Age | Commit message (Expand) | Author |
2005-12-27 | 3 drivers that mistakenly claim to need gpiobus | Theo de Raadt |
2005-12-27 | more paranoid checking for 47m192 | Theo de Raadt |
2005-12-27 | Enable i2c bus scanning and kill annoying error message. | Alexander Yurchenko |
2005-12-27 | lm(4) at iic(4) | Mark Kettenis |
2005-12-27 | Add support for newer M7101 chips with different PCI config registers layout. | Mark Kettenis |
2005-12-27 | avoid writing back same value; and use symbolic name for config START bit | Theo de Raadt |
2005-12-27 | adm1024 has the same interrupt clearing semantics as a lm87; tested by miod | Theo de Raadt |
2005-12-27 | interrupt clearing applies to lm87 class too (not just lm81 class) | Theo de Raadt |
2005-12-27 | if the device is busy trying to deliver an interrupt, it will stall on | Theo de Raadt |
2005-12-27 | correct adm2940 probe | Theo de Raadt |
2005-12-27 | on lm81 and clones, reflag external sensor as invalid every time through | Theo de Raadt |
2005-12-27 | only start, if not already started | Theo de Raadt |
2005-12-27 | no longer use ia_compat; tested by a few | Theo de Raadt |
2005-12-27 | match about 15 more clone chips | Theo de Raadt |
2005-12-27 | make direct mappings fail for now, since noone will test that for me | Theo de Raadt |
2005-12-27 | the name belongs in "quotes" | Theo de Raadt |
2005-12-27 | if we write to the START bit, splat out a message | Theo de Raadt |
2005-12-27 | completely bogus adm1021 check; it is much more like the xeon-style | Theo de Raadt |
2005-12-26 | Reset i2c bus if operation times out. | Mark Kettenis |
2005-12-26 | split out debug code | Theo de Raadt |
2005-12-26 | add address qualifiers to a few chips (ie. they can only occur at certain | Theo de Raadt |
2005-12-26 | if start is already set, avoid setting it again | Theo de Raadt |
2005-12-26 | if probe falls, iic_print should print the name we attempted to match under | Theo de Raadt |
2005-12-26 | maxim1617 is the same | Theo de Raadt |
2005-12-26 | symbolic names for command start bit | Theo de Raadt |
2005-12-26 | set the "start adc" bit upon startup | Theo de Raadt |
2005-12-25 | regen | Brad Smith |
2005-12-25 | fix ordering | Brad Smith |
2005-12-25 | Force polling during autoconf. | Alexander Yurchenko |
2005-12-25 | Don't allow slave devices to do polling during autoconf. | Alexander Yurchenko |
2005-12-25 | Force polling if interrupts not available. | Alexander Yurchenko |
2005-12-25 | Move all PIIX register definitions to a separate file. | Alexander Yurchenko |
2005-12-25 | Do not make the whole sc_i2c_xfer structure volatile, only the | Alexander Yurchenko |
2005-12-25 | wrong fan2 register | Theo de Raadt |
2005-12-25 | <= instead of < in two loops; spotted by miod | Theo de Raadt |
2005-12-25 | even though some i2c devices have ID and chip registers which we can key | Theo de Raadt |
2005-12-25 | typo | Theo de Raadt |
2005-12-25 | support adm1024, kind of like adm1025 but some voltage pins more around and 2... | Theo de Raadt |
2005-12-25 | Add support for AS99127F, an Asus W83781D clone. | Mark Kettenis |
2005-12-25 | Regen. | Alexander Yurchenko |
2005-12-25 | Consistent device ids for piix pm controllers. | Alexander Yurchenko |
2005-12-25 | rename Xeon sensor, and ignore the other temperature sensor | Theo de Raadt |
2005-12-24 | Driver for Acer Labs M7101 power management controller | Mark Kettenis |
2005-12-24 | Use sensors thread instead of timeouts. | Mark Kettenis |
2005-12-24 | even though the adm1021 manual page doesn't say that the rev at 0xff | Theo de Raadt |
2005-12-24 | bad message | Theo de Raadt |
2005-12-24 | For Xeon sensors, only show one probe | Theo de Raadt |
2005-12-24 | handle embedded xeon temperature probes. yes, you got it -- i2c wires | Theo de Raadt |
2005-12-24 | piixpm now provides i2cbus attribute. Reminded by deraadt@. | Alexander Yurchenko |
2005-12-24 | Rewrite piixpm(4) driver. It doesn't support acpi timer anymore, if we | Alexander Yurchenko |