.\" $OpenBSD: faithd.8,v 1.6 2000/05/31 03:09:22 itojun Exp $ .\" $KAME: faithd.8,v 1.9 2000/05/31 03:06:07 itojun Exp $ .\" .\" Copyright (C) 1995, 1996, 1997, and 1998 WIDE Project. .\" All rights reserved. .\" .\" Redistribution and use in source and binary forms, with or without .\" modification, are permitted provided that the following conditions .\" are met: .\" 1. Redistributions of source code must retain the above copyright .\" notice, this list of conditions and the following disclaimer. .\" 2. Redistributions in binary form must reproduce the above copyright .\" notice, this list of conditions and the following disclaimer in the .\" documentation and/or other materials provided with the distribution. .\" 3. Neither the name of the project nor the names of its contributors .\" may be used to endorse or promote products derived from this software .\" without specific prior written permission. .\" .\" THIS SOFTWARE IS PROVIDED BY THE PROJECT AND CONTRIBUTORS ``AS IS'' AND .\" ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE .\" IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE .\" ARE DISCLAIMED. IN NO EVENT SHALL THE PROJECT OR CONTRIBUTORS BE LIABLE .\" FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL .\" DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS .\" OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) .\" HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT .\" LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY .\" OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF .\" SUCH DAMAGE. .\" .Dd May 17, 1998 .Dt FAITHD 8 .Os .Sh NAME .Nm faithd .Nd FAITH IPv6/v4 translator daemon .Sh SYNOPSIS .Nm .Op Fl dp .Op Ar service Op Ar serverpath Op Ar serverargs .Sh DESCRIPTION .Nm provides IPv6/v4 TCP relay for the specified .Ar service . .Pp .Nm must be invoked on IPv4/v6 dual stack router. The router must be configured to capture all the TCP traffic toward reserved .Tn IPv6 address prefix, by using .Xr route 8 and .Xr sysctl 8 commands. .Nm will daemonize itself on invocation. .Pp .Nm will listen to .Tn TCPv6 port .Ar service . If .Tn TCPv6 traffic to port .Ar service is found, .Nm will relay the .Tn TCPv6 traffic to .Tn TCPv4 . Destination for relayed .Tn TCPv4 connection will be determined by the last 4 octets of the original .Tn IPv6 destination. For example, if .Li 3ffe:0501:4819:ffff:: is reserved for .Nm Ns , and the .Tn TCPv6 destination address is .Li 3ffe:0501:4819:ffff::0a01:0101 , the traffic will be relayed to IPv4 destination .Li 10.1.1.1 . .Pp If .Ar service is not given, .Li telnet is assumed, and .Nm will relay TCP traffic on TCP port .Li telnet . With .Ar service , .Nm will work as TCP relaying daemon for specified .Ar service as described above. .Pp Since .Nm listens to TCP port .Ar service , it is not possible to run local TCP daemons for port .Ar service on the router, using .Xr inetd 8 or other standard mechanisms. By specifying .Ar serverpath to .Nm Ns , you can run local daemons on the router. .Nm will invoke local daemon at .Ar serverpath if the destination address is local interface address, and will perform translation to IPv4 TCP in other cases. You can also specify .Ar serverargs for the arguments for the local daemon. .Pp To use .Nm translation service, an IPv6 address prefix must be reserved for mapping IPv4 addresses into. Kernel must be properly configured to route all the TCP connection toward the reserved IPv6 address prefix into the .Dv faith pseudo interface, by using .Xr route 8 command. Also, .Xr sysctl 8 should be used to configure .Dv net.inet6.ip6.keepfaith to .Dv 1 . .Pp If .Fl d is given, debugging information will be generated using .Xr syslog 3 . If .Fl p is given, .Nm will use privileged TCP port number as source port, for IPv4 TCP connection toward final destination. For relaying .Xr ftp 1 and .Xr rlogin 1 , .Fl p is not necessary as special program code is supplied. .Pp .Nm will relay both normal and out-of-band TCP data. It is capable of emulating TCP half close as well. .Nm includes special support for protocols used by .Xr ftp 1 and .Xr rlogin 1 . When translating FTP protocol, .Nm translates network level addresses in .Li PORT/LPRT/EPRT and .Li PASV/LPSV/EPSV commands. For RLOGIN protocol, .Nm will relay back connection from .Xr rlogind 8 on the server to .Xr rlogin 1 on client. .Pp Inactive sessions will be disconnected in 30 minutes, to avoid stale sessions from chewing up resources. This may be inappropriate for some of the services .Pq should this be configurable? . .Sh EXAMPLES Before invoking .Nm Ns , .Xr faith 4 interface has to be configured properly. .Pp To translate .Li telnet service, and provide no local telnet service, invoke .Nm as either of the following: .Bd -literal -offset # faithd # faithd telnet .Ed .Pp If you would like to provide local telnet service via .Xr telnetd 8 on .Pa /usr/libexec/telnetd , user the following command line: .Bd -literal -offset # faithd telnet /usr/libexec/telnetd telnetd .Ed .Pp If you would like to pass extra arguments to the local daemon: .Bd -literal -offset # faithd ftpd /usr/libexec/ftpd ftpd -l .Ed .Pp Here are some other examples: .Bd -literal -offset # faithd login /usr/libexec/rlogin rlogind # faithd shell /usr/libexec/rshd rshd # faithd sshd .Ed .Sh RETURN VALUES .Nm exits with .Dv EXIT_SUCCESS .Pq 0 on success, and .Dv EXIT_FAILURE .Pq 1 on error. .Sh SEE ALSO .Xr faith 4 , .Xr route 8 , .Xr sysctl 8 .Rs .%A Jun-ichiro itojun Hagino .%A Kazu Yamamoto .%T "An IPv6-to-IPv4 transport relay translator" .%R internet draft .%N draft-ietf-ngtrans-tcpudp-relay-01.txt .%O work in progress material .Re .Sh SECURITY NOTICE It is very insecure to use .Xr rhosts 5 and other IP-address based authentication, for connections relayed by .Nm .Pq and any other TCP relaying services . .Pp .Nm itself does not implement access controls, as it intends to implement transparent TCP relay services. Administrators are advised to filter packets based on IPv6 address. IPv6 destination address can be limited by carefully configuring routing entries that points to .Xr faith 4 , using .Xr route 8 . IPv6 source address needs to be filtered by using packet filters. Documents listed in .Sx SEE ALSO have more discussions on this topic. .\" .Sh HISTORY The .Nm command first appeared in WIDE Hydrangea IPv6 protocol stack kit.