Installation is supported from several media types, including:
	NFS partitions
	FTP
	Tape

The steps necessary to prepare the distribution sets
for installation depend on which method of installation
you choose.  The various methods are explained below.
Those are only the preparations required before you start
the installation.

To prepare for installing via an NFS partition:

	Place the OpenBSD software you wish to install into
	a directory on an NFS server, and make that directory
	mountable by the machine which you will be installing
	OpenBSD on.  This will probably require modifying the
	/etc/exports file of the NFS server and resetting
	mountd, acts which will require superuser privileges.
	Note the numeric IP address of the NFS server and of
	the router closest to the the new OpenBSD machine,
	if the NFS server is not on a network which is
	directly attached to the OpenBSD machine.

	If you are using a diskless setup to install OpenBSD on
	your machine, you can take advantage of the fact that
	the above has already been done on your machine's server.
	So, you can conveniently put the OpenBSD filesets in your
	machine's root filesystem on the server where the install
	program can find them.

	Once you have done this, you can proceed to the next
	step in the installation process, preparing your
	system for OpenBSD installation.

To prepare for installing via FTP:

	The preparations for this method of installation
	are easy: all you have to do is make sure that
	there's some FTP site from which you can retrieve
	the OpenBSD installation when it's time to do
	the install.  You should know the numeric IP
	address of that site, the numeric IP address of
	your nearest router if one is necessary

	Once you have done this, you can proceed to the next
	step in the installation process, preparing your
	system for OpenBSD installation.

To prepare for installing via a tape:

	To install OpenBSD from a tape, you need to somehow
	get the OpenBSD filesets you wish to install on
	your system on to the appropriate kind of tape,
	in tar format.

	If you're making the tape on a UN*X system, the easiest
	way to do so is:

		tar cvf <tape_device> <files>

	where "<tape_device>" is the name of the tape device
	that describes the tape drive you're using (possibly
	something like /dev/nrst0, but we make no guarantees 8-).
	Under SunOS 5.x, this would be something like /dev/rmt/0mbn.
	Again, your mileage may vary.  If you can't figure it out,
	ask your system administrator.  "<files>" are the names
	of the "set_name.nnn" files which you want to be placed
	on the tape.

	Once you have done this, you can proceed to the next
	step in the installation process, preparing your 
	system for OpenBSD installation.