summaryrefslogtreecommitdiff
path: root/sys
AgeCommit message (Expand)Author
2006-05-28do not print "root on ..." twice for the -a case, also cope with systemsTheo de Raadt
2006-05-28Configure network devices at ipl 3, not ipl 1.Miod Vallat
2006-05-28always set if_hardmtu.Brad Smith
2006-05-28Remove dead code; free commit on behalf of dlg@Uwe Stuehler
2006-05-28Use TEST_READY_RETRIES_TAPE instead of TEST_READY_RETRIES_DEFAULT,Kenneth R Westerback
2006-05-28more fallout from the sensors: Every single ramdisk got broken.Theo de Raadt
2006-05-28Use bit 23 of the device minor to indicate a control mode device. AKenneth R Westerback
2006-05-28don't hardcode the iova... it uses the same scheme as the sbus machinesJason Wright
2006-05-28formattingJason Wright
2006-05-28Fix multicast and broadcast over gre(4) tunnels. Clear the M_MCAST and M_BCASTClaudio Jeker
2006-05-28Spacing in vfs_sysctl()Pedro Martelletto
2006-05-28Nuke unused VFSGEN_MAXID definePedro Martelletto
2006-05-28intrducing device type DV_SENSOR turned out to be a bad idea as itHenning Brauer
2006-05-28regenJonathan Gray
2006-05-28Add a few more devices from submitted dmesgs.Jonathan Gray
2006-05-28more hotplug fallout: add DV_SENSOR to the device type switchJason Wright
2006-05-28Enable adaptive timeouts by default, with adaptive.start of 60% of theRyan Thomas McBride
2006-05-28pass the reply from the hardware via the ccb rather than on the stack toDavid Gwynne
2006-05-28need <sys/device.h> or it doesn't compile on sparc64Jason Wright
2006-05-28new field at end of struct, discussed with theoHenning Brauer
2006-05-28Only preemptively increase the replay counter for outbound TDBs.Ryan Thomas McBride
2006-05-28Include device id in hotplug events. This will be used by ntpd to checkMichael Knudsen
2006-05-28rename mpi_complete to mpi_poll and make it call mpi_start itself.David Gwynne
2006-05-28check if the interface is active and UP. some, but not all, networkReyk Floeter
2006-05-28cleanup whitespaces, tabs are so much nicerFelix Kronlage
2006-05-28Always allow ioctl's to work, even if there is no media loaded.Kenneth R Westerback
2006-05-28use if_hardmtu for MTU ioctl handler.Brad Smith
2006-05-28fix a whitespace error causing confusionHenning Brauer
2006-05-28Don't print tape media information during probe. This is transitoryKenneth R Westerback
2006-05-28unbreak, of course this needs to included sys/hotplug.h tooHenning Brauer
2006-05-28- remove ETHER_MAX_LEN_JUMBO and ETHERMTU_JUMBO.Brad Smith
2006-05-28unknown ioctl is ENOTTY not EINVALJason Wright
2006-05-27unknown ioctl is ENOTTY not EINVALJason Wright
2006-05-27Make sensor add/remove create hotplug events (after much prodding from hennin...Michael Knudsen
2006-05-27Do the same thing as for IPv4. Use a sysctl to enable/disable mfrowardingClaudio Jeker
2006-05-27add the messages for config page requests and replies.David Gwynne
2006-05-27With the National variants of the sis(4) chip make sure toBrad Smith
2006-05-27Add support for multicast packets.Christopher Pascoe
2006-05-27There is no longer the need to create INVALID sensors on stock, the sensorMarc Balmer
2006-05-27make debug output during attach quiet unless you want it by raisingDavid Gwynne
2006-05-27remove FreeBSD specific code.Brad Smith
2006-05-27garbage collect vlan.hBrad Smith
2006-05-27Nuke defopt remains. Tested on cats and zaurus.Miod Vallat
2006-05-27Fix obvious error in code that is currently not compiled.Claudio Jeker
2006-05-27remove dead codeDavid Gwynne
2006-05-27add mpi(4) glue. commented out for nowDavid Gwynne
2006-05-27add mpi(4), an alternative (replacement) driver for lsi logic fusion mptDavid Gwynne
2006-05-27When the device is attached, immediately create the timedelta sensor with theMarc Balmer
2006-05-27remove useless error check and irritating commentNikolay Sturm
2006-05-27Make NCOM_{CARDBUS,GSC,ISAPNP} defined again in com.h, as there is codeMiod Vallat