| Age | Commit message (Collapse) | Author | |
|---|---|---|---|
| 2005-05-15 | sync | Martin Reindl | |
| 2005-05-15 | Schneider & Koch FDDI adapter | Martin Reindl | |
| ok deraadt@ | |||
| 2005-05-15 | ANSI, mostly from Toni Mueller <openbsd-tech@oeko.net> | Henning Brauer | |
| 2005-05-15 | Speed up the low-level dae helpers. | Miod Vallat | |
| 2005-05-15 | Compile out more code if TRACE_DEBUG is not defined. | Miod Vallat | |
| 2005-05-15 | Disable ddb backtrace debug code by default. | Miod Vallat | |
| 2005-05-15 | KNF and ANSIfy. | Miod Vallat | |
| 2005-05-15 | Partial sync to the NetBSD wscons code, bringing a better wsmux behaviour | Miod Vallat | |
| and bugfixes (the kqueue code, /dev/wsmuxctl and screen border color changes have not been picked), keeping local changes. Tested by many on alpha/cats/hp300/i386/macppc/sparc/sparc64/zaurus if not more. | |||
| 2005-05-15 | Oops. atapiscsi.h is needed because that's where NATAPISCSI is | Kenneth R Westerback | |
| defined. Fixes Y-E DATA USB Floppy Drive that otherwise complains about 'atapiscsi not configured'. Should fix PR #4204 from Ben Hooper. | |||
| 2005-05-14 | Try to ensure that UFI/ATAPI USB umass devices always get the zero | Kenneth R Westerback | |
| padded 12 byte commands mandated by the standard. Adapt the Linux data length twiddling on certain commands. We used to have some of this in a different form, curtesy of csapuntz@, but it got lost in subsequent merges. Fixes the USB card reader of Quentin Barnes who provided much testing and feedback for over a year! Tested by drahn@, ok marco@, 'this is good stuff' deraadt@. | |||
| 2005-05-14 | Match a device_type of scsi-2 as SCSI (as found in a Netra 1405). | Brad Smith | |
| From NetBSD ok miod@ | |||
| 2005-05-14 | - Add IPv6 over GRE. | Brad Smith | |
| - u_short -> u_int16_t - Change default MTU to 1476 (same value that Cisco and other *BSD's use). - Mark gre(4) interfaces as IFT_TUNNEL (Encapsulation interface). From NetBSD - Support setting the MTU Be very careful when upgrading, the change in default MTU might cause problems with an existing OpenBSD <-> OpenBSD setup. Thanks to Stephen Marley <stephen dot marley at catwoman dot cl-is dot com> for some testing. | |||
| 2005-05-14 | Remove bogus #define, no binary difference. | Dale Rahn | |
| 2005-05-14 | Factorize most of the high-level logic for Sun serial keyboards in | Miod Vallat | |
| sys/dev/sun/sunkbd.c, and move the layout tables to sys/dev/sun/sunkbdmap.c. No functional changes, small sparc64 kernel shrinkage. | |||
| 2005-05-14 | don't copy the capinfo field from the ap. forge our own based on what | Damien Bergamini | |
| ieee80211_output.c does. | |||
| 2005-05-14 | Unused after last scsi commit. | Kenneth R Westerback | |
| 2005-05-14 | Add scsi_mode_[sense|select]_big() and use it instead of | Kenneth R Westerback | |
| atapi_mode_[sense|select](). This will allow the removal of atapi_base.c and atapi_all.h files, and sets the stage for better usb mode sense handling amoung other things. Remove cd_scsibus_[get|set]_mode() and sd_scsibus_mode_sense() shims in favour of scsi_mode_[sense|select](). Add zero'ing of reserved length field in scsi_mode_select(). Change some uchar * type parameters to scsi_mode_header *. No functional changes. Mostly from NetBSD. ok dlg@. | |||
| 2005-05-14 | remove redundant definition of PCI_ID_CODE. I added this to the | Brad Smith | |
| MI pcivar.h header 5 months ago. | |||
| 2005-05-13 | /dev/speaker node on cats. | Miod Vallat | |
| 2005-05-13 | Kill <machine/spkr.h>, software should use <dev/isa/spkrio.h> instead. | Miod Vallat | |
| 2005-05-13 | another uftdi varient, from freebsd | Theo de Raadt | |
| 2005-05-13 | should support channel 165 too in 802.11a mode. | Damien Bergamini | |
| 2005-05-13 | not ready for NATM | Theo de Raadt | |
| 2005-05-13 | fix sensitivity setting. | Damien Bergamini | |
| 2005-05-13 | fix dmesg output for pre-firmware modems. | Damien Bergamini | |
| 2005-05-13 | Fix for a panic experienced when authenticating a pppoe session on an amd64 ↵ | Brad Smith | |
| system. From: i4b project via FreeBSD via Jason Ackley Fixes PR 4190 & 4196 ok canacar@ | |||
| 2005-05-13 | override default bbp register values with values stored in eeprom (except | Damien Bergamini | |
| for the R17 register). | |||
| 2005-05-13 | before ieee80211.c rev 1.6, it was guaranted that ic_curmode was different | Damien Bergamini | |
| from IEEE80211_MODE_AUTO if ic_fixed_rate != -1. it is no longer the case. this implements a temporary workaround. the whole rate selection should be rewritten. | |||
| 2005-05-13 | simplify test conditions. ((v & f1) || (v & f2)) <=> (v & (f1 | f2)) in | Damien Bergamini | |
| these particular cases. avoid extra calls to letoh32(). | |||
| 2005-05-13 | make sure all endpoint descriptors have been found during the attachment. | Damien Bergamini | |
| 2005-05-13 | give disassociation a chance when turning the interface down while associated. | Damien Bergamini | |
| avoid usb tx timeouts too. | |||
| 2005-05-13 | recognize 82551's | Brad Smith | |
| 2005-05-13 | Do not invoke hil_process_pendinc() from the interrupt handler if the loop | Miod Vallat | |
| is marked as busy. | |||
| 2005-05-13 | Regen | Miod Vallat | |
| 2005-05-13 | Separate button boxens from keyboards in the HIL device list. | Miod Vallat | |
| hilkbd will still match both, but will neither do the auto-layout dance nor attach as console for button boxens. | |||
| 2005-05-13 | enable spkr by default; ckuethe 4201 | Theo de Raadt | |
| 2005-05-13 | do { } while (0) wrappers on debug printf macros. ok reyk@ | Jonathan Gray | |
| 2005-05-13 | move IFQ_SET_MAXLEN to just above IFQ_SET_READY | Brad Smith | |
| 2005-05-12 | ANSIfy, some KNF and zap a little bit of whitespace. | Niall O'Higgins | |
| No binary changes. ok mickey@ | |||
| 2005-05-12 | sync | Theo de Raadt | |
| 2005-05-12 | airprime and sealevel | Theo de Raadt | |
| 2005-05-12 | Regen | Miod Vallat | |
| 2005-05-12 | Populate \t better in the output, for human readability; no change in the | Miod Vallat | |
| map themselves. | |||
| 2005-05-12 | Add a bzero() after malloc() when allocating component info in ccdinit(). | Niall O'Higgins | |
| This fixes a panic in ccd(4) mirroring where the second component could be wrongly treated as failed, which leads to uvm_fault in write operation. ok mickey@ | |||
| 2005-05-12 | Regen | Miod Vallat | |
| 2005-05-12 | Define a specific map for the Apple portuguese USB keyboards. | Miod Vallat | |
| Based on input from Manuel Pata and Rodolfo Gouveia on tech@. | |||
| 2005-05-12 | Define a keyboard layout variant for Apple international USB keyboards, which | Miod Vallat | |
| sometimes sligthly differ from the canonical layout. | |||
| 2005-05-12 | Minimal terminal line discipline support to stop the boot timeout | Uwe Stuehler | |
| after the first keystroke, as on other platforms. | |||
| 2005-05-11 | Reset IO completion values to 0 to disable completion holdof. This improves | Marco Peereboom | |
| read performance. This will only work with firmwares that are launched post 5/13/2005. Help LSI, ok mickey@ | |||
| 2005-05-11 | no need to include '\n' on a panic(), fix two typos, | Pedro Martelletto | |
| from Leonardo C. Filho <leonardo@fesppr.br>, thanks! | |||
 |
index : src | |
| OpenBSD base system |
| summaryrefslogtreecommitdiff |