OpenBSD/amiga 2.1 runs on any amiga that has a 68020, 68030, 68040 or
68060 CPU with some form of FPU and MMU.  The minimal configuration
requires 4M of RAM and about 75M of disk space.  To install the entire
system requires much more disk space, and to run X or compile the system,
more RAM is recommended.  (4M of RAM will actually allow you to
compile, however it won't be speedy.  X really isn't usable on a
4M system.)

Here is a table of recommended HD partition sizes for a full install:
	partition:	advise,	with X,	needed,	with X
	root (/)	20M	20M	15M	15M
	user (/usr)	95M	130M	75M 	110M
	swap		---- 1MB for every MB RAM ----
			-- but the sum of swap and ---
			- RAM should be at least 16 --

As you may note the recommended size of /usr is 20M greater than
needed. This is to leave room for a kernel source and compile tree
as you will probably want to compile your own kernel. (GENERIC and
INSTALL are large and bulky to accommodate all people).

If you only have 4M of fast memory, you should make your swap partition
larger, as your system will be doing much more swapping.

Supported devices include:
	A4000/A1200 IDE controller.
	ISA IDE & ATAPI with a supported ISA bridge.
	SCSI host adapters:
		33c93 based boards: A2091, A3000 and GVP series II.
		53c80 based boards: 12 Gauge, IVS and Wordsync/Bytesync.
		53c710 based boards: A4091, Magnum, Warp Engine and Zeus.
		FAS216 based boards: FastLane Z3, Blizzard.
	Video controllers:
		ECS, AGA and A2024 built in on various amigas.
		Retina Z2 and Retina Z3.
		Picasso II.
		GVP Spectrum.
              Piccolo.
		A2410.
		Cybervision 64.
	Ethernet controllers:
		A2065 Ethernet
		Hydra Ethernet
		ASDG Ethernet
		A4066 Ethernet
		Ariadne Ethernet
		Quicknet Ethernet
		Via a supported ISA bridge:
			NE[12]000, SMC/WD 8003/8013/8216, 3COM 3c503 Ethernet
		
	Arcnet controllers:
		A2060 Arcnet
	Tape drives:
		Most SCSI tape drives, including
			Archive Viper, Cipher SCSI-2 ST150.
	CD-ROM drives:
		Most SCSI CD-ROM drives
	Serial ports:
		Amiga serial port.
		MultiFaceCard II and III
		A2232
		PC COM ports attached to a supported ISA bridge
	Parallel ports:
		Amiga parallel port.
		PC LPT ports attached to a supported ISA bridge
	ISA bridges:
		The GoldenGate Bus+ (aka GG2)
		The CrossLink
	Amiga floppy drives.
	Amiga mouse.

If its not on this list, there is no support for it in this release.