1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
|
/* $OpenBSD: ebusreg.h,v 1.4 2001/10/01 18:08:04 jason Exp $ */
/* $NetBSD: ebusreg.h,v 1.1 1999/06/04 13:29:13 mrg Exp $ */
/*
* Copyright (c) 1999 Matthew R. Green
* All rights reserved.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
* 1. Redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer.
* 2. Redistributions in binary form must reproduce the above copyright
* notice, this list of conditions and the following disclaimer in the
* documentation and/or other materials provided with the distribution.
* 3. The name of the author may not be used to endorse or promote products
* derived from this software without specific prior written permission.
*
* THIS SOFTWARE IS PROVIDED BY THE AUTHOR ``AS IS'' AND ANY EXPRESS OR
* IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES
* OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED.
* IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR ANY DIRECT, INDIRECT,
* INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING,
* BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES;
* LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED
* AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY,
* OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY
* OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF
* SUCH DAMAGE.
*/
#ifndef _SPARC64_DEV_EBUSREG_H_
#define _SPARC64_DEV_EBUSREG_H_
/*
* UltraSPARC `ebus'
*
* The `ebus' bus is designed to plug traditional PC-ISA devices into
* an SPARC system with as few costs as possible, without sacrificing
* to performance. Typically, it is implemented in the PCIO IC from
* SME, which also implements a `hme-compatible' PCI network device
* (`network'). The ebus has 4 DMA channels, similar to the DMA seen
* in the ESP SCSI DMA.
*
* Typical UltraSPARC systems have a NatSemi SuperIO IC to provide
* serial ports for the keyboard and mouse (`se'), floppy disk
* controller (`fdthree'), parallel port controller (`bpp') connected
* to the ebus, and a PCI-IDE controller (connected directly to the
* PCI bus, of course), as well as a Siemens Nixdorf SAB82532 dual
* channel serial controller (`su' providing ttya and ttyb), an MK48T59
* EEPROM/clock controller (also where the idprom, including the
* ethernet address, is located), the audio system (`SUNW,CS4231', same
* as other UltraSPARC and some SPARC systems), and other various
* internal devices found on traditional SPARC systems such as the
* `power', `flashprom', etc., devices.
*
* The ebus uses an interrupt mapping scheme similar to PCI, though
* the actual structures are different.
*/
/*
* ebus PROM structures
*/
struct ebus_regs {
u_int32_t hi; /* high bits of physaddr */
u_int32_t lo;
u_int32_t size;
};
#define EBUS_PADDR_FROM_REG(reg) ((((paddr_t)((reg)->hi)) << 32UL) | ((paddr_t)(reg)->lo))
struct ebus_ranges {
u_int32_t child_hi; /* child high phys addr */
u_int32_t child_lo; /* child low phys addr */
u_int32_t phys_hi; /* parent high phys addr */
u_int32_t phys_mid; /* parent mid phys addr */
u_int32_t phys_lo; /* parent low phys addr */
u_int32_t size;
};
struct ebus_interrupt_map {
u_int32_t hi; /* high phys addr mask */
u_int32_t lo; /* low phys addr mask */
u_int32_t intr; /* interrupt mask */
int32_t cnode; /* child node */
u_int32_t cintr; /* child interrupt */
};
struct ebus_interrupt_map_mask {
u_int32_t hi; /* high phys addr */
u_int32_t lo; /* low phys addr */
u_int32_t intr; /* interrupt */
};
/* EBUS dma registers */
#define EBDMA_DCSR 0x0 /* control/status */
#define EBDMA_DADDR 0x4 /* DMA address */
#define EBDMA_DCNT 0x8 /* DMA count */
/* EBUS DMA control/status (EBDMA_DCSR) */
#define EBDCSR_INT 0x00000001 /* interrupt pending */
#define EBDCSR_ERR 0x00000002 /* error pending */
#define EBDCSR_DRAIN 0x00000004 /* drain */
#define EBDCSR_INTEN 0x00000010 /* interrupt enable */
#define EBDCSR_RESET 0x00000080 /* reset */
#define EBDCSR_WRITE 0x00000100 /* write */
#define EBDCSR_DMAEN 0x00000200 /* dma enable */
#define EBDCSR_CYC 0x00000400 /* cyc pending */
#define EBDCSR_DIAGRD 0x00000800 /* diagnostic read done */
#define EBDCSR_DIAGWR 0x00001000 /* diagnostic write done */
#define EBDCSR_CNTEN 0x00002000 /* count enable */
#define EBDCSR_TC 0x00004000 /* terminal count */
#define EBDCSR_CSRDRNDIS 0x00010000 /* disable csr drain */
#define EBDCSR_BURSTMASK 0x000c0000 /* burst size mask */
#define EBDCSR_BURST_1 0x00080000 /* burst 1 */
#define EBDCSR_BURST_4 0x00000000 /* burst 4 */
#define EBDCSR_BURST_8 0x00040000 /* burst 8 */
#define EBDCSR_BURST_16 0x000c0000 /* burst 16 */
#define EBDCSR_DIAGEN 0x00100000 /* enable diagnostics */
#define EBDCSR_ERRDIS 0x00400000 /* disable error pending */
#define EBDCSR_TCIDIS 0x00800000 /* disable TCI */
#define EBDCSR_NEXTEN 0x01000000 /* enable next */
#define EBDCSR_DMAON 0x02000000 /* dma on */
#define EBDCSR_A_LOADED 0x04000000 /* address loaded */
#define EBDCSR_NA_LOADED 0x08000000 /* next address loaded */
#define EBDCSR_DEVMASK 0xf0000000 /* device id mask */
#endif /* _SPARC64_DEV_EBUSREG_H_ */
|
