src - OpenBSD base system

Age	Commit message (Collapse)	Author
2005-10-01	regen	Brad Smith

2005-10-01	better names for Apple GMAC's.	Brad Smith

2005-10-01	regen	Brad Smith

2005-10-01	add a Broadcom BCM5701 with a Apple vendor id.	Brad Smith
	From Linux tg3 driver
2005-10-01	add Broadcom BCM5421K2	Brad Smith

2005-10-01	regen	Brad Smith

2005-10-01	add the Broadcom BCM5421K2 PHY found in the Apple K2 IC in the G5.	Brad Smith

2005-10-01	oops, the include was just doing fine there	Martin Reindl

2005-10-01	fix some comments and put if_devar.h include where it belongs	Martin Reindl

2005-10-01	simplifiy esp_dafb_have_dreq()	Martin Reindl
	from NetBSD
2005-10-01	load the BCM5401 DSP code for rev 0 and not rev 1.	Brad Smith
	From: Linux sungem_phy driver.
2005-10-01	add Broadcom BCM5462	Brad Smith

2005-10-01	regen	Brad Smith

2005-10-01	add the Broadcom BCM5462 PHY found in the Apple Vesta PHY IC in the iMac G5.	Brad Smith

2005-09-30	Determine the number of attached devices from OF.	Mark Kettenis
	Map enough memory for up to 8 devices. Handle unconnected interrupt lines. ok drahn@
2005-09-30	Configure pci busses on ht too.	Mark Kettenis

2005-09-30	i hate panic messages which do not print the value that was in error	Theo de Raadt

2005-09-30	regen	Mark Kettenis

2005-09-30	s/K2_UATA/K2_ATA/	Mark Kettenis
	ok drahn@
2005-09-30	Add support for K2 GMAC.	Mark Kettenis

2005-09-30	regen	Mark Kettenis

2005-09-30	Fix typo.	Mark Kettenis

2005-09-30	unless AMI_DEBUG is defined, dont compile in if statements that only there	David Gwynne
	to see if we should DPRINTF. this has been bugging me for a while.
2005-09-30	sync the dma mapping for the data buffer in the right direction when	David Gwynne
	sending commands
2005-09-30	spacing	David Gwynne

2005-09-30	remove the dmamap used for iocmds since they were only copied into the	David Gwynne
	mbox, no dma was ever performed on them. store them in the ccb instead.
2005-09-30	revert MAX_KMAPENT hack added just before 3.7 now that	Brad Smith
	a proper fix has been implemented in uvm_mapent_alloc(). ok pedro@
2005-09-30	remove old unused NRL IPv6 code.	Brad Smith
	ok deraadt@
2005-09-30	Make ddb's 'show uvmexp' print information about kmapent, okay deraadt@	Pedro Martelletto

2005-09-30	pretty print	Theo de Raadt

2005-09-30	pretty print	Theo de Raadt

2005-09-30	sync	Theo de Raadt

2005-09-30	nicer names	Theo de Raadt

2005-09-30	Allow fcn 1 to attach (mac-io on G5 tower)	Dale Rahn

2005-09-30	sync	Dale Rahn

2005-09-30	oops, rev.	Dale Rahn

2005-09-29	G5 bridge.	Dale Rahn

2005-09-29	sync	Dale Rahn

2005-09-29	Devices on G5 tower	Dale Rahn

2005-09-29	Avoid i/o's when spoofonly = 1 in readdisklabel(). Same as other DOS	Kenneth R Westerback
	partition archs with an extra bit to avoid i/o for hfs. ok deraadt@
2005-09-29	Sync dirty data when going from read-write to read-only.	Pedro Martelletto
	Verified against FreeBSD, closes PR 4526, okay deraadt@.
2005-09-29	Clean up ht_intr_map() a bit.	Mark Kettenis

2005-09-29	Execute operations in the correct order. From jason@	Marco Peereboom

2005-09-29	Add HyperTransport here too.	Mark Kettenis

2005-09-29	Add driver for HyperTransport as found in G5 Macs.	Mark Kettenis
	ok drahn@
2005-09-29	Improve PowerPC 7447A support.	Mark Kettenis
	ok drahn@
2005-09-29	Add support for Shasta GMAC.	Mark Kettenis
	ok drahn@
2005-09-29	Configure ht if found.	Mark Kettenis
	"there is some stuff here that needs no ok's!" deraadt@
2005-09-29	Add Shasta HyperTransport.	Mark Kettenis
	ok deraadt@
2005-09-29	Add support for the VIA VT1211 watchdog timer, not tested.	Alexander Yurchenko
	If you have a board that really uses this watchdog please give it a try.