dnl     $OpenBSD: install,v 1.1 2011/03/22 18:33:51 jasper Exp $
OpenBSDInstallPrelude

Now you are ready to power up the board. It will print some hardware
information and if your SD card has been properly setup the autoboot
script will be loaded:

	Hit any key to stop autoboot:  0 
	mmc1 is available
	The user button is currently NOT pressed.
	reading boot.scr

	123 bytes read
	Running bootscript from mmc ...
	## Executing script at 80200000
	reading bsd.umg

	2634332 bytes read

	## Booting kernel from Legacy Image at 82800000 ...
	   Image Name:   boot
	   Image Type:   ARM Linux Kernel Image (uncompressed)
	   Data Size:    2634268 Bytes =  2.5 MB
	   Load Address: 80300000
	   Entry Point:  80300000
	   Verifying Checksum ... OK
	   Loading Kernel Image ... OK
	OK

	Starting kernel ...

	OpenBSD/beagle booting ...

Alternatively you can manually boot OpenBSD when you hit any key
during the time-out and you will be presented with the following
prompt:

	OMAP3 beagleboard.org #

Now type 'mmc init' to check that the SD card has been found:

	OMAP3 beagleboard.org # mmc init
	mmc1 is available
	OMAP3 beagleboard.org # 

When the card has been found you should load the U-Boot image into memory:

	OMAP3 beagleboard.org # fatload mmc 0 0x80800000 bsd.umg
	reading bsd.umg

	2634332 bytes read
	OMAP3 beagleboard.org # 

To load that image from memory and thus boot OpenBSD type:

	OMAP3 beagleboard.org # bootm 0x80800000

Note that no ramdisk kernels are provided at this moment, so you won't
be able to actually install OpenBSD/MACHINE yet..

OpenBSDInstallPart2

OpenBSDInstallPart3(,"sd0")

OpenBSDInstallPart4

OpenBSDInstallMBRPart1

OpenBSDInstallMBRPart2(indeed)

OpenBSDInstallPart5

OpenBSDInstallPart6({:-CD-ROM, -:})

OpenBSDURLInstall

OpenBSDCDROMInstall

OpenBSDDISKInstall(,,{:-, Linux (ext2) or MS-DOS-:})

OpenBSDCommonInstall

OpenBSDInstallWrapup

OpenBSDCongratulations