blob: 697a921b27a905feeb9621daaa1b498ead484efe (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
|
/* $OpenBSD: pcctworeg.h,v 1.3 2001/12/13 08:55:51 smurph Exp $ */
/*
* Memory map for PCC2 chip found in mvme1x7 boards.
*
* PCCchip2 control and status register can be accessed as bytes (8 bits),
* two-bytes (16 bits), or four-bytes (32 bits).
*/
struct pcctworeg {
volatile u_char pcc2_chipid;
volatile u_char pcc2_chiprev;
volatile u_char pcc2_genctl;
volatile u_char pcc2_vecbase; /* irq vector base */
volatile u_long pcc2_t1cmp; /* timer1 compare */
volatile u_long pcc2_t1count; /* timer1 count */
volatile u_long pcc2_t2cmp; /* timer2 compare */
volatile u_long pcc2_t2count; /* timer2 count */
volatile u_char pcc2_pscalecnt; /* timer prescaler counter */
volatile u_char pcc2_pscaleadj; /* timer prescaler adjust */
volatile u_char pcc2_t2ctl; /* timer2 ctrl reg */
volatile u_char pcc2_t1ctl; /* timer1 ctrl reg */
volatile u_char pcc2_gpioirq; /* gpio irq */
volatile u_char pcc2_gpio; /* gpio i/o */
volatile u_char pcc2_t2irq;
volatile u_char pcc2_t1irq;
volatile u_char pcc2_sccerr;
volatile u_char pcc2_sccirq;
volatile u_char pcc2_scctx;
volatile u_char pcc2_sccrx;
volatile u_char :8;
volatile u_char :8;
volatile u_char :8;
volatile u_char pcc2_sccmoiack;
volatile u_char :8;
volatile u_char pcc2_scctxiack;
volatile u_char :8;
volatile u_char pcc2_sccrxiack;
volatile u_char pcc2_ieerr;
volatile u_char :8;
volatile u_char pcc2_ieirq;
volatile u_char pcc2_iefailirq;
volatile u_char pcc2_ncrerr;
volatile u_char :8;
volatile u_char :8;
volatile u_char pcc2_ncrirq;
volatile u_char pcc2_prtairq;
volatile u_char pcc2_prtfirq;
volatile u_char pcc2_prtsirq;
volatile u_char pcc2_prtpirq;
volatile u_char pcc2_prtbirq;
volatile u_char :8;
volatile u_char pcc2_prtstat;
volatile u_char pcc2_prtctl;
volatile u_short pcc2_speed; /* DO NOT USE */
volatile u_short pcc2_prtdat;
volatile u_short :16;
/* The following regs are not valid on MVME197 */
volatile u_char pcc2_ipl;
volatile u_char pcc2_mask;
};
#define PCC2_PCC2CHIP_OFF 0x42000
#define PCC2_CHIPID 0x20
#define PCC2_BASE_ADDR 0xFFF42000 /* base address */
#define PCC2_SIZE 0x1000 /* size */
#define PCC2_CHIP_REV 0x00
/* General Control Register */
#define PCC2_DR0 0x80
#define PCC2_C040 0x04
#define PCC2_MIEN 0x02
#define PCC2_FAST 0x01
/* Top 4 bits of the PCC2 VBR. Will be the top 4 bits of the vector */
#define PCC2_VECT 0x50
/* Bottom 4 bits of the vector returned during IACK cycle */
#define PPBSY 0x00 /* lowest */
#define PPSE 0x01
#define PPSEL 0x02
#define PPFLT 0x03
#define PPACK 0x04
#define SCSIIRQ 0x05
#define LANCERR 0x06
#define LANCIRQ 0x07
#define TIMER1IRQ 0x08
#define TIMER2IRQ 0x09
#define GPIOIRQ 0x0a
#define SRXEIRQ 0x0c
#define SMOIRQ 0x0d
#define STxIRQ 0x0e
#define SRxIRQ 0x0f
/*
* Vaddrs for interrupt mask and pri registers
*/
extern volatile u_char *pcc2intr_mask;
extern volatile u_char *pcc2intr_ipl;
/*
* points to system's PCCTWO. This is not active until the pcctwo0
* device has been attached.
*/
extern struct pcctworeg *sys_pcc2;
/*
* We lock off our interrupt vector at 0x50.
*/
#define PCC2_VECBASE 0x50
#define PCC2_NVEC 16
/*
* Vectors we use
*/
#define PCC2V_NCR 0x05
#define PCC2V_IEFAIL 0x06
#define PCC2V_IE 0x07
#define PCC2V_TIMER2 0x08
#define PCC2V_TIMER1 0x09
#define PCC2V_GPIO 0x0a
#define PCC2V_SCC_RXE 0x0c
#define PCC2V_SCC_M 0x0d
#define PCC2V_SCC_TX 0x0e
#define PCC2V_SCC_RX 0x0f
#define PCC2_TCTL_CEN 0x01
#define PCC2_TCTL_COC 0x02
#define PCC2_TCTL_COVF 0x04
#define PCC2_TCTL_OVF 0xf0
#define PCC2_TICTL_CEN 0x01
#define PCC2_TICTL_COC 0x02
#define PCC2_TICTL_COVF 0x04
#define PCC2_TTCTL_OVF_MASK (1 << 4) /* overflow bits mask */
#define PCC2_GPIO_PLTY 0x80
#define PCC2_GPIO_EL 0x40
#define PCC2_GPIOCR_OE 0x2
#define PCC2_GPIOCR_O 0x1
#define PCC2_SCC_AVEC 0x08
#define PCC2_SCCRX_INHIBIT (0 << 6)
#define PCC2_SCCRX_SNOOP (1 << 6)
#define PCC2_SCCRX_INVAL (2 << 6)
#define PCC2_SCCRX_RESV (3 << 6)
#define pcc2_timer_us2lim(us) (us) /* timer increments in "us" */
#define PCC2_IRQ_IPL 0x07
#define PCC2_IRQ_ICLR 0x08
#define PCC2_IRQ_IEN 0x10
#define PCC2_IRQ_INT 0x20
/* Tick Timer Interrupt Control Register */
#define PCC2_TTIRQ_INT 0x20
#define PCC2_TTIRQ_IEN 0x10
#define PCC2_TTIRQ_ICLR 0x08
#define PCC2_TTIRQ_IL 0x07 /* mask for IL2-IL0 */
#define PCC2_IEERR_SCLR 0x01
#define PCC2_GENCTL_FAST 0x01
#define PCC2_GENCTL_IEN 0x02
#define PCC2_GENCTL_C040 0x03
#define PCC2_SC_INHIBIT (0 << 6)
#define PCC2_SC_SNOOP (1 << 6)
#define PCC2_SC_INVAL (2 << 6)
#define PCC2_SC_RESV (3 << 6)
|
