/* $OpenBSD: pciide_opti_reg.h,v 1.5 2022/08/29 06:08:04 jsg Exp $ */ /* $NetBSD: pciide_opti_reg.h,v 1.2 2000/06/07 20:42:53 scw Exp $ */ /*- * Copyright (c) 2000 The NetBSD Foundation, Inc. * All rights reserved. * * This code is derived from software contributed to The NetBSD Foundation * by Steve C. Woodford. * * Redistribution and use in source and binary forms, with or without * modification, are permitted provided that the following conditions * are met: * 1. Redistributions of source code must retain the above copyright * notice, this list of conditions and the following disclaimer. * 2. Redistributions in binary form must reproduce the above copyright * notice, this list of conditions and the following disclaimer in the * documentation and/or other materials provided with the distribution. * * THIS SOFTWARE IS PROVIDED BY THE NETBSD FOUNDATION, INC. AND CONTRIBUTORS * ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED * TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR * PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE FOUNDATION OR CONTRIBUTORS * BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR * CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF * SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS * INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN * CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) * ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE * POSSIBILITY OF SUCH DAMAGE. */ #ifndef _DEV_PCI_PCIIDE_OPTI_REG_H_ #define _DEV_PCI_PCIIDE_OPTI_REG_H_ /* * Register definitions for OPTi PCIIDE controllers based on * their 82c621 chip. */ /* IDE Initialization Control Register */ #define OPTI_REG_INIT_CONTROL 0x40 #define OPTI_INIT_CONTROL_MODE_PIO_0 0 #define OPTI_INIT_CONTROL_MODE_PIO_1 2 #define OPTI_INIT_CONTROL_MODE_PIO_2 1 #define OPTI_INIT_CONTROL_MODE_PIO_3 3 #define OPTI_INIT_CONTROL_ADDR_RELOC (1u << 2) #define OPTI_INIT_CONTROL_CH2_ENABLE 0 #define OPTI_INIT_CONTROL_CH2_DISABLE (1u << 3) #define OPTI_INIT_CONTROL_FIFO_16 0 #define OPTI_INIT_CONTROL_FIFO_32 (1u << 5) #define OPTI_INIT_CONTROL_FIFO_REQ_32 0 #define OPTI_INIT_CONTROL_FIFO_REQ_30 (1u << 6) #define OPTI_INIT_CONTROL_FIFO_REQ_28 (2u << 6) #define OPTI_INIT_CONTROL_FIFO_REQ_26 (3u << 6) /* IDE Enhanced Features Register */ #define OPTI_REG_ENH_FEAT 0x42 #define OPTI_ENH_FEAT_X111_ENABLE (1u << 1) #define OPTI_ENH_FEAT_CONCURRENT_MAST (1u << 2) #define OPTI_ENH_FEAT_PCI_INVALIDATE (1u << 3) #define OPTI_ENH_FEAT_IDE_CONCUR (1u << 4) #define OPTI_ENH_FEAT_SLAVE_FIFO_ISA (1u << 5) /* IDE Enhanced Mode Register */ #define OPTI_REG_ENH_MODE 0x43 #define OPTI_ENH_MODE_MASK(c,d) (3u << (((c) * 4) + ((d) * 2))) #define OPTI_ENH_MODE_USE_TIMING(c,d) 0 #define OPTI_ENH_MODE(c,d,m) ((m) << (((c) * 4) + ((d) * 2))) /* Timing registers */ #define OPTI_REG_READ_CYCLE_TIMING 0x00 #define OPTI_REG_WRITE_CYCLE_TIMING 0x01 #define OPTI_RECOVERY_TIME_SHIFT 0 #define OPTI_PULSE_WIDTH_SHIFT 4 /* * Control register. */ #define OPTI_REG_CONTROL 0x03 #define OPTI_CONTROL_DISABLE 0x11 #define OPTI_CONTROL_ENABLE 0x95 /* Strap register */ #define OPTI_REG_STRAP 0x05 #define OPTI_STRAP_PCI_SPEED_MASK 0x1u #define OPTI_STRAP_PCI_33 0 #define OPTI_STRAP_PCI_25 1 /* Miscellaneous register */ #define OPTI_REG_MISC 0x06 #define OPTI_MISC_INDEX(d) ((unsigned)(d)) #define OPTI_MISC_INDEX_MASK 0x01u #define OPTI_MISC_DELAY_MASK 0x07u #define OPTI_MISC_DELAY_SHIFT 1 #define OPTI_MISC_ADDR_SETUP_MASK 0x3u #define OPTI_MISC_ADDR_SETUP_SHIFT 4 #define OPTI_MISC_READ_PREFETCH_ENABLE (1u << 6) #define OPTI_MISC_ADDR_SETUP_MASK 0x3u #define OPTI_MISC_WRITE_MASK 0x7fu /* * These are the timing register values for the various IDE modes * supported by the OPTi chip. The first index of the two-dimensional * arrays is used for a 33MHz PCIbus, the second for a 25MHz PCIbus. */ static const u_int8_t opti_tim_cp[2][8] = { /* Command Pulse */ {5, 4, 3, 2, 2, 7, 2, 2}, {4, 3, 2, 2, 1, 5, 2, 1} }; static const u_int8_t opti_tim_rt[2][8] = { /* Recovery Time */ {9, 4, 0, 0, 0, 6, 0, 0}, {6, 2, 0, 0, 0, 4, 0, 0} }; static const u_int8_t opti_tim_as[2][8] = { /* Address Setup */ {2, 1, 1, 1, 0, 0, 0, 0}, {1, 1, 0, 0, 0, 0, 0, 0} }; static const u_int8_t opti_tim_em[8] = { /* Enhanced Mode */ 0, 0, 0, 1, 2, 0, 1 ,2 }; #endif /* !_DEV_PCI_PCIIDE_OPTI_REG_H_ */