dnl	$OpenBSD: install,v 1.7 2008/10/16 00:05:09 krw Exp $
OpenBSDInstallPrelude

OpenBSDInstallPart2

OpenBSDBootMsgs(,"wd0")

	You will next be asked for your terminal type.  If you are
	installing from a non-serial console, the default of "vt220"
	is correct.  If you are installing from a serial console
	you should choose the terminal type from amongst those listed.
	(If your terminal type is xterm, just use vt220.)

OpenBSDInstallPart3

	Next you will have to edit or create a disk label for the disk
	OpenBSD is being installed on.  If there are any existing
	partitions defined (for any operating system), and a disk label
	is not found, you will first be given an opportunity to run
	fdisk and create an OpenBSD partition.

	If fdisk is being invoked on your behalf, it will start by
	displaying the current partitions defined and then allow you
	to modify this information, add new partitions and change
	which partition to boot from by default.  If you make a mistake,
	you will be allowed to repeat this procedure as necessary to
	correct this.  Note that you should make OpenBSD be the active
	partition at least until the install has been completed.

OpenBSDInstallPart4({:- If you have Linux partitions
	defined on the disk, these will usually show up as partition
	'i', 'j' and so on.-:})

OpenBSDInstallPart5(wd0)

OpenBSDInstallNet({:-CD-ROM, -:},nofloppy)

OpenBSDFTPInstall

OpenBSDHTTPInstall

OpenBSDCDROMInstall

OpenBSDDISKInstall({:-"wdN" or -:},,{:-, Linux (ext2) or MS-DOS-:})

OpenBSDCommonFS

OpenBSDCommonURL

OpenBSDInstallWrapup

OpenBSDInstallWrapupPart2

OpenBSDCongratulations