1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
|
.\" $OpenBSD: arp.4,v 1.21 2015/11/01 21:26:48 jmc Exp $
.\" $NetBSD: arp.4,v 1.2 1995/03/01 11:50:56 chopps Exp $
.\"
.\" Copyright (c) 1985, 1986, 1988, 1994
.\" The Regents of the University of California. All rights reserved.
.\"
.\" Redistribution and use in source and binary forms, with or without
.\" modification, are permitted provided that the following conditions
.\" are met:
.\" 1. Redistributions of source code must retain the above copyright
.\" notice, this list of conditions and the following disclaimer.
.\" 2. Redistributions in binary form must reproduce the above copyright
.\" notice, this list of conditions and the following disclaimer in the
.\" documentation and/or other materials provided with the distribution.
.\" 3. Neither the name of the University nor the names of its contributors
.\" may be used to endorse or promote products derived from this software
.\" without specific prior written permission.
.\"
.\" THIS SOFTWARE IS PROVIDED BY THE REGENTS AND CONTRIBUTORS ``AS IS'' AND
.\" ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
.\" IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE
.\" ARE DISCLAIMED. IN NO EVENT SHALL THE REGENTS OR CONTRIBUTORS BE LIABLE
.\" FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL
.\" DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS
.\" OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
.\" HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
.\" LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY
.\" OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF
.\" SUCH DAMAGE.
.\"
.\" from: @(#)arp4.4 6.5 (Berkeley) 4/18/94
.\"
.Dd $Mdocdate: November 1 2015 $
.Dt ARP 4
.Os
.Sh NAME
.Nm arp
.Nd Address Resolution Protocol
.Sh SYNOPSIS
.Cd "pseudo-device ether"
.Sh DESCRIPTION
The Address Resolution Protocol (ARP) is used to dynamically
map between Internet host addresses and Ethernet addresses.
It is used by all of the Ethernet interface drivers.
It is not specific to Internet protocols or to Ethernet,
but this implementation currently supports only that combination.
.Pp
ARP caches Internet-Ethernet address mappings.
When an interface requests a mapping for an address not in the cache,
ARP queues the message which requires the mapping and broadcasts
a message on the associated network requesting the address mapping.
If a response is provided, the new mapping is cached and any pending
message is transmitted.
ARP will queue at most one packet while waiting for a response to a
mapping request;
only the most recently transmitted packet is kept.
If the target host does not respond after several requests,
the host is considered to be down for a short period (normally 20 seconds),
allowing an error to be returned to transmission attempts during this
interval.
The error is
.Li EHOSTDOWN
for a non-responding destination host, and
.Li EHOSTUNREACH
for a non-responding router.
.Pp
The ARP cache is stored in the system routing table as
dynamically created host routes.
The route to a directly attached Ethernet network is installed as a
.Dq cloning
route (one with the
.Li RTF_CLONING
flag set),
causing routes to individual hosts on that network to be created on
demand.
These routes time out periodically (normally 20 minutes after validated;
entries are not validated when not in use).
An entry for a host which is not responding is a
.Dq reject
route (one with the
.Li RTF_REJECT
flag set).
.Pp
ARP entries may be added, deleted or changed with the
.Xr arp 8
utility.
Manually added entries may be temporary, static or permanent,
and may be
.Dq published ,
in which case the system will respond to ARP requests for that host
as if it were the target of the request.
A static entry will not
time out, but may be overwritten by network traffic, while a permanent
entry will not time out and cannot be overwritten.
.Pp
In the past,
ARP was used to negotiate the use of a trailer encapsulation.
This is no longer supported.
.Pp
ARP watches passively for hosts impersonating the local host (i.e., a host
which responds to an ARP mapping request for the local host's address).
.Sh DIAGNOSTICS
.Bl -diag
.It "duplicate IP address %x!! sent from ethernet address: %x:%x:%x:%x:%x:%x"
ARP has discovered another host on the local network which responds to
mapping requests for its own Internet address with a different Ethernet
address, generally indicating that two hosts are attempting to use the
same Internet address.
.It "arp info overwritten for %x!! by %x:%x:%x:%x:%x:%x on %x"
An existing route has been overwritten with a new Ethernet address, for
example when the other host has changed Ethernet cards.
If the route
previously was static/non-expiring, the new route will expire normally.
.It "arp: attempt to overwrite permanent entry for %x!! by %x:%x:%x:%x:%x:%x on %x"
As above, but the existing route had been manually set up as permanent.
The routing information is not modified.
.It "arp: attempt to overwrite entry for %x!! on %x by %x:%x:%x:%x:%x:%x on %x"
ARP has noticed an attempt to overwrite a host's routing entry on one
interface with a routing entry for a different interface.
The routing information is not modified.
.It "arp: received reply to broadcast or multicast address"
ARP received a response which is a broadcast or multicast address.
This might indicate an ARP spoofing attempt.
.It "arp: ether address is broadcast for IP address %s!"
ARP requested information for a host, and received an answer indicating that
the host's Ethernet address is the Ethernet broadcast address.
This indicates a misconfigured or broken device.
.It "arp: ether address is multicast for IP address %s!"
ARP requested information for a host, and received an answer indicating that
the host's Ethernet address is the Ethernet multicast address.
This indicates a misconfigured or broken device.
.It "arp: attempt to add entry for %s on %s by %s on %s"
This usually indicates there is more than one interface
connected to the same hub,
or that the networks have somehow been short-circuited
(e.g. IPs that should have been present on interface one
are present on interface two).
.It "arplookup: unable to enter address for %s"
An IP received on the interface does not match the network/netmask
of the interface.
This indicates a netmask problem.
.El
.Sh SEE ALSO
.Xr inet 4 ,
.Xr route 4 ,
.Xr arp 8 ,
.Xr ifconfig 8 ,
.Xr route 8
.Sh STANDARDS
.Rs
.%A David C. Plummer
.%D November 1982
.%R RFC 826
.%T "An Ethernet Address Resolution Protocol"
.Re
.Pp
.Rs
.%A Samuel J. Leffler
.%A Michael J. Karels
.%D April 1984
.%R RFC 893
.%T Trailer Encapsulations
.Re
|
