| Age | Commit message (Expand) | Author |
|---|
| 2010-02-07 | cleanup run_rt3070_set_chan | Damien Bergamini |
| 2010-02-07 | add a function to set the channel on RT3572. | Damien Bergamini |
| 2010-02-07 | when calibrating filter, use better target values for >=RT3071 | Damien Bergamini |
| 2010-02-07 | read vendor RF settings for >=RT3572 and tx mixer gains for >=RT3070 | Damien Bergamini |
| 2010-02-07 | add a new function to set the AGC since the code is a bit different | Damien Bergamini |
| 2010-02-07 | use new mcu command to select the antenna on RT2020 | Damien Bergamini |
| 2010-02-07 | split 32-bit mac_rev into 16-bit mac_ver and mac_rev to avoid | Damien Bergamini |
| 2010-02-07 | add rf init values for rt3572 | Damien Bergamini |
| 2010-02-07 | update firmware for rt2870 and >=rt3071 | Damien Bergamini |
| 2010-02-07 | add channels 167, 169, 171, 173 for dual-band devices | Damien Bergamini |
| 2010-02-05 | regen | Miod Vallat |
| 2010-02-05 | Add SiliconMotion Voyager GX, reportedly found in Gdium Liberty. | Miod Vallat |
| 2010-02-05 | regen | Jasper Lievisse Adriaanse |
| 2010-02-05 | - fix doubles | Jasper Lievisse Adriaanse |
| 2010-02-05 | regen | Jasper Lievisse Adriaanse |
| 2010-02-05 | - add few new devices found in dmesglog | Jasper Lievisse Adriaanse |
| 2010-02-04 | Added optimization for XY reads, requires only one temp buffer | Jordan Hargrave |
| 2010-02-04 | Optimized failure handing for Read with X/P failures | Jordan Hargrave |
| 2010-02-03 | init ofdm sensitivity with min value (which depends on the chip) | Damien Bergamini |
| 2010-02-03 | Enable the next page bit for IP1001, otherwise the PHY fails | Stuart Henderson |
| 2010-02-03 | Use nitems. | Joel Sing |
| 2010-02-02 | Attach athn(4) to the AR2427 which is a castrated (no 11n) AR928X. | Damien Bergamini |
| 2010-02-02 | regen | Damien Bergamini |
| 2010-02-02 | add AR2427 pci id | Damien Bergamini |
| 2010-02-02 | Fix for the Intel WiFi Link 1000. | Damien Bergamini |
| 2010-02-01 | regen | Damien Bergamini |
| 2010-02-01 | change descriptions for WiFi Link 6000 series | Damien Bergamini |
| 2010-02-01 | unmute GPIO 0 on IDT 92HD73C1 codecs found in Dell machines | Jacob Meuser |
| 2010-01-30 | Build these firmwares on loongson. | Miod Vallat |
| 2010-01-28 | set differential gains on 6250 too (but use a 1.0 factor, not 1.5). | Damien Bergamini |
| 2010-01-27 | change the MRR pattern from 1/1/1/1 to 2/2/2/4 | Damien Bergamini |
| 2010-01-27 | - regen | Jasper Lievisse Adriaanse |
| 2010-01-27 | - add a bunch of new ati and nvidia devices | Jasper Lievisse Adriaanse |
| 2010-01-26 | sync | Damien Bergamini |
| 2010-01-26 | new run(4) ids | Damien Bergamini |
| 2010-01-26 | backout last, it causes mem conflicts and device trouble; | Otto Moerbeek |
| 2010-01-23 | finally, 6250 parts need crystal calibration too. | Damien Bergamini |
| 2010-01-22 | Correctly return ENXIO on unhandled ioctls; ok marco@ | Miod Vallat |
| 2010-01-21 | Do not assume mac address and bss id are stored at 32-bit aligned addresses; | Miod Vallat |
| 2010-01-21 | Use ahci_nvidia_mcp_attach() for nvidia MCP79 ("Ion"), without which | Stuart Henderson |
| 2010-01-20 | Fix collider offsets to correct LBA. | Jordan Hargrave |
| 2010-01-20 | Remove horrible hack in ahc/ahd that made some commands retry | Kenneth R Westerback |
| 2010-01-19 | IP checksum is still broken with fragments, turn it off for now. | Reyk Floeter |
| 2010-01-16 | rename bluetooth coexistence flags. no binary change. | Damien Bergamini |
| 2010-01-16 | Enable DC calibration and disable crystal calibration on | Damien Bergamini |
| 2010-01-15 | sync | Igor Sobrado |
| 2010-01-15 | add `Logitech Webcam C200' to the list of supported uvideo(4) devices. | Igor Sobrado |
| 2010-01-14 | SiS devices seem unable to reset dma block index to zero, causing | Alexandre Ratchov |
| 2010-01-13 | Make sure that acpitz is always the last one to replace the global | Marco Peereboom |
| 2010-01-13 | Fix another long standing double scsi_done() bug. This time when a | Kenneth R Westerback |
