#	$Id: MYBOX,v 1.4 1997/03/03 20:20:30 rahnds Exp $

include "std.mvme88k"

maxusers	8
options		TIMEZONE=300, DST=1
options		BYTE_MSF
options		SWAPPAGER, VNODEPAGER, DEVPAGER
#options		INET
options		FFS, MFS, FDESC
#options		"COMPAT_42", "COMPAT_43"
options		GENERIC, KTRACE, DIAGNOSTIC, "NKMEMCLUSTERS=256"
#options		PANICWAIT, DEBUG, DDB
options		PANICWAIT, DEBUG, DDB

#options	"CD9660", PORTAL, MSDOSFS, PROCFS, NULLFS, FIFO, KERNFS
#options	NFSSERVER, NFSCLIENT
#options	SYSVSHM, SYSVMSG, SYSVSEM	
#options	SYSCALL_DEBUG, SCSIDEBUG, KGDB

mainbus0	at root

pcctwo0 at mainbus0 addr 0xfff00000
clock0	at pcctwo0 ipl 5
#nvram0	at pcctwo0 offset 0xc0000
#ie0	at pcctwo0 offset 0x46000 ipl 1
#siop0	at pcctwo0 offset 0x47000 ipl 2
#cl0	at pcctwo0 offset 0x45000 ipl 4
vme0	at pcctwo0 offset 0x40000
#lptwo0	at pcctwo0 ipl 1
#mcecc0	at pcctwo0 offset 0x43000
#mcecc1	at pcctwo0 offset 0x43100
#memc0	at pcctwo0 offset 0x43000
#memc1	at pcctwo0 offset 0x43100
#sram0	at mainbus0 addr 0xffe00000

bugtty0		at mainbus0		# bug tty

# scsi stuff, all possible
#m187scsi0	at mainbus0
#bugscsi0	at mainbus0
#bugscsi0	at pcc0

#scsibus0	at m187scsi0
#scsibus0	at bugscsi0
#scsibus0	at scsi0
#
# compat.
#
#sd0	at scsibus? target 0 lun 0
#sd1	at scsibus? target 1 lun 0
#sd2	at scsibus? target 2 lun 0
#sd3	at scsibus? target 3 lun 0
#sd4	at scsibus? target 4 lun 0
#sd5	at scsibus? target 5 lun 0
#sd6	at scsibus? target 6 lun 0

#
# This is nicer however many amiga setups expect sd units to refer to
# scsi target numbers.  If this is not the case, you can remove the 
# specific sdx lines above and each hard drive from low target to high
# will configure to the next available sd unit number

#sd*	at scsibus? target ? lun ?	# scsi disks
#st*	at scsibus? target ? lun ?	# scsi tapes
#cd*	at scsibus? target ? lun ?	# scsi cd's

#pseudo-device	sl			# slip
#pseudo-device	ppp			# ppp
#pseudo-device	pty 16			# pseudo terminals
#pseudo-device	loop			# network loopback
#
config	netbsd swap on generic