.\"	$OpenBSD: boot_tahoe.8,v 1.3 1996/06/29 18:24:20 mickey Exp $
.\"	$NetBSD: boot_tahoe.8,v 1.3 1995/04/23 10:33:38 cgd Exp $
.\"
.\" Copyright (c) 1980, 1991, 1993
.\"	The Regents of the University of California.  All rights reserved.
.\"
.\" Redistribution and use in source and binary forms, with or without
.\" modification, are permitted provided that the following conditions
.\" are met:
.\" 1. Redistributions of source code must retain the above copyright
.\"    notice, this list of conditions and the following disclaimer.
.\" 2. Redistributions in binary form must reproduce the above copyright
.\"    notice, this list of conditions and the following disclaimer in the
.\"    documentation and/or other materials provided with the distribution.
.\" 3. All advertising materials mentioning features or use of this software
.\"    must display the following acknowledgement:
.\"	This product includes software developed by the University of
.\"	California, Berkeley and its contributors.
.\" 4. Neither the name of the University nor the names of its contributors
.\"    may be used to endorse or promote products derived from this software
.\"    without specific prior written permission.
.\"
.\" THIS SOFTWARE IS PROVIDED BY THE REGENTS AND CONTRIBUTORS ``AS IS'' AND
.\" ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
.\" IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE
.\" ARE DISCLAIMED.  IN NO EVENT SHALL THE REGENTS OR CONTRIBUTORS BE LIABLE
.\" FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL
.\" DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS
.\" OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
.\" HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
.\" LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY
.\" OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF
.\" SUCH DAMAGE.
.\"
.\"     @(#)boot_tahoe.8	8.2 (Berkeley) 4/19/94
.\"
.Dd April 19, 1994
.Dt BOOT 8 tahoe
.Os
.Sh NAME
.Nm boot
.Nd
system bootstrapping procedures
.Sh DESCRIPTION
.Sy Power fail and crash recovery.
Normally, the system will reboot itself at power-up or after crashes.
An automatic consistency check of the file systems will be performed,
and unless this fails, the system will resume multi-user operations.
.Pp
.Sy Cold starts.
These are processor-type dependent.
On the
.Tn CCI
Power 6/32 and related processors,
the system will do a standard autoboot from drive 0
upon power-up or reset.
This automatic boot may be cancelled by typing a
.Ql \&#
in the first few seconds after reset.
This enters console mode; the console prompt is
.Ql >
or
.Ql \&# .
The boot flags can be set to any hexadecimal value
.Fl n
with the command
.Pp
.Bd -filled -offset indent -compact
.Li \&#> p23
.Ar n .
.Ed
.Pp
The default device may be examined or set; see the Diagnostics and Debugging
manual for the processor for details on device naming and syntax.
After setting the boot flags and/or device,
a bootstrap sequence can be initiated with
.Pp
.Dl #> fb
.Pp
A specific device or bootstrap file may be used; for example,
.Pp
.Dl \&#> \&fb xfd(1,0)
.Pp
would boot from the `a' partition on
.Tn XFD
drive 1.
.Pp
The file specifications used for the boostrap
when loaded with the
.Dq askme
flag
(register 23 set to 1 or 3)
are of the form:
.Pp
.Dl device(adaptor,controller,unit,minor)
.Pp
where
.Ar device
is the type of the device to be searched,
.Ar adaptor
is number of the
.Tn VERSAbus
(or
.Tn VMEbus )
to which the device is attached,
.Ar controller
is the unit number of the controller on that buss,
.Ar unit
is the unit number of the disk or tape,
and
.Ar minor
is the disk partition or tape file number.
Leading adaptor or controller numbers default to 0.
Normal line editing characters can be used when typing the file specification.
The following list of supported devices may vary from installation to
installation:
.Pp
.Bd -unfilled -offset indent -compact
dk	SMD or ESDI disks on VDDC or SMD-E
cy	tape on Ciprico Tapemaster controller
.Ed
.Pp
For example,
to boot from a file system which starts at cylinder 0
of unit 0 of an
.Tn SMD-E
disk, type
.Ql dk(0,0)bsd
to the boot prompt;
.Ql dk(2,1,0)bsd
would specify drive 1 on
.Tn SMD-E
controller 2.
.Pp
In an emergency, the bootstrap methods described in the paper
.%T "Installing and Operating 4.3 BSD-tahoe UNIX on the Tahoe"
can be used
to boot from a distribution tape.
.Sh FILES
.Bl -tag -width /bsd -compact
.It Pa /bsd
system code
.It Pa /boot
system bootstrap
.El
.Sh SEE ALSO
.Xr halt 8 ,
.Xr reboot 8 ,
.Xr shutdown 8
.Sh BUGS
The disklabel format used by some versions of the console processor
is different than the format used by
.Tn UNIX
and the bootstrap.
.Sh HISTORY