1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
|
/* $OpenBSD: ubsecreg.h,v 1.7 2000/08/13 22:06:48 deraadt Exp $ */
/*
* Copyright (c) 2000 Theo de Raadt
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
*
* 1. Redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer.
* 2. Redistributions in binary form must reproduce the above copyright
* notice, this list of conditions and the following disclaimer in the
* documentation and/or other materials provided with the distribution.
* 3. The name of the author may not be used to endorse or promote products
* derived from this software without specific prior written permission.
*
* THIS SOFTWARE IS PROVIDED BY THE AUTHOR ``AS IS'' AND ANY EXPRESS OR
* IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES
* OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED.
* IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR ANY DIRECT, INDIRECT,
* INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT
* NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE,
* DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY
* THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
* (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF
* THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
*/
/*
* Register definitions for 5601 BlueSteel Networks Ubiquitous Broadband
* Security "uBSec" chip. Definitions from revision 2.8 of the product
* datasheet.
*/
#define BS_BAR 0x10 /* DMA and status base address register */
/*
* DMA Control & Status Registers (offset from BS_BAR)
*/
#define BS_MCR1 0x00 /* DMA Master Command Record 1 */
#define BS_CTRL 0x04 /* DMA Control */
#define BS_STAT 0x08 /* DMA Status */
#define BS_ERR 0x0c /* DMA Error Address */
#define BS_MCR2 0x10 /* DMA Master Command Record 2 */
/* BS_CTRL - DMA Control */
#define BS_CTRL_MCR2INT 0x40000000 /* enable intr MCR for MCR2 */
#define BS_CTRL_MCR1INT 0x20000000 /* enable intr MCR for MCR1 */
#define BS_CTRL_OFM 0x10000000 /* Output fragment mode */
#define BS_CTRL_BE32 0x08000000 /* big-endian, 32bit bytes */
#define BS_CTRL_BE64 0x04000000 /* big-endian, 64bit bytes */
#define BS_CTRL_DMAERR 0x02000000 /* enable intr DMA error */
#define BS_CTRL_RNG_M 0x01800000 /* RND mode */
#define BS_CTRL_RNG_1 0x00000000 /* 1bit rn/one slow clock */
#define BS_CTRL_RNG_4 0x00800000 /* 1bit rn/four slow clocks */
#define BS_CTRL_RNG_8 0x01000000 /* 1bit rn/eight slow clocks */
#define BS_CTRL_RNG_16 0x01800000 /* 1bit rn/16 slow clocks */
#define BS_CTRL_FRAG_M 0x0000ffff /* output fragment size mask */
/* BS_STAT - DMA Status */
#define BS_STAT_MCR1_BUSY 0x80000000 /* MCR1 is busy */
#define BS_STAT_MCR1_FULL 0x40000000 /* MCR1 is full */
#define BS_STAT_MCR1_DONE 0x20000000 /* MCR1 is done */
#define BS_STAT_DMAERR 0x10000000 /* DMA error */
#define BS_STAT_MCR2_FULL 0x08000000 /* MCR2 is full */
#define BS_STAT_MCR2_DONE 0x04000000 /* MCR2 is done */
/* BS_ERR - DMA Error Address */
#define BS_ERR_READ 0x00000001 /* fault was on read */
#define UBSEC_CARD(sid) (((sid) & 0xf0000000) >> 28)
#define UBSEC_SESSION(sid) ( (sid) & 0x0fffffff)
#define UBSEC_SID(crd, sesn) (((crd) << 28) | ((sesn) & 0x0fffffff))
#define MAX_SCATTER 64
struct ubsec_pktctx {
u_int32_t pc_deskey[6]; /* 3DES key */
u_int32_t pc_hminner[5]; /* hmac inner state */
u_int32_t pc_hmouter[5]; /* hmac outer state */
u_int32_t pc_iv[2]; /* [3]DES iv */
u_int16_t pc_flags; /* flags, below */
u_int16_t pc_offset; /* crypto offset */
u_int32_t pc_paddr;
u_int8_t pad[16];
};
#define UBS_PKTCTX_ENC_3DES 0x8000 /* use 3des */
#define UBS_PKTCTX_ENC_NONE 0x0000 /* no encryption */
#define UBS_PKTCTX_INBOUND 0x4000 /* inbound packet */
#define UBS_PKTCTX_AUTH 0x3000 /* authentication mask */
#define UBS_PKTCTX_AUTH_NONE 0x0000 /* no authentication */
#define UBS_PKTCTX_AUTH_MD5 0x1000 /* use hmac-md5 */
#define UBS_PKTCTX_AUTH_SHA1 0x2000 /* use hmac-sha1 */
struct ubsec_pktbuf {
volatile u_int32_t pb_addr; /* address of buffer start */
volatile u_int32_t pb_next; /* pointer to next pktbuf */
volatile u_int32_t pb_len; /* packet length */
};
#define UBS_PKTBUF_LEN 0x0000ffff /* length mask */
struct ubsec_mcr {
volatile u_int16_t mcr_pkts; /* #pkts in this mcr */
volatile u_int16_t mcr_flags; /* mcr flags (below) */
volatile u_int32_t mcr_cmdctxp; /* command ctx pointer */
struct ubsec_pktbuf mcr_ipktbuf; /* input chain header */
volatile u_int16_t mcr_reserved;
volatile u_int16_t mcr_pktlen;
struct ubsec_pktbuf mcr_opktbuf; /* output chain header */
};
struct ubsec_mcr_add {
volatile u_int32_t mcr_cmdctxp; /* command ctx pointer */
struct ubsec_pktbuf mcr_ipktbuf; /* input chain header */
volatile u_int16_t mcr_reserved;
volatile u_int16_t mcr_pktlen;
struct ubsec_pktbuf mcr_opktbuf; /* output chain header */
};
#define UBS_MCR_DONE 0x0001 /* mcr has been processed */
#define UBS_MCR_ERROR 0x0002 /* error in processing */
#define UBS_MCR_ERRORCODE 0xff00 /* error type */
|
