| Age | Commit message (Collapse) | Author | |
|---|---|---|---|
| 2006-05-11 | Zap trailing whitespace. | Kenneth R Westerback | |
| 2005-08-23 | setting the FAULT flag on a device so the alarm led blinks may have | David Gwynne | |
| unwanted side effects, eg, disabling both fc ports and powering the disk down. so remove this knob for now. ok deraadt@ | |||
| 2005-08-22 | spell: failture->failure | David Krause | |
| 2005-08-18 | Silly dlg did not read my old code careful enough. Missed 2 bits that are | Marco Peereboom | |
| necessary for the blinkenlight magic. Also removed some XXX cruft that was misleading. | |||
| 2005-08-18 | infrastructure to support blinking controlled via /dev/bio ioctls. the | David Gwynne | |
| code to do the actual blink is ifdefed out till marco can figure out what im doing wrong. | |||
| 2005-08-03 | report the state of the power supplies. the value shows if the psu is on | David Gwynne | |
| or off, but sysctl doesnt know how to display it (yet). requested by marco@ | |||
| 2005-08-02 | read the rpm of the fans | David Gwynne | |
| 2005-08-01 | a new scsi enclosure services driver. this and safte replace the old ses | David Gwynne | |
| driver. rather than relying on its own set of tools, ses reports the enclosure status via the hw.sensors sysctl tree. so far only temperature is reported ok marco@ deraadt@ krw@ | |||
| 2005-07-31 | remove the ses driver. it has never been enabled in GENERIC on any arch | David Gwynne | |
| in openbsds lifetime so noone is going to miss it. if you did enable it, it either didnt work or the data was hard to read and usually wrong. ok deraadt@ marco@ | |||
| 2000-02-21 | add SES/SAF-TE SCSI device | mjacob | |
 |
index : src | |
| OpenBSD base system |
| summaryrefslogtreecommitdiff |