-09 | Load the firmware files just one time per device lifecycle (attach time) | Marcus Glocker | |
instead on every `ifconfig up'. | |||
2007-10-09 | Use %zu for printing size_t values. | Ray Lai | |
OK dlg. | |||
2007-10-08 | Give the device a bit time to finish the reset when stopped. Avoids | Marcus Glocker | |
helper firmware load timeouts when device is brought up very fast again, like seen with trunk(4). | |||
2007-10-08 | Make pcmcia malo(4) work with trunk(4) by: | Marcus Glocker | |
Setting interface ethernet address from link level address. Adding firmware command to set ethernet address. | |||
2007-10-08 | GPS170 -> GPS170PCI | Marc Balmer | |
ok claudio | |||
2007-10-08 | regen | Marc Balmer | |
2007-10-08 | GPS170 -> GPS170PCI | Marc Balmer | |
ok claudio | |||
2007-10-08 | Print registered/CAS latency information for SDRAM. | Jonathan Gray | |
2007-10-08 | To identity PC133 we need to check cycle time as modules | Jonathan Gray | |
often identify as PC100. | |||
2007-10-08 | Correct frequency for SDRAM. | Jonathan Gray | |
2007-10-08 | More simple memset(,0,) -> M_ZERO changes. In this batch move to | Kenneth R Westerback | |
size(*p) as the first malloc() parameter where p is declared locally and thus easy to check. Add M_ZERO to gpe_table allocation in acpi.c even though there is no obvious bzero or memset nearby. | |||
2007-10-08 | Don't skip EEPROMs in ofw i2c scan, | Jonathan Gray | |
match on sparc64 SPD name in spdmem. Tested on a V120. ok deraadt@ | |||
2007-10-08 | attach uslcom to the track systems traqmate | joshua stein | |
ok jsg | |||
2007-10-08 | support 230400 speed | joshua stein | |
ok jsg | |||
2007-10-08 | Indicate if the module is registered, DDR/DDR2 only at the moment. | Jonathan Gray | |
Tested by ian@ wilfried@ and deraadt@ | |||
2007-10-07 | regen | joshua stein | |
2007-10-07 | track systems traqmate gps data acquisition system | joshua stein | |
2007-10-07 | Add a driver, amdpcib(4), for the AMD 8111 series LPC bridge and HPET written | Marc Balmer | |
by mickey, man page by me. Help, suggestions by Theo and jmc. Enable this driver and glxpcib(4) in all RAMDISK kernel, but glxpcib(4) does not provide the watchdog timer in the RAMDISK kernels. Prodded by deraadt. E | |||
2007-10-07 | Print CAS latency for DDR/DDR2. | Jonathan Gray | |
Shuffle strings around to look pretty as suggested by deraadt. | |||
2007-10-07 | Port of Nicolas Joly, Paul Goyette & Tobias Nygren's | Jonathan Gray | |
spdmem(4) driver for Serial Presence Detect memory information. | |||
2007-10-07 | add support for scanning the spdmem range of addresses, using a different | Theo de Raadt | |
probe function; based on earlier work by jsg, and retested by us | |||
2007-10-06 | Simpliest memset(,0,) -> M_ZERO changes. One (caddr *) cast removal, | Kenneth R Westerback | |
otherwise just adding M_ZERO to malloc() and removing the immediately adjacent memset(,0,). | |||
2007-10-06 | Another NPBFILTER comment typo. | Jonathan Gray | |
From Jung <moorang@gmail.com> | |||
2007-10-06 | NPBFILTER -> NBPFILTER in comments. | Jonathan Gray | |
ok kettenis@ | |||
2007-10-06 | Oops, committed this with a typo, which made it do not quite the right thing. | Mark Kettenis | |
2007-10-06 | Rename bus_space macros. ISA_GET/PUT -> CSR_READ/WRITE | Brad Smith | |
Tested by todd@ ok dlg@ | |||
2007-10-06 | Oops. Forgot to do FREE -> free when I did MALLOC -> malloc. | Kenneth R Westerback | |
2007-10-05 | gilles missed one of the __attribute__((__packed__)) here in | Jonathan Gray | |
the __attribute__((__packed__)) -> __packed conversion. | |||
2007-10-05 | Disable fiber/copper auto-selection on the 88E1111 if it is in RGMII mode, to | Mark Kettenis | |
work around the fact that the onboard PHYs attached to nfe(4) on the Sun X4100 M2 have fiber/copper auto-selection enabled even though the interfaces are clearly copper-only. Fixes PR system/5587. ok jsg@, claudio@ | |||
2007-10-05 | The Acer TravelMate 3010 (ALC883) has a couple of gpio pins that need | Deanna Phillips | |
to be enabled in order for it to produce sound. It can use the same gpio function as the macs, so rename that to azalia_gpio_unmute. Tested by damien@, no regressions noticed by jakemsr@ | |||
2007-10-04 | attribute packed -> __packed | Gilles Chehade | |
ok miod@ a while ago, ok pyr@ | |||
2007-10-04 | attribute packed -> __packed | Gilles Chehade | |
okayd by miod a while ago, ok by pyr | |||
2007-10-04 | Import the bwi single firmware-file builder / extractor before we forget | Marcus Glocker | |
about it. It's not linked into microcode/Makefile. OK deraadt@ |