| Age | Commit message (Expand) | Author |
|---|
| 2006-05-28 | don't #undef SDMMC_DEBUG | Uwe Stuehler |
| 2006-05-28 | - if the "upa-portid" property doesn't exist, try "portid" (schizo) | Jason Wright |
| 2006-05-28 | sync, enable and move twe(4) out from untested on alpha | Martin Reindl |
| 2006-05-28 | Fix open(2) semantics for ch(4) to not be completely on fresh minty crack: | Bob Beck |
| 2006-05-28 | Support for standard SD host controllers like the Ricoh 5C822, a small | Uwe Stuehler |
| 2006-05-28 | Add PCATCH to tsleep flags when a scsi command is waiting for an opening | Bob Beck |
| 2006-05-28 | make the ISR bits visible so we can poll them in cngetc (w/out cnpollc). | Jason Wright |
| 2006-05-28 | Allow len == 1 in systrace_fname(), so systraced processes can proceed | Pedro Martelletto |
| 2006-05-28 | Actually remove the device id from events. | Michael Knudsen |
| 2006-05-28 | unbrek tree by syncing protoypes to hotplug.c | Henning Brauer |
| 2006-05-28 | remove the dev/isa/isavar.h include, as it is not needed | Felix Kronlage |
| 2006-05-28 | remove sc_ic member from struct com_softc as it is not used anywhere | Felix Kronlage |
| 2006-05-28 | Remove device id from hotplug events. | Michael Knudsen |
| 2006-05-28 | do not print "root on ..." twice for the -a case, also cope with systems | Theo de Raadt |
| 2006-05-28 | Configure network devices at ipl 3, not ipl 1. | Miod Vallat |
| 2006-05-28 | always set if_hardmtu. | Brad Smith |
| 2006-05-28 | Remove dead code; free commit on behalf of dlg@ | Uwe Stuehler |
| 2006-05-28 | Use TEST_READY_RETRIES_TAPE instead of TEST_READY_RETRIES_DEFAULT, | Kenneth R Westerback |
| 2006-05-28 | more fallout from the sensors: Every single ramdisk got broken. | Theo de Raadt |
| 2006-05-28 | Use bit 23 of the device minor to indicate a control mode device. A | Kenneth R Westerback |
| 2006-05-28 | don't hardcode the iova... it uses the same scheme as the sbus machines | Jason Wright |
| 2006-05-28 | formatting | Jason Wright |
| 2006-05-28 | Fix multicast and broadcast over gre(4) tunnels. Clear the M_MCAST and M_BCAST | Claudio Jeker |
| 2006-05-28 | Spacing in vfs_sysctl() | Pedro Martelletto |
| 2006-05-28 | Nuke unused VFSGEN_MAXID define | Pedro Martelletto |
| 2006-05-28 | intrducing device type DV_SENSOR turned out to be a bad idea as it | Henning Brauer |
| 2006-05-28 | regen | Jonathan Gray |
| 2006-05-28 | Add a few more devices from submitted dmesgs. | Jonathan Gray |
| 2006-05-28 | more hotplug fallout: add DV_SENSOR to the device type switch | Jason Wright |
| 2006-05-28 | Enable adaptive timeouts by default, with adaptive.start of 60% of the | Ryan Thomas McBride |
| 2006-05-28 | pass the reply from the hardware via the ccb rather than on the stack to | David Gwynne |
| 2006-05-28 | need <sys/device.h> or it doesn't compile on sparc64 | Jason Wright |
| 2006-05-28 | new field at end of struct, discussed with theo | Henning Brauer |
| 2006-05-28 | Only preemptively increase the replay counter for outbound TDBs. | Ryan Thomas McBride |
| 2006-05-28 | Include device id in hotplug events. This will be used by ntpd to check | Michael Knudsen |
| 2006-05-28 | rename mpi_complete to mpi_poll and make it call mpi_start itself. | David Gwynne |
| 2006-05-28 | check if the interface is active and UP. some, but not all, network | Reyk Floeter |
| 2006-05-28 | cleanup whitespaces, tabs are so much nicer | Felix Kronlage |
| 2006-05-28 | Always allow ioctl's to work, even if there is no media loaded. | Kenneth R Westerback |
| 2006-05-28 | use if_hardmtu for MTU ioctl handler. | Brad Smith |
| 2006-05-28 | fix a whitespace error causing confusion | Henning Brauer |
| 2006-05-28 | Don't print tape media information during probe. This is transitory | Kenneth R Westerback |
| 2006-05-28 | unbreak, of course this needs to included sys/hotplug.h too | Henning Brauer |
| 2006-05-28 | - remove ETHER_MAX_LEN_JUMBO and ETHERMTU_JUMBO. | Brad Smith |
| 2006-05-28 | unknown ioctl is ENOTTY not EINVAL | Jason Wright |
| 2006-05-27 | unknown ioctl is ENOTTY not EINVAL | Jason Wright |
| 2006-05-27 | Make sensor add/remove create hotplug events (after much prodding from hennin... | Michael Knudsen |
| 2006-05-27 | Do the same thing as for IPv4. Use a sysctl to enable/disable mfrowarding | Claudio Jeker |
| 2006-05-27 | add the messages for config page requests and replies. | David Gwynne |
| 2006-05-27 | With the National variants of the sis(4) chip make sure to | Brad Smith |
