dnl	$OpenBSD: install,v 1.1 2006/11/09 00:45:37 deraadt Exp $
OpenBSDInstallPrelude

Write some good explaination here...

OpenBSDInstallPart2

OpenBSDBootMsgs

	You will next be asked for your terminal type.  You should just
	hit return to select the default (vt220).

OpenBSDInstallPart3({:- or "wd0" for IDE drives-:})

	Next you will have to edit or create a disk label for the disk
	OpenBSD is being installed on.  If there are any existing
	partitions defined (for any operating system), and a disk label
	is not found, you will first be given an opportunity to run
	fdisk and create an OpenBSD partition.

	If fdisk is being invoked on your behalf, it will start by
	displaying the current partitions defined and then allow you
	to modify this information, add new partitions and change
	which partition to boot from by default.  If you make a mistake,
	you will be allowed to repeat this procedure as necessary to
	correct this.  Note that you should make OpenBSD be the active
	partition at least until the install has been completed.

OpenBSDInstallPart4({:- If you have Linux partitions
	defined on the disk, these will usually show up as partition
	'h', 'i' and so on.-:})

	Explain more here.

OpenBSDInstallPart5(wd0)

OpenBSDInstallNet({:-CD-ROM, -:},nofloppy)

OpenBSDFTPInstall

OpenBSDHTTPInstall

OpenBSDCDROMInstall

OpenBSDDISKInstall({:-"wdN" or -:},,{:-, Linux (ext2) or MS-DOS-:})

OpenBSDCommonFS

OpenBSDCommonURL

OpenBSDCongratulations