NetBSD/amiga 1.1 runs on any amiga that has a 68020 or better CPU
with some form of FPU and MMU.  The minimal configuration requires
4M of RAM and about 65M of disk space.  To install the entire system
requires much more disk space, and to run X or compile the system,
more RAM is recommended.  (4M of RAM will actually allow you to
compile, however it won't be speedy.  X really isn't usable on a
4M system)

Here is a table of recommended HD partition sizes for a full install:
	partition:	advise,	with X,	needed,	with X
	root (/)	15M	15M	10M	10M
	user (/usr)	65M	100M	45M 	80M
	swap		----- 2M for every M ram -----
	local (/local)	up to you


As you may note the recommended size of /usr is 20M greater than
needed. This is to leave room for a kernel source and compile tree
as you will probably want to compile your own kernel. (GENERIC is
large and bulky to accommodate all people).

If you only have 4M of fast memory, you should make your swap partition
larger, as your system will be doing much more swapping.

Supported devices include:
	A4000/A1200 IDE controller.
	SCSI host adapters:
		33c93 based boards: A2091, A3000 and GVP series II.
		53c80 based boards: 12 Gauge, IVS and Wordsync/Bytesync.
		53c710 based boards: A4091, Magnum, Warp Engine and Zeus.
		FAS216 based boards: FastLane Z3, Blizzard.
	Video controllers:
		ECS, AGA and A2024 built in on various amigas.
		Retina Z2 and Retina Z3.
		Picasso II.
		GVP Spectrum.
		Piccalo.
		A2410.
		Cybervision 64.
	Ethernet controllers:
		A2065 Ethernet
		Hydra Ethernet
		ASDG Ethernet
		A4066 Ethernet
		Ariadne Ethernet
		Quicknet Ethernet
	Arcnet controllers:
		A2060 Arcnet
	Tape drives:
		Most SCSI tape drives, including
			Archive Viper, Cipher SCSI-2 ST150.
	CD-ROM drives:
		Most SCSI CD-ROM drives
	Serial cards:
		MultiFaceCard II and III
		A2232
	Amiga floppy drives.
	Amiga parallel port.
	Amiga serial port.
	Amiga mouse.

If its not on this list, there is no support for it in this release.