first cut

1 files changed, 7 insertions, 11 deletions

diff --git a/distrib/notes/i386/xfer b/distrib/notes/i386/xfer
index 5507715cf88..a68f7ac023c 100644
--- a/distrib/notes/i386/xfer
+++ b/distrib/notes/i386/xfer
@@ -4,6 +4,7 @@ Installation is supported from several media types, including:
 	Tape
 	Remote NFS partition
 	FTP
+	rsh & restore
 
 No matter which installation medium you choose, you'll need to have
 two floppy disks (either 1.2M or 1.44 will work, though both should be
@@ -12,11 +13,6 @@ appropriate for your system.  On the second, you'll put the install or
 upgrade floppy image, depending on whether you're installing OpenBSD
 for the first time, or upgrading a previous installation.
 
-If you are using an Adaptec SCSI host adapter, you need the kcadp11.fs
-kernel-copy image.  If you're using any other SCSI host adapter,
-you'll need the kcoth11.fs image.  If you're using a non-SCSI disk
-controller, either kernel-copy disk image will work for you.
-
 If you are using a UN*X-like system to write the floppy images to
 disks, you should use the "dd" command to copy the file system images
 (.fs files) directly to the raw floppy disks.  It is suggested that
@@ -90,14 +86,14 @@ following:
 	(If you can't figure it out, ask your system administrator.)
 	In the above example, "<dist_directories>" are the
 	distribution sets' directories, for the distribution sets you
-	wish to place on the tape.  For instance, to put the "base11"
-	and "etc11" distributions on tape (in order to do the absolute
+	wish to place on the tape.  For instance, to put the "base20"
+	and "etc20" distributions on tape (in order to do the absolute
 	minimum installation to a new disk), you would do the
 	following:
 
-		cd .../OpenBSD-1.1		# the top of the tree
-		cd i386/binary
-		tar cf <tape_device> base11 etc11
+		cd .../1.2		# the top of the tree
+		cd i386/
+		tar cf <tape_device> base20 etc20
 
 	(Note that you still need to fill in "<tape_device>" in the
 	example.)
@@ -173,7 +169,7 @@ following:
 	Place the distribution sets you wish to upgrade somewhere in
 	your current file system tree.  At a bare minimum, you must
 	upgrade the "base" binary distribution, and so must put the
-	"base11" set somewhere in your file system.  If you wish,
+	"base20" set somewhere in your file system.  If you wish,
 	you can do the other sets, as well, but you should NOT upgrade
 	the "etc" distribution; the "etc" distribution contains system
 	configuration files that you should review and update by hand.