blob: a44f0c49f1c5f46a01533a00375583b2a1c3f42c (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
|
dnl $OpenBSD: prep,v 1.8 2016/05/29 13:50:13 jsg Exp $
Please be aware that OpenBSD support for this platform is far from
complete.
OpenBSD can be installed onto a disk by copying the miniroot for your
board "miniroot-board-{:--:}OSrev.fs" image to an SD card.
Booting from an SD card:
To use the miniroot image you will need another machine to plug the
SD card in to. Any machine type will do, as long as it supports SD card
storage devices. Under OpenBSD, it will appear as a ``sd'' device, for
example sd1.
Use the dd(1) utility to copy the miniroot to the hard drive.
The command would likely be, under OpenBSD:
dd if=miniroot-beagle-{:--:}OSrev.fs of=/dev/rsd1c
When you have connected the BeagleBoard to you computer, a command such
as "cu -l cuaU0 -s 115200" (assuming cuaU0 is your serial port device)
should connect you to the board's console.
Note: By default the BeagleBone Black will boot from the internal emmc.
In order to make it boot from the micro SD card, you will need to hold down
the small button located by the SD card slot while powering on the board.
Once you have done this the board will boot from the SD card as the default.
|
