/* $OpenBSD: igc_phy.h,v 1.1 2021/10/31 14:52:57 patrick Exp $ */ /*- * Copyright 2021 Intel Corp * Copyright 2021 Rubicon Communications, LLC (Netgate) * SPDX-License-Identifier: BSD-3-Clause * * $FreeBSD$ */ #ifndef _IGC_PHY_H_ #define _IGC_PHY_H_ void igc_init_phy_ops_generic(struct igc_hw *); int igc_null_read_reg(struct igc_hw *, uint32_t, uint16_t *); void igc_null_phy_generic(struct igc_hw *); int igc_null_lplu_state(struct igc_hw *, bool); int igc_null_write_reg(struct igc_hw *, uint32_t, uint16_t); int igc_null_set_page(struct igc_hw *, uint16_t); int igc_check_downshift_generic(struct igc_hw *); int igc_check_reset_block_generic(struct igc_hw *); int igc_get_phy_id(struct igc_hw *); int igc_phy_sw_reset_generic(struct igc_hw *); int igc_phy_hw_reset_generic(struct igc_hw *); int igc_phy_reset_dsp_generic(struct igc_hw *); int igc_set_d3_lplu_state_generic(struct igc_hw *, bool); int igc_setup_copper_link_generic(struct igc_hw *); int igc_phy_has_link_generic(struct igc_hw *, uint32_t, uint32_t, bool *); int igc_determine_phy_address(struct igc_hw *); int igc_enable_phy_wakeup_reg_access_bm(struct igc_hw *, uint16_t *); int igc_disable_phy_wakeup_reg_access_bm(struct igc_hw *, uint16_t *); void igc_power_up_phy_copper(struct igc_hw *); void igc_power_down_phy_copper(struct igc_hw *); int igc_read_phy_reg_mdic(struct igc_hw *, uint32_t offset, uint16_t *); int igc_write_phy_reg_mdic(struct igc_hw *, uint32_t offset, uint16_t); int igc_read_xmdio_reg(struct igc_hw *, uint16_t, uint8_t, uint16_t *); int igc_write_xmdio_reg(struct igc_hw *, uint16_t, uint8_t, uint16_t); int igc_write_phy_reg_gpy(struct igc_hw *, uint32_t, uint16_t); int igc_read_phy_reg_gpy(struct igc_hw *, uint32_t, uint16_t *); int igc_wait_autoneg(struct igc_hw *); /* IGP01IGC Specific Registers */ #define IGP01IGC_PHY_PORT_CONFIG 0x10 /* Port Config */ #define IGP01IGC_PHY_PORT_STATUS 0x11 /* Status */ #define IGP01IGC_PHY_PORT_CTRL 0x12 /* Control */ #define IGP01IGC_PHY_LINK_HEALTH 0x13 /* PHY Link Health */ #define IGP02IGC_PHY_POWER_MGMT 0x19 /* Power Management */ #define IGP01IGC_PHY_PAGE_SELECT 0x1F /* Page Select */ #define BM_PHY_PAGE_SELECT 22 /* Page Select for BM */ #define IGP_PAGE_SHIFT 5 #define PHY_REG_MASK 0x1F #define IGC_I225_PHPM 0x0E14 /* I225 PHY Power Management */ #define IGC_I225_PHPM_DIS_1000_D3 0x0008 /* Disable 1G in D3 */ #define IGC_I225_PHPM_LINK_ENERGY 0x0010 /* Link Energy Detect */ #define IGC_I225_PHPM_GO_LINKD 0x0020 /* Go Link Disconnect */ #define IGC_I225_PHPM_DIS_1000 0x0040 /* Disable 1G globally */ #define IGC_I225_PHPM_SPD_B2B_EN 0x0080 /* Smart Power Down Back2Back */ #define IGC_I225_PHPM_RST_COMPL 0x0100 /* PHY Reset Completed */ #define IGC_I225_PHPM_DIS_100_D3 0x0200 /* Disable 100M in D3 */ #define IGC_I225_PHPM_ULP 0x0400 /* Ultra Low-Power Mode */ #define IGC_I225_PHPM_DIS_2500 0x0800 /* Disable 2.5G globally */ #define IGC_I225_PHPM_DIS_2500_D3 0x1000 /* Disable 2.5G in D3 */ /* GPY211 - I225 defines */ #define GPY_MMD_MASK 0xFFFF0000 #define GPY_MMD_SHIFT 16 #define GPY_REG_MASK 0x0000FFFF #define IGP01IGC_PHY_PCS_INIT_REG 0x00B4 #define IGP01IGC_PHY_POLARITY_MASK 0x0078 #define IGP01IGC_PSCR_AUTO_MDIX 0x1000 #define IGP01IGC_PSCR_FORCE_MDI_MDIX 0x2000 /* 0=MDI, 1=MDIX */ #define IGP01IGC_PSCFR_SMART_SPEED 0x0080 #define IGP02IGC_PM_SPD 0x0001 /* Smart Power Down */ #define IGP02IGC_PM_D0_LPLU 0x0002 /* For D0a states */ #define IGP02IGC_PM_D3_LPLU 0x0004 /* For all other states */ #define IGP01IGC_PLHR_SS_DOWNGRADE 0x8000 #define IGP01IGC_PSSR_POLARITY_REVERSED 0x0002 #define IGP01IGC_PSSR_MDIX 0x0800 #define IGP01IGC_PSSR_SPEED_MASK 0xC000 #define IGP01IGC_PSSR_SPEED_1000MBPS 0xC000 #define IGP02IGC_PHY_CHANNEL_NUM 4 #define IGP02IGC_PHY_AGC_A 0x11B1 #define IGP02IGC_PHY_AGC_B 0x12B1 #define IGP02IGC_PHY_AGC_C 0x14B1 #define IGP02IGC_PHY_AGC_D 0x18B1 #define IGP02IGC_AGC_LENGTH_SHIFT 9 /* Course=15:13, Fine=12:9 */ #define IGP02IGC_AGC_LENGTH_MASK 0x7F #define IGP02IGC_AGC_RANGE 15 #define IGC_CABLE_LENGTH_UNDEFINED 0xFF #define IGC_KMRNCTRLSTA_OFFSET 0x001F0000 #define IGC_KMRNCTRLSTA_OFFSET_SHIFT 16 #define IGC_KMRNCTRLSTA_REN 0x00200000 #define IGC_KMRNCTRLSTA_DIAG_OFFSET 0x3 /* Kumeran Diagnostic */ #define IGC_KMRNCTRLSTA_TIMEOUTS 0x4 /* Kumeran Timeouts */ #define IGC_KMRNCTRLSTA_INBAND_PARAM 0x9 /* Kumeran InBand Parameters */ #define IGC_KMRNCTRLSTA_IBIST_DISABLE 0x0200 /* Kumeran IBIST Disable */ #define IGC_KMRNCTRLSTA_DIAG_NELPBK 0x1000 /* Nearend Loopback mode */ #define IFE_PHY_EXTENDED_STATUS_CONTROL 0x10 #define IFE_PHY_SPECIAL_CONTROL 0x11 /* 100BaseTx PHY Special Ctrl */ #define IFE_PHY_SPECIAL_CONTROL_LED 0x1B /* PHY Special and LED Ctrl */ #define IFE_PHY_MDIX_CONTROL 0x1C /* MDI/MDI-X Control */ /* IFE PHY Extended Status Control */ #define IFE_PESC_POLARITY_REVERSED 0x0100 /* IFE PHY Special Control */ #define IFE_PSC_AUTO_POLARITY_DISABLE 0x0010 #define IFE_PSC_FORCE_POLARITY 0x0020 /* IFE PHY Special Control and LED Control */ #define IFE_PSCL_PROBE_MODE 0x0020 #define IFE_PSCL_PROBE_LEDS_OFF 0x0006 /* Force LEDs 0 and 2 off */ #define IFE_PSCL_PROBE_LEDS_ON 0x0007 /* Force LEDs 0 and 2 on */ /* IFE PHY MDIX Control */ #define IFE_PMC_MDIX_STATUS 0x0020 /* 1=MDI-X, 0=MDI */ #define IFE_PMC_FORCE_MDIX 0x0040 /* 1=force MDI-X, 0=force MDI */ #define IFE_PMC_AUTO_MDIX 0x0080 /* 1=enable auto, 0=disable */ #endif /* _IGC_PHY_H_ */