| Age | Commit message (Expand) | Author |
|---|
| 2010-09-06 | - spello, short-hand -> shorthand | Jasper Lievisse Adriaanse |
| 2010-09-06 | Some stupid hardware marks PCI BARs as prefetchable that aren't side-effect | Mark Kettenis |
| 2010-09-06 | move away from using /**/ to ## for cpp paste in sh locore | Jonathan Gray |
| 2010-09-05 | Add an ioctl to figure out the non-sticky bits in PCI BARs used for determining | Mark Kettenis |
| 2010-09-05 | Remove bogus LHS casts. makes gcc4 happy. | Mark Kettenis |
| 2010-09-05 | Make gcc4 happy. Similar to what we've done to sparc64 a couple of months ago. | Mark Kettenis |
| 2010-09-05 | Fix inline assembler to make it acceptable to gcc4. Similar to what we've | Mark Kettenis |
| 2010-09-05 | Properly invoke bus_dmamap_sync() around the ring descriptors. No functional | Miod Vallat |
| 2010-09-04 | revert previous "simplification". kcornies at gmail says it doesn't work. | Ted Unangst |
| 2010-09-04 | Remove redundant prototype left behind by deraadt@ | Mark Kettenis |
| 2010-09-04 | Off-by-two in the length check for CISTPL_CONFIG tuples. | Miod Vallat |
| 2010-09-04 | Use pcmcia_cis_read_1() to read cis data to be checksummed, instead of | Miod Vallat |
| 2010-09-04 | Add support for indirect CIS data (CISTPL_INDIRECT tuple). | Miod Vallat |
| 2010-09-04 | Let se(4) support SiS191, and bring a lot of bugfixes and improvements from | Miod Vallat |
| 2010-09-03 | Some cleanup in preparation for suspend/resume improvements. | Mark Kettenis |
| 2010-09-03 | bus_dmamap_sync() freshly initialized Rx descriptors before flipping the bit | Mark Kettenis |
| 2010-09-03 | fix initialization value of analog register AR_AN_TOP2 on some high | Damien Bergamini |
| 2010-09-03 | Use MPLS_INKERNEL_LOOP_MAX instead of 16 when initializing mpls_inkloop. | Claudio Jeker |
| 2010-09-03 | thib insists i take responsibility too | David Gwynne |
| 2010-09-02 | the page_length field in the vpd page header is 2 bytes, not 1. | David Gwynne |
| 2010-09-02 | don't attempt to enqueue routing messages on sockets marked SS_CANTRCVMORE | Bret Lambert |
| 2010-09-02 | Inline bufq_impl_disksort and bufq_impl_fifo's definitions into | Matthew Dempsky |
| 2010-09-01 | Don't give xs->resid an invalid value (xs->datalen * st->blksize) | Kenneth R Westerback |
| 2010-09-01 | After all escape sequence processing, check for being beyond the last | Nicholas Marriott |
| 2010-09-01 | Do not panic in parsedisk() for ``second class'' block devices (which we can't | Miod Vallat |
| 2010-09-01 | There is no point doing wakeups in bufq_done() unless we're actually in the | Mark Kettenis |
| 2010-09-01 | Clarify why we can walk the list of bufqs without holding a mutex with a | Mark Kettenis |
| 2010-09-01 | Fix typo in vgafb_mmap(), causing a comparison to always fail. ok kettenis@ | Miod Vallat |
| 2010-09-01 | Clean-up the spl dance around suspend/resume. Okay miod@. | Paul Irofti |
| 2010-09-01 | Failure to attach a pcmcia driver could leave the function to be disabled | Miod Vallat |
| 2010-09-01 | Let non-ykbec kernels link again. | Miod Vallat |
| 2010-09-01 | Restore compilability after bufq changes | Miod Vallat |
| 2010-09-01 | ata information vpd page id | David Gwynne |
| 2010-09-01 | make struct bufq a member of the softc for devices that use it, | David Gwynne |
| 2010-08-31 | sync | Stuart Henderson |
| 2010-08-31 | add id for BCM5719; from Linux tg3 driver via Brad | Stuart Henderson |
| 2010-08-31 | remove argnames from prototype. | Owain Ainsworth |
| 2010-08-31 | convert the powerhook to an activate function. That activate function | Theo de Raadt |
| 2010-08-31 | Do wsdisplay suspend/resume and also the bufq dance. | Paul Irofti |
| 2010-08-31 | remove a comment suggesting that azalia needs a powerhook | Theo de Raadt |
| 2010-08-31 | Add DVACT_QUIECE support. This is called before splhigh() and before | Theo de Raadt |
| 2010-08-31 | Add DVACT_QUIECE support. This is called before splhigh() and before | Theo de Raadt |
| 2010-08-31 | When cardbus is fixed, this will be able to use dc_activate directly | Theo de Raadt |
| 2010-08-31 | sort DVACT_ actions in order of use | Theo de Raadt |
| 2010-08-31 | annotate that this driver needs sc_dying code | Theo de Raadt |
| 2010-08-31 | sort DVACT_ actions according to the order likely to be used | Theo de Raadt |
| 2010-08-31 | Change the powerhook into an activation routine. It has to use a workq. | Theo de Raadt |
| 2010-08-31 | In xxactivate() DVACT_DEACTIVATE, when calling a series of config_deactivate() | Theo de Raadt |
| 2010-08-31 | in the activate function, order the DVACT_ functions in the order they | Theo de Raadt |
| 2010-08-31 | activate function should return result of config_activate_children | Theo de Raadt |
