$OpenBSD: README.copy,v 1.2 1997/05/29 00:04:15 niklas Exp $ $NetBSD: README.copy,v 1.2 1995/09/29 16:33:38 ragge Exp $ How to use copy ------------------ Edlabel is a standalone program that can copy multiple volumes from disk/tape to disk/tape. Mostly it is used to copy the miniroot filesystem onto the swap partition during initial installation. You will here be guided through a session, things with ^^^^ under is typed in by the user, comments are within /* */. This is an installation from TK50. Nboot : copy ^^^^ 10480+468+34868 start 0x0 copy: This program will read miniroot from tape/floppy/disk and install this miniroot onto disk. Specify the device to read from as xx(N,0), where xx is the device-name and N is the unit-number, e.g. "tms(0,1)" for the first TMSCP-tape (TK50), "ra(2,0)" for the third MSCP-disk/floppy (RX33/RX50) device to read from ? tms(0,1) /* Tape 0, file 1 */ ^^^^^^^^ Specify number of blocks to transfer. Usually this is sizeof(miniroot) / 512. It's safe to transfer more blocks than just the miniroot. number of blocks ? 4096 /* Miniroot size is 4096 block */ ^^^^ If your miniroot is split into volumes, then you must specify the number of blocks per volume. (e.g. 800 blocks per RX50, 2400 blocks per RX33) number of blocks per volume ? [4096] Make sure unit tms(0,1) is online and holds the proper volume. Then type 'g' to Go or 'a' to Abort. OK to go on ? [g/a] g /* g == go, a == abort */ ^ Reading ... Reading of miniroot done. (4096 blocks read) Now specify the device to write miniroot to as xx(N,1) where xx is the drive type and N is the drive number. For example: ra(0,1) refers to MSCP drive #0, b partition Root disk ? : ra(0,1) /* Actually DUA0, partition b (swap) */ ^^^^^^^^^ Initializing partition ... done. (4096 blocks written.) Halt the machine and reboot from distribution media, giving second partition as part to mount as root. Ex: : ra(0,1) for ra disk 0, hp(2,1) for massbuss disk 2 Halt/Reboot the machine NOW. ?02 EXT HLT PC = 001005F3 >>> -- Ragge