1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
|
/* $OpenBSD: yukonreg.h,v 1.1 2003/08/01 04:46:13 nate Exp $ */
/*
* Copyright (c) 2003 Nathan L. Binkert
* All rights reserved.
*
* Permission to redistribute, use, copy, and modify this software
* without fee is hereby granted, provided that the following
* conditions are met:
*
* 1. This entire notice is included in all source code copies of any
* software which is or includes a copy or modification of this
* software.
* 2. The name of the author may not be used to endorse or promote
* products derived from this software without specific prior
* written permission.
*
* THIS SOFTWARE IS PROVIDED BY THE AUTHOR ``AS IS'' AND ANY EXPRESS
* OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED
* WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE
* ARE DISCLAIMED. IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR ANY
* DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL
* DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE
* GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS
* INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY,
* WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING
* NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS
* SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
*/
/* General Purpose Status Register (GPSR) */
#define YUKON_GPSR 0x0000
#define YU_GPSR_SPEED 0x8000 /* speed 0 - 10Mbps, 1 - 100Mbps */
#define YU_GPSR_DUPLEX 0x4000 /* 0 - half duplex, 1 - full duplex */
#define YU_GPSR_FCTL_TX 0x2000 /* flow control */
#define YU_GPSR_LINK 0x1000 /* link status (down/up) */
#define YU_GPSR_PAUSE 0x0800 /* flow control enable/disable */
#define YU_GPSR_TX_IN_PROG 0x0400 /* transmit in progress */
#define YU_GPSR_EXCESS_COL 0x0200 /* excessive collisions occurred */
#define YU_GPSR_LATE_COL 0x0100 /* late collision occurred */
#define YU_GPSR_MII_PHY_STC 0x0020 /* MII PHY status change */
#define YU_GPSR_GIG_SPEED 0x0010 /* Gigabit Speed (0 - use speed bit) */
#define YU_GPSR_PARTITION 0x0008 /* partition mode */
#define YU_GPSR_FCTL_RX 0x0004 /* flow control enable/disable */
#define YU_GPSR_PROMS_EN 0x0002 /* promiscuous mode enable/disable */
/* General Purpose Control Register (GPCR) */
#define YUKON_GPCR 0x0004
#define YU_GPCR_FCTL_TX 0x2000 /* Transmit flow control 802.3x */
#define YU_GPCR_TXEN 0x1000 /* Transmit Enable */
#define YU_GPCR_RXEN 0x0800 /* Receive Enable */
#define YU_GPCR_LPBK 0x0200 /* Loopback Enable */
#define YU_GPCR_PAR 0x0100 /* Partition Enable */
#define YU_GPCR_GIG 0x0080 /* Gigabit Speed */
#define YU_GPCR_FLP 0x0040 /* Force Link Pass */
#define YU_GPCR_DUPLEX 0x0020 /* Duplex Enable */
#define YU_GPCR_FCTL_RX 0x0010 /* Receive flow control 802.3x */
#define YU_GPCR_SPEED 0x0008 /* Port Speed */
#define YU_GPCR_DPLX_EN 0x0004 /* Enable Auto-Update for duplex */
#define YU_GPCR_FCTL_EN 0x0002 /* Enabel Auto-Update for 802.3x */
#define YU_GPCR_SPEED_EN 0x0001 /* Enable Auto-Update for speed */
/* Transmit Control Register (TCR) */
#define YUKON_TCR 0x0008
#define YU_TCR_FJ 0x8000 /* force jam / flow control */
#define YU_TCR_CRCD 0x4000 /* insert CRC (0 - enable) */
#define YU_TCR_PADD 0x2000 /* pad packets to 64b (0 - enable) */
#define YU_TCR_COLTH 0x1c00 /* collision threshold */
/* Receive Control Register (RCR) */
#define YUKON_RCR 0x000c
#define YU_RCR_UFLEN 0x8000 /* unicast filter enable */
#define YU_RCR_MUFLEN 0x4000 /* multicast filter enable */
#define YU_RCR_CRCR 0x2000 /* remove CRC */
#define YU_RCR_PASSFC 0x1000 /* pass flow control packets */
/* Transmit Flow Control Register (TFCR) */
#define YUKON_TFCR 0x0010 /* Pause Time */
/* Transmit Parameter Register (TPR) */
#define YUKON_TPR 0x0014
#define YU_TPR_JAM_LEN(x) (((x) & 0x3) << 14)
#define YU_TPR_JAM_IPG(x) (((x) & 0x1f) << 9)
#define YU_TPR_JAM2DATA_IPG(x) (((x) & 0x1f) << 4)
/* Serial Mode Register (SMR) */
#define YUKON_SMR 0x0018
#define YU_SMR_DATA_BLIND(x) (((x) & 0x1f) << 11)
#define YU_SMR_LIMIT4 0x0400 /* reset after 16 / 4 collisions */
#define YU_SMR_MFL_JUMBO 0x0100 /* max frame length for jumbo frames */
#define YU_SMR_MFL_VLAN 0x0200 /* max frame length + vlan tag */
#define YU_SMR_IPG_DATA(x) ((x) & 0x1f)
/* Source Address Low #1 (SAL1) */
#define YUKON_SAL1 0x001c /* SA1[15:0] */
/* Source Address Middle #1 (SAM1) */
#define YUKON_SAM1 0x0020 /* SA1[31:16] */
/* Source Address High #1 (SAH1) */
#define YUKON_SAH1 0x0024 /* SA1[47:32] */
/* Source Address Low #2 (SAL2) */
#define YUKON_SAL2 0x0028 /* SA2[15:0] */
/* Source Address Middle #2 (SAM2) */
#define YUKON_SAM2 0x002c /* SA2[31:16] */
/* Source Address High #2 (SAH2) */
#define YUKON_SAH2 0x0030 /* SA2[47:32] */
/* Multicatst Address Hash Register 1 (MCAH1) */
#define YUKON_MCAH1 0x0034
/* Multicatst Address Hash Register 2 (MCAH2) */
#define YUKON_MCAH2 0x0038
/* Multicatst Address Hash Register 3 (MCAH3) */
#define YUKON_MCAH3 0x003c
/* Multicatst Address Hash Register 4 (MCAH4) */
#define YUKON_MCAH4 0x0040
/* Transmit Interrupt Register (TIR) */
#define YUKON_TIR 0x0044
#define YU_TIR_OUT_UNICAST 0x0001 /* Num Unicast Packets Transmitted */
#define YU_TIR_OUT_BROADCAST 0x0002 /* Num Broadcast Packets Transmitted */
#define YU_TIR_OUT_PAUSE 0x0004 /* Num Pause Packets Transmitted */
#define YU_TIR_OUT_MULTICAST 0x0008 /* Num Multicast Packets Transmitted */
#define YU_TIR_OUT_OCTETS 0x0030 /* Num Bytes Transmitted */
#define YU_TIR_OUT_64_OCTETS 0x0000 /* Num Packets Transmitted */
#define YU_TIR_OUT_127_OCTETS 0x0000 /* Num Packets Transmitted */
#define YU_TIR_OUT_255_OCTETS 0x0000 /* Num Packets Transmitted */
#define YU_TIR_OUT_511_OCTETS 0x0000 /* Num Packets Transmitted */
#define YU_TIR_OUT_1023_OCTETS 0x0000 /* Num Packets Transmitted */
#define YU_TIR_OUT_1518_OCTETS 0x0000 /* Num Packets Transmitted */
#define YU_TIR_OUT_MAX_OCTETS 0x0000 /* Num Packets Transmitted */
#define YU_TIR_OUT_SPARE 0x0000 /* Num Packets Transmitted */
#define YU_TIR_OUT_COLLISIONS 0x0000 /* Num Packets Transmitted */
#define YU_TIR_OUT_LATE 0x0000 /* Num Packets Transmitted */
/* Receive Interrupt Register (RIR) */
#define YUKON_RIR 0x0048
/* Transmit and Receive Interrupt Register (TRIR) */
#define YUKON_TRIR 0x004c
/* Transmit Interrupt Mask Register (TIMR) */
#define YUKON_TIMR 0x0050
/* Receive Interrupt Mask Register (RIMR) */
#define YUKON_RIMR 0x0054
/* Transmit and Receive Interrupt Mask Register (TRIMR) */
#define YUKON_TRIMR 0x0058
/* SMI Control Register (SMICR) */
#define YUKON_SMICR 0x0080
#define YU_SMICR_PHYAD(x) (((x) & 0x1f) << 11)
#define YU_SMICR_REGAD(x) (((x) & 0x1f) << 6)
#define YU_SMICR_OPCODE 0x0020 /* opcode (0 - write, 1 - read) */
#define YU_SMICR_OP_READ 0x0020 /* opcode read */
#define YU_SMICR_OP_WRITE 0x0000 /* opcode write */
#define YU_SMICR_READ_VALID 0x0010 /* read valid */
#define YU_SMICR_BUSY 0x0008 /* busy (writing) */
/* SMI Data Register (SMIDR) */
#define YUKON_SMIDR 0x0084
/* PHY Addres Register (PAR) */
#define YUKON_PAR 0x0088
#define YU_PAR_MIB_CLR 0x0020 /* MIB Counters Clear Mode */
#define YU_PAR_LOAD_TSTCNT 0x0010 /* Load count 0xfffffff0 into cntr */
|
