.\"	$OpenBSD: ndp.8,v 1.31 2013/10/21 12:41:52 jmc Exp $
.\"	$KAME: ndp.8,v 1.28 2002/07/17 08:46:33 itojun Exp $
.\"
.\" Copyright (C) 1995, 1996, 1997, and 1998 WIDE Project.
.\" All rights reserved.
.\"
.\" Redistribution and use in source and binary forms, with or without
.\" modification, are permitted provided that the following conditions
.\" are met:
.\" 1. Redistributions of source code must retain the above copyright
.\"    notice, this list of conditions and the following disclaimer.
.\" 2. Redistributions in binary form must reproduce the above copyright
.\"    notice, this list of conditions and the following disclaimer in the
.\"    documentation and/or other materials provided with the distribution.
.\" 3. Neither the name of the project nor the names of its contributors
.\"    may be used to endorse or promote products derived from this software
.\"    without specific prior written permission.
.\"
.\" THIS SOFTWARE IS PROVIDED BY THE PROJECT AND CONTRIBUTORS ``AS IS'' AND
.\" ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
.\" IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE
.\" ARE DISCLAIMED.  IN NO EVENT SHALL THE PROJECT OR CONTRIBUTORS BE LIABLE
.\" FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL
.\" DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS
.\" OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
.\" HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
.\" LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY
.\" OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF
.\" SUCH DAMAGE.
.\"
.Dd $Mdocdate: October 21 2013 $
.Dt NDP 8
.Os
.\"
.Sh NAME
.Nm ndp
.Nd control/diagnose IPv6 Neighbor Discovery Protocol (NDP)
.\"
.Sh SYNOPSIS
.Nm ndp
.Bk -words
.Op Fl nrt
.Op Fl a | c | p
.Op Fl H | P | R
.Op Fl A Ar wait
.Op Fl d Ar hostname
.Op Fl f Ar filename
.Op Fl i Ar interface Op Ar flag ...
.Op Fl s Ar nodename etheraddr Oo Ic temp Oc Op Ic proxy
.Op Fl V Ar rdomain
.Op Ar hostname
.Ek
.\"
.Sh DESCRIPTION
The
.Nm
command manipulates the address mapping table
used by the Neighbor Discovery Protocol (NDP).
.Bl -tag -width Ds
.It Fl A Ar wait
Repeat
.Fl a
.Pq dump NDP entries
every
.Ar wait
seconds.
.It Fl a
Dump the currently existing NDP entries.
The following information will be printed:
.Bl -tag -width Ds -offset 3n
.It Neighbor
The IPv6 address of the neighbor.
.It Linklayer Address
The linklayer address of the neighbor.
If the address is not available,
it will be displayed as
.Dq (incomplete) .
.It Netif
The network interface associated with the neighbor cache entry.
.It Expire
The time until expiry of the entry.
If the entry is marked
.Dq permanent ,
it will never expire.
.It S
The state of the neighbor cache entry, as a single letter:
.Pp
.Bl -tag -width Ds -offset 3n -compact
.It D
Delay
.It I
Incomplete
.It N
Nostate
.It P
Probe
.It R
Reachable
.It S
Stale
.It W
Waitdelete
.It \&?
Unknown state (should never happen).
.El
.It Flags
Flags on the neighbor cache entry, in a single letter.
They are: Router
.Pq Sq R
and proxy neighbor advertisement
.Pq Sq p .
This field may be followed by a decimal number,
representing the number of NS probes
the node has sent during the current state.
.El
.It Fl c
Erase all the NDP entries.
.It Fl d Ar hostname
Delete the specified NDP entry.
.It Fl f Ar filename
Parse the file specified by
.Ar filename .
.It Fl H
Harmonize consistency between the routing table and the default router
list; install the top entry of the list into the kernel routing table.
.It Fl i Ar interface Op Ar flag ...
View ND information for the specified interface.
If additional arguments are given,
.Nm
sets or clears the specified flags for the interface.
Each flag should be separated by whitespace or tab characters.
Possible flags are as follows.
All of the flags can begin with the
special character
.Ql - ,
which means the flag should be cleared.
Note that
.Fl -
would be needed before
.Fl foo
in this case.
.\"
.Bl -tag -width Ds
.It Ic nud
Turn on or off NUD (Neighbor Unreachability Detection) on the
interface.
NUD is usually turned on by default.
.It Ic accept_rtadv
Specify whether or not to accept Router Advertisement messages
received on the
.Ar interface .
Note that the kernel does not accept Router Advertisement messages
unless the
.Li net.inet6.ip6.accept_rtadv
variable is non-0, even if the flag is on.
This flag is set to 1 by default.
See
.Xr sysctl 8
and
.Xr sysctl.conf 5
for further details on how to set the
.Li net.inet6.ip6.accept_rtadv
variable.
.\".It Xo
.\".Ic prefer_source
.\".Xc
.\"Prefer addresses on the
.\".Ar interface
.\"as candidates of the source address for outgoing packets.
.\"The default value of this flag is off.
.\"For more details about the entire algorithm of source address
.\"selection, see the
.\".Pa IMPLEMENTATION
.\"file supplied with the KAME kit.
.El
.It Fl n
Do not try to resolve numeric addresses to hostnames.
.It Fl P
Flush all the entries in the prefix list.
.It Fl p
Show the prefix list.
.It Fl R
Flush all the entries in the default router list.
.It Fl r
Show the default router list.
.It Xo
.Fl s Ar nodename etheraddr
.Op Cm temp
.Op Cm proxy
.Xc
Register an NDP entry for a node.
The entry will be permanent unless the word
.Cm temp
is given in the command.
If the word
.Cm proxy
is given, this system will act as a proxy NDP server,
responding to requests for
.Ar hostname
even though the host address is not its own.
.It Fl t
Print a timestamp on each entry,
making it possible to merge output with
.Xr tcpdump 8 .
Most useful when used with
.Fl A .
.It Fl V Ar rdomain
Set the routing domain to be used.
The default is 0.
.El
.Sh EXIT STATUS
.Ex -std ndp
.\"
.Sh SEE ALSO
.Xr ip6 4 ,
.Xr sysctl.conf 5 ,
.Xr arp 8 ,
.Xr sysctl 8 ,
.Xr tcpdump 8
.\"
.Sh HISTORY
The
.Nm
command first appeared in the WIDE Hydrangea IPv6 protocol stack kit.
.\"
.\" .Sh BUGS
.\" (to be written)