Age | Commit message (Collapse) | Author | |
---|---|---|---|
2009-11-19 | Add PPB_IO_SHIFT #define to mirror PPB_MEM_SHIFT. | Mark Kettenis | |
2009-11-19 | Rename KSEG* defines to CKSEG* to match their names in 64 bit mode; also | Miod Vallat | |
define more 64 bit spaces. | |||
2009-11-19 | All callers of updateimask() immediately enable interrupts afterwards, so do | Miod Vallat | |
it in updateimask() itself. No functional change. | |||
2009-11-19 | Remove code allowing native binaries with O32 ABI to run, there aren't any... | Miod Vallat | |
2009-11-19 | By popular demand and peer pressure, check-in work in progress work to support | Miod Vallat | |
the Yeelong Lemote mips-based netbook. Kernel bits only for now, needs polishing; most of this work done during h2k9 last month, although the porting effort started earlier this year. | |||
2009-11-19 | if a radio switch exists, configure the GPIO pin to which it is | Damien Bergamini | |
connected to raise an interrupt when the pin goes low (or high depending on the polarity of the radio switch.) turn the interface down when the interrupt occurs. this is the same behaviour as in wpi(4) and iwn(4). cleanup interrupts processing while i'm here. remove ATHN_INTR_MITIGATION compile option (it is set by default.) | |||
2009-11-19 | By popular demand and peer pressure, check-in work in progress work to support | Miod Vallat | |
the Yeelong Lemote mips-based netbook. Kernel bits only for now, needs polishing; most of this work done during h2k9 last month, although the porting effort started earlier this year. | |||
2009-11-19 | fix for some variants of AR9285. | Damien Bergamini | |
found while doing code inspection as i don't have such hardware. | |||
2009-11-19 | It turns out that the 2GB contiguous DMA direct map window also needs | Miod Vallat | |
to be aligned on a 2GB boundary. Therefore the `add 512MB' bit used on Octane does not give us a 0.5GB-2.5GB usable DMA range, but a 0.5GB-2GB range; trying to use address in the 2GB-2.5GB range would cause PCI DMA errors at the xbridge level. There is no real benefit in using it, since this required us to keep subtracting or adding 0.5GB when converting DMA address to physical memory address or the other way around. So stop using it; this makes a few parts of the code simpler (and until bounce buffers are implemented, Octane systems will not use more than 1.5GB of memory). | |||
2009-11-19 | Factor triplicated code responsible to add memory information into a | Miod Vallat | |
single place. | |||
2009-11-19 | Dell's SVR4 apparently mapped page zero to the executable. We don't | Philip Guenthe | |
do that and, given the security issues it exacerbates, never will. So document it and delete the disabled support. ok deraadt@ tedu@ | |||
2009-11-18 | - regen | Jasper Lievisse Adriaanse | |
2009-11-18 | - add startech.com and the product id for their ICUSB2321X/2X/4X devices, | Jasper Lievisse Adriaanse | |
which seem to be a multiport TIUSB3410, which uticom(4) can't deal with yet. hints from sthen@ | |||
2009-11-18 | * always move the same amount of data (256 frames) in the interrupt handler | Jacob Meuser | |
* round blocksizes to multiples of 256 frames * fix display of record.source.volume and add record.mic.preamp mixer controls * add recording support ok kettenis@. ok ratchov@ on a slightly different version. | |||
2009-11-18 | Stricter type usage (width and signedness); first step towards 64 bit ptes. | Miod Vallat | |
2009-11-18 | panic on impossible error code | Alexander Hall | |
potential off-by-one found by parfait ok deraadt@, krw@ | |||
2009-11-18 | Move widget register information apart from xbow software interface, and | Miod Vallat | |
update #include needs. No functional change. | |||
2009-11-18 | Add glue to attach iockbc(4) to iof(4) as well. Tested by deraadt@ | Miod Vallat | |
2009-11-18 | regen | Jonathan Gray | |
2009-11-18 | More EP80579 devices. | Jonathan Gray | |
2009-11-18 | Don't whinge about not knowing the bus_clock for EP80579 (model 0x15) | Jonathan Gray | |
as there is no FSB and the processors don't have speedstep anyway. | |||
2009-11-18 | improve the bpf path. packets we send out via the bridge are seen, but | Theo de Raadt | |
those that come in the bridge are still invisible. the bridge is going to have to bpf those for us. | |||
2009-11-18 | set IFCAP_VLAN_MTU; from brad | Theo de Raadt | |
2009-11-18 | do not do setup that ether_ifattach() takes care of; ok jsg | Theo de Raadt | |
2009-11-17 | Tidy up promisc/multicast handing. From Brad. Tested by me. | Mark Kettenis | |
2009-11-17 | fix a DPRINTF format string. | Damien Bergamini | |
2009-11-17 | nuke the temperature sensor. | Damien Bergamini | |
it is totally useless since (contrary to the one in iwn(4)) it is not in any known unit (can't be converted to degK or degC). | |||
2009-11-17 | regen | Damien Bergamini | |
2009-11-17 | another shitload of run(4) usb ids | Damien Bergamini | |
we have 159 ids now just for run(4) | |||
2009-11-17 | cleanup the printf/DPRINTF mess. | Damien Bergamini | |
use proper debug levels for diagnostic messages such that we don't spam the logs when athn_debug is low. | |||
2009-11-17 | fix previous. | Damien Bergamini | |
2009-11-17 | update hardware multicast filter. | Damien Bergamini | |
2009-11-17 | regen | Damien Bergamini | |
2009-11-17 | the D-Link DWA-160 rev A2 is an otus(4) too. | Damien Bergamini | |
2009-11-17 | add short interframe space to duration since the athn_txtime | Damien Bergamini | |
function does not take it into account. oops. | |||
2009-11-17 | Initialize the FPU to be in double precision mode for SH4. This is what the | Mark Kettenis | |
Linux kernel does and is obviously what GCC expects. Fixed segmentation faults in omalloc_init() for shared executables linked with the pthreads library. tested by otto@, ok deraadt@, drahn@ | |||
2009-11-17 | Tidy up promisc/multicast handling. Tested by myself (and earlier | Stuart Henderson | |
versions by some others who didn't test with both multicast and promiscuous at the same time). From Brad. | |||
2009-11-16 | regen | Jonathan Gray | |
2009-11-16 | Some more Cavium devices. Prompted by a dmesg from Jason George. | Jonathan Gray | |
2009-11-16 | it is better if it compiles. | Damien Bergamini | |
2009-11-16 | do not panic when wep is enabled. | Damien Bergamini | |
2009-11-16 | Fix array access found by parfait and switch to nitems while here. | Jonathan Gray | |
ok deraadt@ | |||
2009-11-15 | athn works on sparc64 | Theo de Raadt | |
2009-11-15 | Move ciss(4) to NO_CCB. Add some extra paranoia by always testing | Kenneth R Westerback | |
the results of attempting to get a ccb. Eliminates manual reservation of ccb's for bioctl and sensors. Tested by johan@ and okan@. Eyes from brad@, dlg@ and marco@. tech@ did its Thomas More thing. | |||
2009-11-15 | AR9287 uses GPIO pin 8 for LED, not 1. | Damien Bergamini | |
Turn link LED on while associated. | |||
2009-11-15 | Fix memory leak in error case. Found by Parfait. | Joel Sing | |
ok marco@ deraadt@ | |||
2009-11-15 | fix athn_stop_tx_dma(). | Damien Bergamini | |
2009-11-15 | athn(4) has a future in here. | Theo de Raadt | |
2009-11-14 | translate a comment from french to english. | Damien Bergamini | |
no binary change. | |||
2009-11-14 | make ramdisks compile | Theo de Raadt | |